How to remove the bed
SOURCE: troubleshooting air conditioner thermostat 1995 nissan pickup hardbody
The thermostat is located where the lower radiator hose goes into the engine. I've had to replace mine, and it took a while to find it. I found the easiest way to get at it is to remove the power steering pump (hoses attached) and set it over to the side to get at the bolts on the thermostat housing.
Good luck!
SOURCE: How do you remove the door panel of a 1995 Nissan XE Pickup
Not sure about the 95, but to remove it on my 94 i just pulled on once corner till the fastener poped out, then worked slowly around removing each fastener. Be careful as the the door pannel is quite flimsy but if the 95 is the same as the 94 it should be fairly easy to remove.
SOURCE: 1995 nissan pickup 4 cylinder timing chain - 256k miles
did u recently buy it used-mite of been already done--how r the other components enginewise-its an old car n theyll be more things--but if u luv it then get a haynes repair manual at the zone
SOURCE: how do you bleed cooling system for 1995 nissan pickup truck
SOURCE: 1995 nissan pickup throttle position sensor
ok on a 2.4l on the black/green and white wires use ohm meter and there is no specific spec for that engine just make sure the the resistance changes and there is no dead spots. for the 3.0l black and white wires specs are 1.0-9.0k ohms im guessing the specs are the same either engine. close to full open
92 views
Usually answered in minutes!
×