Question about 1997 Mercury Sable

Open Question

97 mercury sable starts to **** while in drive at 4000 rpms

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1996 mercury sable speed hand and drives in strain and ****

I hace a 19196 sable-the problem is the transaxle speed sensor-this part sends all speed info to the computer ..-First symptom(speedometer stops working and then transmission shifts erratacially and power steering becomes hard and engine light comes on..The computer on this all eletronic car cannot send proper signals to the speedo-trans-power steering and other functions without knowing how fast or slow the car is going..Have the SPEED SENSOR mounted on top of the tranaxle replaced and all will be well.Part is not to expensive.labor can vary depending whether you have 3.0OHV or DOHC engine-some cars have to have exhaust dropped to get at it-Good Luck All

Posted on Sep 15, 2008

c17hydro
  • 2984 Answers

SOURCE: 2000 mercury sable drive belt

For VIN 2 FLEX Fuel:

4488d47.jpg For VIN U and S....with A/C:

c2b84a7.jpg PLEASE DON'T FORGET TO RATE!!!!

Posted on Apr 01, 2009

  • 109 Answers

SOURCE: cigarette lighter

First check the fuse... then try using a test light to check for power in the socket. If there is power replace the lighter coil... if not look for a loose wire behind the socket... Hope this helps...;-)

Posted on Apr 14, 2009

  • 104 Answers

SOURCE: Where is the air conditioner compressor relay

The relay for the air conditioner compressor is located in a black box on the radiator support. this is a multi-function relay box and is sealed. This box has a large bundle of wires plugged into it. This controls the fuel pump, A/C compressor, and cooling fans. Unfortunately, the whole thing will have to be replaced which will cost around 100 dollars unless you can find one in a salvage or junk yard.

Posted on Jul 16, 2009

  • 1 Answer

SOURCE: Why my turn signal don't

i have no turn signals on my 1998 mercury sable

Posted on Dec 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Please Help!!! 1999 Mercury Sable doesn't seem to accelerate past first gear..engine revs up to very high rpms.


If the speedometer stops working the odometer stops also. Sounds like it is stuck in first gear. The RPM went up because the throttle was response to pedal but transmission not response. Check transmission fluid color. Whip off dipstick on a white paper towel look for gray if see any that is metal shavings and transmission is bad.

Feb 16, 2016 | 1999 Mercury Sable

1 Answer

My 97 mercury sable 3.0 is very hard to start once started runs really rough for a second then smooths out


My first guess would be a dirty throttle body or a faulty idle air control valve.
Also one of the injectors could be leaking fuel into the cylinder when you stop the engine.
Is the check engine light on when the engine is running ?

Jul 09, 2012 | 1997 Mercury Sable

1 Answer

What size do I calibrate the spark plugs to a 97 mercury sable.


I have a 97 sable,my plug gap was .044.and runs good..

Mar 18, 2012 | 1997 Mercury Sable

1 Answer

My 99 mercury sable is running very poorly it cuts off at stoplights and ay other times it reves to 3000 rpms without my foot touching the gas. the car also drives through town at 45 miles an hour wihout...


on the back of the engine are some vacuum lines that get damaged.either that or the throttle position sensor is not working properly.it is located on the throttle body.

Jan 03, 2011 | 1999 Mercury Sable

2 Answers

Why my turn signal don't work on my 97 mercury sable?


i have no turn signals on my 1998 mercury sable

Nov 02, 2010 | Mercury Sable Cars & Trucks

1 Answer

2 times now when my 2002 Mercury Sable was low on gas (about 1/8 tank) it died while driving. Both times while it was in the process of dying, it wasn't running rough or RPMs going crazy, the RPMs just...


Sounds like your gas guage isn't accurate. A fuel pump is not designed to draw fuel from the tank until it is completly dry. This is to avoid sucking up all the debris on the bottom of the tank.

Dec 11, 2009 | 2002 Mercury Sable

1 Answer

I have mercury sable 2001 when the engine reach 4000 rpm start miss fire


Hi, the cause of this problem might be a faulty fuel pump. As soon as the engine is under load the fuel pump can't keep up with the demand and cause a misfire

Nov 04, 2009 | 2001 Mercury Sable

Not finding what you are looking for?
1997 Mercury Sable Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...