Question about 1995 Mazda 626

1 Answer

Cant find the idle aduster on my 2008 yamaha ttrL

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

IT'S NON ADJUSTABLE R FUEL INJECTION>

Posted on Apr 19, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to adust idle on 1999 tarus dohc


There's no way to adjust idle from set factory specs.sounds like you might have a vacuum leak or sensor concern. Is service engine light on? I would check the main vacuum connection at the rear of the motor on the drivers side near Lynn he firewall, all around the airbox and air tube going into throttle body. They're known for bad vacuum leaks at various places around there.you might be able to hear it if you have someone start and slightly hold throttle open and listen for a whistle or sucking noise. .

Jun 28, 2014 | 1999 Ford Taurus

1 Answer

2008 sebring convertible when top is up trunk will not close


Mine took several hard slams to latch, with top up or down. Finally got dealer to adjust the latch which they originally said wasn't possible. Wore grooves into the latch rod while it was out of adustment, but at least now it closes.

May 03, 2011 | 2008 Chrysler Sebring Convertible

1 Answer

1995 Explorer idles at about 12-15 RPM. Should or always has idled at 10. Is there any adjustment?


normally idle adustment are controlled by the computer, i would look at the throttle linkages to make sure they are not in a bind or excessively dirty, you can clean them with throttle body cleaner. also throttle body might need cleaning, a lot of service centers do this with their profesional equipment.

Feb 14, 2011 | 1995 Ford Explorer

1 Answer

A 1985 Sentra - The engine idles until warm then it dies.


has it got a idle control valve, have tried adusting throttle cable slightly

Oct 05, 2009 | 1985 Nissan Sentra 2 Door

1 Answer

I have a 2008 Yamaha vx110 deluxe waverunner that idles high.


I dont know the answer but my vx deluxe is doing the same thing. Not as bad as yours but 4k rpm idle.....ANyone?

Jul 13, 2009 | 1997 Acura CL

1 Answer

My car is jerking and will stall when the air is on


Look at your RPM gauge, before and after, putting on the A/C. Does the RPM drop with the A/C on? May need to adust the idling or check the throttle sensor

May 04, 2009 | 2001 Mitsubishi Eclipse

1 Answer

Carburator tune up of charadade 1992 sedan. The engine is running too fast while idle at 1200 r.p.m.


Before you start check the status of your choke. One that is stuck on will cause a high idle. If the choke checks out, proceed to the following:


You should have what's called a 2 needle carburetor. A larger screw adjustment for idle, and a smaller for high speed.

Start by adjusting your low speed (idle) needle until you reach the desired idle. I prefer about 850rpms. Do this with the engine running and adequately warmed so that your adjustments are not thrown off by the automatic choke.

Next slowly open up the high speed needle. As you open it your idle speed will gradually increase. Adust it in 1/8 turn increments, pausing after each adjustment to allow the changes to take affect. Keep opening it until you stop increasing your rpms, then take it back 1/8 of a turn.

Next readjust your idle mixture screw so that your idle is back down to 850rpms.

Apr 29, 2009 | 1992 Daihatsu Charade

2 Answers

1999 ASTRO VAN IDLES TOO HIGHWITH AC ON, AND WILL CRUISE ALONG WI


this is not somthing you adust there is what you call an idle air control module by the throttle body that might want to check out it may be sticking due to carbon build up or just plainly broken if the check engine light is on then the module might be broken

Mar 26, 2009 | 1999 Chevrolet Astro

1 Answer

Carburettor adustment on 1995 mitsubishi starwagon


If you have a carburator still then you need to know more.
screwdriver method on feel/rpm gauge
Proper exhaust measurement.
Run her up to 650 rpm idle start adjusting mixture screw until max rpm obtained. back out a bit too be lean. Ajust Idle screw again for 650.
Turn on appliances as lighting and airco. If engine starts/tends to stall, vibrate increase the idle a bit more.

You are not ready with the engine if not doing ignition settings and valve clearances as well, etc.

Mar 17, 2009 | 1995 Mitsubishi Mighty Max

Not finding what you are looking for?
1995 Mazda 626 Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8755 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...