Question about Cars & Trucks

Open Question

How to put fuel line retainer clips on fuel lines on a 2001 buick regal

How do i put on fuel line retainer clips on feul lines to a 2001 buick regal

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Clutch slave hydraulic retainer clip not avail.

Call you local auto recycler and see if they have what your looking for. It may take a few tries at a few places, but you'll find it.

Posted on Feb 11, 2009

daves944
  • 1050 Answers

SOURCE: Buick Regal dying

You have a problem in the fuel pump relay circuit for sure then. I'm betting the relay, but it could be that dropping resistor.

Posted on May 11, 2009

  • 30 Answers

SOURCE: NEED TO FIX FRONT BRAKE LINE METAL

In a pinch, I agree, use a compression fitting. But that is even harder than doing it the right way. After cutting the line, you have to have it perfectly round. By working with the already rusty metal, you are now fatiguing the metal. Then add on the compression, and added weight, and you get yourself a weak point.

The easiest way is to by the right length line or lines (It is far better to have more than less), the couplers (if needed), and any special adapters you may need (ie 3/16 standard flare to 1/4 bubble flare.) Take with you the ends and a section of line. The line is not that expensive ($7 for the longest.)

Start running the line, one section at a time, making sure to keep the ends on the end. When you need to make a bend, DO NOT make a tight bend that crimps the line. Discard the line if this happens. If you have a tool, use it. Other wise use you hand to make, gentle bends. Connect one end and connect the couplers, if used. When you get to the other side, wind the excess around a spiral. Secure with wire or existing retainers.

This is way safer than a compression fitting, and not all that hard. Remember to bleed the brakes

Posted on May 28, 2009

  • 190 Answers

SOURCE: clip on fuel line broke replacing fuel filter

Should be able to get one in the help section of any autopart

Posted on Aug 15, 2009

jturcotte
  • 7716 Answers

SOURCE: 2001 Buick Regal GS How to turn off " Low

check sensor on reservoir. Unplug connector to sensor to see if light goes out. If yes, replace sensor. If no, wire may be shorted.

Posted on Oct 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 century custom 3.3 v6. Do I need a specialty tool to remove fuel filter? Looks like snap connects on both sides, I thought one side would be a threaded hard line. It won't even downshift to pass


Yes you need a special tool. Any auto parts store will have the internal fuel line retainer clip release tool. If you look at the photo of the filter below the off white plastic clips are the retainers I refer to.
26287419-dvg5ggpsyradvzbbyp0b0ito-5-0.jpg

Sep 20, 2016 | Buick Century Cars & Trucks

1 Answer

Where is the fuel felter located on a 2001 buick regal


underneath on drivers side right in the fuel line

Jan 08, 2013 | 2001 Buick Regal

1 Answer

Where is the fuel pressure regeulator located on 2001 buick regal?


Under the hood on the fuel injector fuel supply rail, it has a vacuum line attached to it. See photo below.9_20_2012_8_14_00_pm.jpg

Sep 20, 2012 | 2001 Buick Regal

1 Answer

How do you replace fuel line on 1996 buick regal 3.8


I am assuming you are referring to the fuel line that runs from the fuel filter back and goes over the fuel tank. If that is the case. 1. remove fuel pump relay, then crank car and allow car to run until it dies (this will purge the fuel from the fuel line, not necessarily required but a good idea). 2. use 2 wrenches to remove line from fuel filter. 3. trace line back over fuel tank until you get to the clip that attaches fuel line to fuel pump. clip is simple to remove just like the one on the outlet side of fuel filter. if looking for the replacement part. hit the junk yards I paid $15 at a you pull a part place verses 85+ through a dealer (this part is not carried by the auto parts places here in GA)

Sep 07, 2012 | 1996 Buick Regal Olympic Gold

2 Answers

Where is the fuel filter on a 1992 buick regal


Driver side in front of the rear wheel. Follow the fuel line under the doors. I think it has a nut on one side and a clip on the other.

Jun 25, 2012 | 1992 Buick Regal

1 Answer

How to change fuel filter on 1997 Ford 150


Things You'll Need

  • Drop pan
  • Socket set
  • Fuel line disconnect tool
  • New filter

  • 1Slide the drip pan under the driver side of the truck, below the driver door. Climb under with the socket set, fuel line disconnect tool and new filter.
  • 2Unbolt the fuel filter retaining strap with the socket set. The filter is located along the inboard side of the frame, below the driver seat. When in doubt, simply follow the fuel lines forward from the fuel tank until you locate the filter.
  • 3Disconnect the front fuel line from the fuel filter with the fuel line disconnect tool. The line flares out where the filter outlet enters it and a retaining clip holds it in place. You can unseat this clip with a pocket screwdriver or a pick, but it's not advisable, as the clip tends to break if pried on unevenly. hence why u need the tool. about ten buck
  • 4Pull the fuel line off the front of the fuel filter and then pull the filter out of the rear line and retaining strap. Put the old filter in the drip pan.
  • 5Slide the new filter into the retaining strap and plug the inlet into the rear fuel line. Make sure the arrow indicating flow direction points toward the engine. Connect the front fuel line, push the retaining clip back into place and bolt the retaining strap back to the frame.
  • 6Climb out, get in the truck and turn the ignition key to the run position. Wait for the fuel pump to stop running (this should be about 10 seconds) and start the truck.

Nov 18, 2011 | 1997 Ford F150 Regular Cab

2 Answers

How do i change a fuel filter on a 2001 f150


The clamps are just a secondary lock, special tools are needed to unlock the fuel lines.

Nov 05, 2009 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Fuel filter loction on a 2000 buick regal GS


If you look under (this would be easier with a hoist) the middle of the car and look for the lines following from the gas tank to the engine (most likely a small silver line) and look for where it attaches to a bigger more cylinder like (silver color) looking bottle, that's the fuel filter. There will be two (plastic) clips on wither side of it so it might be a bit hard laying on the ground to take out, and also watch for any excess fuel in the lines (if it's majorly block) when removing it..

Oct 19, 2009 | 1992 Buick Regal

2 Answers

1995 buick lesabre shuts off while driving,engine runs smooth and then shuts off,,it restarts without a problem,,,,what could be causing this. i have checked my battery connections and they are fine.


Plugged fuel filter. There are two - one in the tank and one in the fuel line. Probably the one in the fuel line so change that one first.

Jul 15, 2009 | 1995 Buick Regal

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...