Question about 1991 Mazda 323

1 Answer

Meter Fuse (10amp) shorts/burns out

The turn signals do not work, the gas gauge is stuck on "F", the temp gauge is stuck on "C"

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 1,493 Answers

Check your instrument cluster fuse.It'll just say "Instruments".Fuse diagram is on back of the fuse panel cover.

Posted on May 14, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Temp/gauge not reaching normal working temp-richer


the first thing to check is to feel if the radiator is hot, if the radiator feels hot and the engine is also hot the coolant is circulating ok then the problem is more than likely electrical, the temp gauge gets its signal from the engine control module the coolant temp sensor sends coolant temp signal to engine control module for engine managment purposes then passes it to instument pack/gauge, if the sensor was at fault you would have engine running problems also,with poss fault codes logged, if the engine and rad are cold/only warm after the engine has been run for 15 mins or so it sounds like the thermostat is stuck open but you have changed that. i have had faulty new ones in the past and have had to test them in a pan of boiling water, hope this is some help to you.

Apr 02, 2015 | 2006 Jaguar X-Type 2.0

1 Answer

Check gauges signal , temp gauge stop work, when I acelerate everything goes normal again


My guess would be a short or problem with the printed circuit board in the cluster.

Jul 20, 2012 | Cars & Trucks

1 Answer

Gas gauge not working


The fuel gauge is operated by the fuel sending unit. The sending unit may be stuck. The temp sensor may also be bad.
First check your fuses.

Jun 19, 2012 | 1994 Nissan Sentra 4-Door

1 Answer

Changed fuel pump,now the gas gauge stays on half mark and oil pressure stays on also , temp gauge stays up to ,when key is off what would cause this


Well fuel gauge stuck temp oil pressure gage all gages i say you have one of the wires pinched above the gas tank!!!!good place to start

Jan 30, 2011 | 1996 Chevrolet Blazer

1 Answer

2001 Dodge Ram 2500 - gauges don't work


check the engine to body ground strap. located rear top of engine screwed to firewall Remove,clean, and resecure.

Nov 12, 2009 | Dodge Ram Pickup 2500 Cars & Trucks

1 Answer

My Speedometer and temp gauge are failing.They get stuck. Can you tell me how to fix it? Some people are saying that you have to remove the entire dashboard to get to it. I was also told that this is an...


Maybe I can help a little they are right it is one unit. How ever each one has a sendding unit and are fused. Your temp gauge has a sendding unit your speedodomder works off a cable. I'm resorring my first car 87' camaro none of the gauge work ex. the speed. No gas, no temp or oil replaced sending units they work now but they not cheap. I got tried of running uot of gas I'm a bad guesser.

Hope I answered your proplem.

Oct 06, 2009 | Chevrolet Impala Cars & Trucks

3 Answers

86 toyota pickup fuse box diagram


When I use my turn signal in my 1986 toyota pickup every 5-6 uses it blows the fuse and my blinkers, backup lights, gas gauge and temp gauge stop working. What is going on

Jan 07, 2009 | 1986 Toyota Pickup 4WD

Not finding what you are looking for?
1991 Mazda 323 Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...