Question about 2006 Cadillac BLS 1.9

1 Answer

Lock unlock beep sound

I have an automatic door lock systm but but when i lock or un lock i have no beep sound. i would like to know how to get the beep sound while locking or unlocking.

Posted by on

  • NonieMouse
    NonieMouse Apr 19, 2014

    A THOUSAND PARDONS, I AM TRYING TO POST FOR A DEAD BATTERY ON A 2001 DEVILLE, BUT THIS SITE IS GLITCHED OUT, SO PLEASE DISREGARD & MARK NOT HELPFUL. . . . . . . . .Hi naveen , I want to help you with your problem, but I need more information from you. Can you please add details in the comment box?


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

After dead battery, readouts
including gas used do not read normally. These "learned" results have to be relearned by the computer-----this will
take driving 100 miles or so. You would only do that if it starts and runs with normal sounding engine performance= if it does not start/run sounding normal, diagnose and fix your other problems, not just the computer memory.

The scanning for codes will not help until the computer "remembers" something----which does not happen with a completely dead battery---memory is erased. I am writing this for Ali Fardshisheh on Apr 20,2014. (There are many other "learned" data elements in the car computer that will not be accurate until
you drive about one hundred miles, so the computer can relearn them thru a NUMBER of normal operating cycles.....IF IT DOES NOT START AND SOUND NORMAL, you cannot apply this solution.)
BEEN THERE, DONE THAT! Just as an example, when I
went thru the 'really dead battery' cycle, the gas used was not
displayed when I got back to running. After I drove thru many
apparently normal miles, the mpg crept up very SLOWLY, from
1, 2, 5mpg, until it eventually plateau-ed at its usual between 15 and 20mpg. I assume there are many other 'learned' readouts that would behave in the same way------this was the only readout I was following as I was not interested in the others, but I presume numerous others are operating in a default mode thru many driving cycles until a memory data-base builds up.
Now I have to go see my DeVille mechanic. I will try to check later and see if you have a response. I have a good mechanic, if you need one. Best wishes....

Posted on Apr 19, 2014

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: security will not reset

security system has the starter locked out the remote was lost some time ago locking and unlocking the door doesent work any more what are my options

Posted on Oct 04, 2008

michigan man
  • 3533 Answers

SOURCE: liftgate will not unlock

if it was mine I would take the rear inside door panel off and see if there is any rust or bind in the power door lock motor itself and also make sure that no one has broken a key off or stuck anything in the lock cause I had an expedition with this same problem and it was a broken key in the lock

Posted on Jan 06, 2009

  • 373 Answers

SOURCE: Drivers Side Door Wont Unlock With Key

the locking solenoid could be sticking up or down due to the cold or could be going bad. if possible take off the door panel a watch the solenoid as you have someone operate the key and with the remote.

Posted on Feb 20, 2009

  • 64 Answers

SOURCE: How do I program my

that is a dealer item there-that is serious,call them for advise 1st-they should help you w/ no charge
thats an sts we're talkin about

Posted on Nov 05, 2010

  • 8177 Answers

SOURCE: remote control won't lock/unlock doors, but will open the trunk. What;s wrong?

There is a fuse box under the right rear seat cushion behind the driver. In that box is a 10 amp mini fuse marked "TRUNK DR RELEASE". That is the fuse that powers your remote receiver. If that fuse is good, the receiver may have failed. To remove the seat cushion, pull the front of the cushion up and then forward.

Posted on Nov 05, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

05 honda odyssey passenger sliding door will not open manually or automatic. will beep if i try to open and make clicking sound. removed door panel and all parts are moving.

Give the door a good hard hit with a rubber hammer just as you move the lock button to unlock,that should do it.DO NOT lock this door again until the lock mech is lubed.You may have to try this a few times but it should open once it is actually unlocked.

Jul 26, 2017 | Honda Cars & Trucks

1 Answer

Car Alarm beep Problem

Sometimes tow beeps when locking means that one of the door is not properly closed or is ajar. If that is not the case, get it reprogrammed.

May 30, 2012 | Proton Cars & Trucks

1 Answer

Alarm beep lagging

get it reprogrammed by service center.

May 30, 2012 | Proton Cars & Trucks

2 Answers

2002 VW Cabrio alarm problem: alarm will not un-set. Door will not lock using the key OR the remote. Hitting "alarm off" button on remote, it unsets, then arms again immediately. With engine...

i have a 2002 vw cabrio and won't start after i took out the battery everbody is telling me that anti-theft is lock mode how do i rest it so i can start my car

Nov 08, 2010 | 2000 Volkswagen Cabrio

2 Answers

2002 pontiac grand prix - power door locks

I do believe the 3 beeps are telling you that you are about to lock your doors. Additonally that should signal you that have your keys in hand before you locks your keys inside the car. It's just an aural warning reminder that your doors are about to be locked.

May 06, 2010 | 2002 Pontiac Grand Prix

1 Answer

2000 E350 door locks wont lock, but will unlock. Recent rain must have caused short because fuse was blown. After changing fuse locks unlock, but will not lock. I understand they are separate relays? where...

i dont know about a e350,but on a f150 there is a locking relay behind the dash on the passengers side,just listen for clinking sound when you un-lock it.

Jan 24, 2010 | 2000 Ford Econoline

1 Answer

Un work of the doors auto control lexus

1. sitting in driver seat, with driver's door OPEN, press lock/unlock button ON THE DRIVERS DOOR to lock all doors, then manually unlock driver door only.
2. Insert YOUR key in ignition, DO NOT TURN, then remove key.
3. Using the same lock/unlock button ON THE DRIVERS DOOR, slowly press lock-unlock in 5 cycles
4. Shut door.
5. Open door.
6. Using the same lock/unlock button ON THE DRIVERS DOOR, again slowly press lock-unlock in 5 cycles
7. With the door open insert your key into the ignition, turn to 'on' position (DON'T START), wait 5 seconds. Turn off and remove key.
8. Locks should cycle once (Car will lock and then unlock once by herself). If they don't cycle or they cycle more than once, do steps 1-7 over.
9. Now using the remote, push lock button, hold for one second, then release the button. The locks should cycle once. If not, start over and go slower.
10. Close the door.
11. Open the door.
12. Press the lock button on the remote. The locks should do a lock-unlock cycle.
13. Close the door
14. Press the lock button on the remote, the doors should lock.
15. Press unlock button and the doors should unlock.

Long beep to follow if successful.

Jun 16, 2009 | 1996 Lexus LS 400

Not finding what you are looking for?
2006 Cadillac BLS 1.9 Logo

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides