Question about 2005 Isuzu Ascender
Posted by Anonymous on
Drive it and it leans .hat
all modern cars do this
read any 7000 service manual.
the click find
they type learn
and you learn in minutes how PCM/BCM learn after a battery goes bad/dead as all do.
Posted on Feb 04, 2017
Clean your throttle body with battery unhooked. Problem will go away. Common problem.
Posted on Feb 02, 2017
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
that code means that the coolant is cooler than it is supposed to be and it cannot be regulated...which means the thermostat is stuck open or broken,so replace the thermostat and that should solve your problem,hope this sheds a little light on it!
Posted on Sep 26, 2009
i assume that you have a trailer light attachment installed at the rear of the vehicle somewhere around the tow hitch,turn on your head lights,obtain a volt meter and check D.C. voltage on the pigtail,ground the black lead to clean frame metal and check the pins on the plug with the red lead,one of them should be live 12v dc.that will be your trailer running lights,theother will be brake lights,you will have to have someone hold trheir foot on the brake to test it,dont assume the trailer is ok. verify voltage at the connector on the vehicle first,if you have 12 v,there the trailer has the problem,or if it hasnt been used in a long time the connector may need to be cleaned,as far as the fuse goes depending how it was installed,could be several choices,set your meter on continuity and check all fuses,you dont have to phisically remove each one,if you look close there are two small contact points on both sides of the amp rating number,most likely you will have two or three fuse panel locations,primary is under dash drivers side ,secondary panels and relays located in engine compartment under hood on fender walls black plastic box w/cover,,also may be on the sides of the dash board,can only see when the door is open ,or behind the ashtray in the center console,replace any fuses that are blown,be aware of the plug configuration on the car to the trailer,and that the ground wire on the car side of the plug is also the ground lead on the trailer connector, wires may have got mixed up during repair,happens to the best of us once in a while,clean ground connections are very important on trailers,old rusty wires and scerws should be removed wire brushed and reinstalled,or replaced if needed,then sealed with varnaloc,or spray paint,to protect them,hope this helps you.aloha from maui todd0708
Posted on Oct 01, 2009
First thing you need to check is the fuse, which should be under the hood. And then the bulbs. No... they didn't both burn out at the same time. They burnt out one at a time. You just don't notice iuntil the second one goes.
Posted on Oct 16, 2009
It could be a bad oil sending sensor, or the oil pump. When it drops, does the gauge stay on zero or fluctuates. The sending sensor isn't to bad to replace or cost wise, but pump is a different story. Have someone check the sending unit or just have it replaced to see if that's the problem.
Posted on Jan 18, 2010
Tips for a great answer:
Apr 09, 2016 | Isuzu Cars & Trucks
Aug 31, 2014 | 2005 Isuzu Ascender
Aug 15, 2014 | Isuzu Cars & Trucks
Apr 17, 2014 | 2005 Isuzu Ascender
Aug 20, 2017 | 2005 Isuzu Ascender
Nov 29, 2010 | 2005 Isuzu Ascender
Nov 27, 2009 | 2006 Isuzu Ascender
30 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: