Question about 2006 Cadillac STS
How long does it take to replace a battery on a 06 Cadillac sts
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you need to have a pulley puller to get the pulley off if you don't have one most auto zone part stores have a loan a tool program and they can help you with that on most powersteering pumps the high pressure line will be a fitting or bolt on and the return line is usually just a squeeze clamp hope this helps good luck
Posted on Jan 30, 2009
This can be a very difficult repair. If you pay someone to do it, the labor costs are very high due to the amount of labor necessary to even access the heater core. I cannot tell you step by step how to do this. I can however tell you that you will have to remove enough of the dash to allow access to the core. Go slow, be careful and do not break any of the parts. Use common sense to figure out how the parts come apart. Look for screws and clips. Some plastic parts just snap together. Take digital photos as you go along to help you in reassembly. It is just a matter of getting to the core and removing it. Of course you will need to drain and flush the cooling system, replace the thermostat, and add a fresh 50/50 mix of DexCool & Distilled water after installing the new core. Be sure and set the heat to high when pouring in the fresh coolant. Bleed all air from the system.
Posted on Sep 09, 2009
Two hour job in your driveway. Lift the side needing replaced, remove plastic clips and the wheel liner. Unbolt the bumper face starting from the wheelwell and working in. When replacing the passanger side, remove the bolts holding the fuse box in place and move to allow more room. the replace is made through the wheelwell reaching in.
Posted on Dec 03, 2009
the oil filter is not a regular looking filter, its a cartriage type that goes into a housing, if you open the hood and look on the driverside of motor near the oil fill cap you will see a cover cap with a nut shape head on top, use a 24mm socket on a rachet and unscrew the cover,then pullfilter out, install new filter and replace oring provide with filter on the cap. hope this helps.
Posted on May 12, 2010
Testimonial: "This was great. I found it immediatly."
To remove the headlight assembly you need to remove the front bumper cover. There are two bolts and one stud with a nut that hold the headlight in. Two of the fasteners are behind the bumper cover.If you remove these the headlight must come out.
Posted on Jul 08, 2010
Tips for a great answer:
Sep 21, 2016 | 2006 Cadillac STS
May 22, 2016 | 2006 Cadillac STS
Oct 14, 2014 | Cadillac STS Cars & Trucks
Aug 11, 2014 | 2006 Cadillac STS
Dec 19, 2013 | 2006 Cadillac STS
Dec 14, 2012 | 2006 Cadillac STS
Dec 25, 2010 | 2006 Cadillac STS
Sep 19, 2010 | 2006 Cadillac STS
Dec 13, 2009 | 2006 Cadillac STS
12 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: