Question about 1988 Chevrolet K1500

1 Answer

Truck idels fine but put into gear stalls

My 1988 chevy 1500, starts and idles fine but when put into gear it stalls and i changed the fuel pump the relay, the regulator, fuel filter. whats wrong with it?

Posted by on

  • ShadetreeGuy May 11, 2010

    how is the battery? any dead cells?

  • dowdajeff
    dowdajeff Oct 24, 2013

    Brand new battery, and charging system puts out 13.9 volts at idel.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

You need to adjust the engion timing

Posted on Jun 19, 2009

  • dowdajeff
    dowdajeff Oct 24, 2013

    Timing is set to specs with advance disconnected.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a chevy s10 2.2 2003 truck and one day it ran about five miles. then stalled. it started back up idled fine but put it in gear. stalled again. had to get towed home replaced the fuel filter,truck...


When you press on the gas when the truck is running, does it rev up?

Did it die while driving down the road (foot on the accelerator) or when idle? - If so, try cranking it and get your RPMs up to 1500-2000 RPMs and put it in drive (with your other foot on the brake). See if it will continue running if you never take your foot off the gas.

Apr 06, 2013 | Cars & Trucks

1 Answer

Stops runing but starts right back up 88 ford f


have seen this before,these vehicles have a history with fuel pump relays failing,also idle air valves getting carboned up (dirty inside) and idle air is restricted and engine dies,and ck map sensor vacuum tubing for cracks.good luck

Jul 07, 2010 | 1988 Ford F 150

1 Answer

My 92 tempo runs and drives great,but when you put it in gear it seams like wants to stall.almost like the idel is to low. if you turn the idel up the car jumps when you put into gear. the idels to high....


GIVE IT A FILTER CHANGE-AIR, FUEL. MAYBE PLUGS AND WIRES DEPENDING WHEN WAS THE LAST TIME. FUEL INJECTOR CLEANER, DON'T MESS WITH THE IDLE SCREW-THAT'S WHAT THE COMPUTER IS FOR.

Oct 16, 2009 | 1992 Ford Tempo

1 Answer

My 1988 chevy 2500 has been so reliable until it stated to stall.


Could be. But more then likely it's the gas. The gas you get these days from the pumps will gunk up after around 30-40 days. I'ld change the fuel filter see if that works. If not you might have to take the tank out to clean off the pickup sock. It's a small filter type on the end of the fuel pump. Of course, you should do a pressure test to see first.

Oct 10, 2009 | 1988 Chevrolet Silverado 2500

2 Answers

Wont keep idle, car stalls out


I had this same problem on my 2005 monte carlo, took mechanic a while to figure out it was the idle air control valve. They also replace the idle air control motor.

Jun 01, 2009 | 2005 Chevrolet Monte Carlo

2 Answers

1995 suburban idles, but dies when put in drive.


check for vacuum leaks at throttle body gasket. pvc valve stuck open.if all is good .change fuel filter .if still stall out check fuel pump pressure.if all is good .replace plugs and wires if they have not been changed.

Apr 27, 2009 | 1996 GMC Suburban

4 Answers

My 1993 chevy 1500 Silverado truck suddenly quits


I put a new fuel pump, fuel filter, and a fuel pump relay and the fuel pump is still not coming on. I am not getting any fuel. Can you please tell me what it might be.

Mar 08, 2009 | 1993 Chevrolet C1500

2 Answers

Jeep wrangler stalls out


check maf and tps sensor

Feb 18, 2009 | 1988 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

1,038 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...