Question about Toyota 4Runner

1 Answer

I have a 2011 toyota 4-runner the child lock will not unlock

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Toyota Master
  • 75,797 Answers

Then you will need to remove the door panel and replace the door latch assembly. What doo is this, front or rear.

Posted on Jul 14, 2016

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: replace front brake pad 2003 toyota 4 runner

Diagram is unnecessry.
Pull both front wheels
Work one at a time leaving the other for reference
Find the retention spring ... its a paperclip thickness wire spring... dislodge center retention loop and undo from both ends which engage brake pad retention rods.
Pull the rods out
Pull the old pads out... laying everything on the ground
Use scrap wooden wedges to pry between the rotor and the caliper ...inside and out until the calipers are fully withdrawn. Use the new pads to measure if they are far enough back.
Note... the brake fluid will have dropped in the master cylinder over many months of wear... do not fill it. When the calipers are pushed back they will fill the reservoir again... one wheel at a time.
Be sure to identify the correct pad based on what you took out and what is on the other side (if you screwed up the layout)
Make sure to take the old antisqueek backing plate from the old pad and place it on the new pad. They don't use lubricant on these anymore.
Replace the pads... the retention rods... then the retention spring
Do the other side
Then progressively step on the brake peddle until full tension is felt
Check the master cylinder reservoir... probably needs no additional fluid.
New pads will register in existing ridges in each disc in no time at all.
You should check the discs to see if they need to be replaced during this operation...using some calipers

Posted on Mar 25, 2009

  • 184 Answers

SOURCE: How to reset the ''Check Engine'' light on a 1999 Toyota 4-Runner?

http://www.obd-codes.com/faq/reset_obd_codes.php

Posted on Apr 04, 2009

  • 161 Answers

SOURCE: Wiring for Toyota 4 Runner Alternator Fuse

it should be in the underhood fusebox on the right.

Posted on Jun 11, 2009

  • 274 Answers

SOURCE: 2002 toyota 4 runner timing belt change interval

100 000km timing belt light on dash should come on when due

Posted on Jul 10, 2009

ZJLimited
  • 17970 Answers

SOURCE: where is the flasher relay located for 1998 Toyota 4- Runner

Toyota Pick-ups, Land Cruiser, and 4 Runner 1997-00
Flashers -REPLACEMENT

The turn signal flasher is usually located in the convenience center, under the dash, on the left side kick panel. In all cases, replacement is made by unplugging the old unit and plugging in a new one.

Hope helped with this (remember rated this help) Good luck.

Posted on Nov 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i unlock child lock on 1996 camry


page 14 of your owners manual shows how to lock unlock the child proof setup on door -----open door and by latch will see the the lock move to unlock position ! CAUTION LOCKING WITH REAR DOOR CHILDPROTECTORS Turn the lock knob to the "LOCK" position as shown on the label. This feature allows you to lock a rear door so it can be opened from the outside only, not from inside. We recommend using this feature.... the link is a copy of your owners manual
1996 Toyota Camry Owners Manual

Aug 11, 2016 | 1996 Toyota Camry

1 Answer

The key fob for my 99 Toyota 4 Runner unlocks doors,won't lock them.


please go to the alarm or dealer shop to replace or re program

Jul 13, 2012 | Toyota Cars & Trucks

1 Answer

I have a 2003 Toyota 4-Runner. The keyless alarm has stopped working on the drivers side door.


On the driver side the actuator is more likely the culprit,the linkage could of come off or the actuator just doesnt work

Mar 06, 2012 | 2003 Toyota 4Runner

2 Answers

Power door locks for 1999 toyota 4runner unlock but do not lock on inside switches or remote


I have the same problem I can unlock my toyota 99 4 runner but does not lock on inside switches or remote.

just found out about it today.

Feb 16, 2010 | 1999 Toyota 4Runner

1 Answer

Drivers door power lock wont work.


Either the wring going to that motor or the motor itself is bad.

Mar 08, 2009 | 2000 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...