Question about Hyundai Atos

Open Question

Ignition and key

When switching the car on, on the dash there is a yellow key that indicates it reads the key so it can start, but sometimes it doesnt read the key, how can i fix this

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Mazda 323 2002 Sting Immobilizer

Fcuk I got same problem with my Mazda 3 year 2004. Noone can help me at all !!! Even in Mazda they have no idea where is problem. For me it is at the moment only in cold weather. I cannot get throught immobilizer. After few turns it works, but not always (only when its bit warmer). I found out that if it is warmer, and I turn on ventilation for a while after it will let me go! Immobilizer starts flashing ... after few more minutes and turning key few times it will let me go !!! Please write me to tomaupair@hotmail.com if you will know updates... I am desperate , cannot use my car in winter at all or cold weather. In summer works fine

Posted on Nov 10, 2008

  • 1 Answer

SOURCE: ignition locked; dash light of car outline with key inside flashs

Get the steering wheel to move even just a little bit and it will unlock.

Posted on Jan 12, 2009

sparxxinct
  • 73 Answers

SOURCE: Dash reads start disabled;due to theft sysytems;wait three minut

did you replace the fuse.if so try to get the alarm reset location,it could be in the stupidist place like my pathfinder you have to put the key in the tailgate and turn it to glass side and hold it for 20 seconds.and then hit the hidden reset switch under the rear carpet.

Posted on Feb 26, 2009

rockmeister
  • 2047 Answers

SOURCE: peugeot 307 sw ignition switch fuse keeps

there are three likely problems.... check the battery of the vehicle if the battery is still ok, or the alternator is not supplying the right power and finally the fuse box has some burnt part in it internally...

Posted on Jan 31, 2010

  • 4 Answers

SOURCE: Wont start, gives error code IN 02 on dash

I had the same problem with my 94 jetta, I would also have the alarm turn on as I connected the battery, if you lower the fuse box being careful not to disconnect anything, there is a box to the upper driver-side aria(that is if you are laying on your back looking up under the dash) this is the alarm control unit, there should be a white label on the wires indicating so (think it says alarm in German) theres a 6 pin(wire) connector and a 10 pin. unplug both connectors and look at the 6 pin connector. There is numbers where the wires are located on the connector, if you take a piece of wire and "bridge" wires 5 and 6 (The largest wires on the connector, red/red w/black stripe) your starter should work, any problem with the alarm system can cause the starter to be disabled. after bridging the wires or simply connecting them do not plug anything back into the alarm box, after this you standard vehicle alarm will be disabled permanently, but you will be able to start your car. If this dose not fix the problem you may have a defective starter, hope this helps.

Posted on Aug 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Buick Lesabre wont start


Did you check the ignition switch? It can be bad!

Mar 01, 2012 | Buick LeSabre Cars & Trucks

1 Answer

Passlock lite on car starts and stops in seconds. tried relearn but doesnt seem to work car is 99 sunfire


most of the time it is either the chip in the key went bad or sometimes it is the ignition switch itself is not reading the key properly.

Jan 02, 2012 | 1999 Pontiac Sunfire

2 Answers

I have a 2005 suzuki swift, a yellow lock light has just appeared on the dash and now my car wont start . do you have any idea what the problem could be ??


SOUND LIKE VECHICLE IN THEFT SECURITY MODE CAUSED BY WORN KEY OR IMMOBILIZER READ COIL.PROBLEM IN THE BCM AND ECM.TRY INSTALLING KEY IGNITION SWITCH.TURN SWITCH TO THE ON POSITION FOR 10 MINUTES UNTIL THE YELLOW LOCK LIGHT TURN OFF OR DISAPPEAR.THEN TURN OFF IGNITION SWITCH FOR 5 SECONDS, THEN TRY START VECHICLE.IF VECHICLE STILL DONT CRANK.HAVE VECHICLE CODE SCAN FOR THEFT SECURITY FAULT CODES.

Jun 19, 2011 | 2005 Suzuki Swift

1 Answer

Yellow engine light


Yellow engine light on the dash board of Toyota Camry is the indication of low oil in car.----------- Get the oil checked and refilled.Driving the car with low oil is not advisable.------------- There is a reset procedure to stop this yellow light on dash.In some cases this helps ,but in some cases the oil needs to be refilled to stop this yellow light.------------- I will mention the reset procedure as follows:-- Turn on the ignition switch, set the mileometer reading to miles not trip meter, turn off the ignition fully, press the button to reset the trip meter and keep it pressed down as you turn on the ignition key to key on engine off, keep it pressed down for about 15 seconds and then the light will be reset. -------------- Thanks. keep updated for any more query.you can rate this solution and show your appreciation.

Jun 09, 2010 | 2000 Toyota Camry

2 Answers

I have a 1993 buick lesabre. The security light is flashing and will not start. I checked the fuse it was ok. I tried our other key and still wouldn't start.


there may be a broken wire from the ignition swith going down the steering column,theres two sensors at the begining opening of switch, sometimes they get stuck and dont pop back out, in turn it doesnt touch the chip on the key and cant read it,take a look with a light use a small pic and push lightly on them and see if the y push in and pop out, if they do then replace ignition swith,theres a way to bypass,use an omh meter and measure resistance of key chip, then buy a resistor with the same value,and connenet to wires from switch under the dash,cut wires and put conecting the two going to switch with resistor connecting them together,heres a diagram,193b32f.jpg

May 06, 2010 | 1993 Buick LeSabre

1 Answer

When i turn the key to start the truck upit turns to run but wont go to start, it turns all the way but doesnt start


Not much to go on---but I'll try here.

Ok first thing check to see if truck is in park---sometimes it may be in park but the park switch will not start truck unless the switch is depressed.

try putting truck in neutral with foot on pedal to start truck-----if starts the problem is with the switch.

If not, then you have a ignition switch problem---there is an ignition switch box under the dash on topside of steering column with has adjustment screws mounted to column.

loosen screws and slide ignition box toward the steering wheel to achieve the start position of the ignition switch box to start truck.

Jan 23, 2010 | 1988 Ford F 250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...