Question about Lincoln Town Car

Open Question

Key fob not working, Battery OK

When I try to program the fob it runs the program just as the manual but the fob will not program I tried my 2nd fob, it would not take the program ether.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76846 Answers

SOURCE: programming a 1995 toyota avalon key fob

To program a remote... note that you must not delay more than 10 seconds between any of the operations.

Driver's door open, all other doors closed, key removed from the ignition switch.

Insert key into ignitions switch, then remove it.

Press LOCK then UNLOCK on the vehicle door lock control switch at 1 second intervals 5 times.

close and re-open drivers door.

Press LOCK and UNLOCK on the vehicle door lock control switch at 1 second intervals 5 times

Insert Key into ignition switch.

Switch ignition ON and OFF once to program a remote transmitter code while retaining the original codes or twice to program a remote transmitter code while erasing the original codes. three times to check how many remote transmitters are currently registered, or 5 times to erase all registered codes.

Remove Key from ignition switch.

System should now lock and unlock vehicle. Once, twice or five times depending which mode has been selected. It will lock and unlock one to four times slowly, to indicate the number of remote transmitters registered if you chose option 3.

Press and hold remote transmitter LOCK and UNLOCK buttons at the same time.

Press LOCK remote button for 1 second: System should now lock and unlock vehicle once to confirm, twice to indicate registration has failed.

NOTE: to exit programming mode, close drivers door or insert key in the ignition.

NOTE: a maximum of 4 remote transmitters can be programmed

Posted on Oct 13, 2008

Ad
  • 2 Answers

SOURCE: renault key fob doesnt work

Hi.
I have a clio II, 2001, i have the same problem and i fixed it.
Don't know if will work for you but here it goes:

1 - no key in ingnition
2 - press the unlock button in console off the car for about 10 seconds(dont let go)
3 - it should work the central doors one time and then 2 times( hear)
4 - press the remote a few times until it starts working

It worked for me hope the same for you.
Please tell me if it worked and pass the message.

Good luck

Posted on Sep 15, 2009

  • 1 Answer

SOURCE: key fob wont work on my Peugeot Expert

Try this, press and hold the large button on your key fob,after 20 seconds press the small button while still pressing the large one, the led light will go out and will reset your remote. It worked for me. ray1297

Posted on Oct 23, 2009

  • 4793 Answers

SOURCE: my Porsche Cayenne S Key fob no longer unlocks the Door

unlock the door then press the lock button on remote and hold down for 20/30 secs.manual does say hold button.....

Posted on Mar 02, 2010

  • 314 Answers

SOURCE: VW key fob has stopped working.

Your best solution is to contact the main dealer and get the whole thing checked out .you could spend hours looking for the problem and never find it .

Posted on Apr 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed battery on my key fob and it won't work


What is year--make--model?
The key fob is a transmitter so there has to be a receiver in the vehicle. At the moment, I can't tell if problem with transmitter or receiver? Can you try a different key fob? Where applicable, if key fob needs to be programmed, maybe the info is in your owners manual?

Apr 10, 2016 | Cars & Trucks

1 Answer

I cannot lock or unlock my car with my key fob


Test the battery inside key fob, should be at 3 volts, if is less than 3 volts replace the battery. If that does not work you may need to replace the key fob, on this vehicle you can program the key fob through the radio, the car manual shows you how to do this.

Before replacing the old key fob you can try to resinc the fob to the car by pressing the lock and unlock buttons at the same time for about 15 sec, if the door locks cycle the the fob will work again.

Mar 02, 2013 | 2004 Chevrolet Impala

1 Answer

What caused my '05 mazda 6 key fobs to stop working


Loss of programming maybe or a faulty keyless entry module.

Nov 01, 2012 | 2005 Mazda 6

1 Answer

The key fob for my car will not unlock the doors or start the engine


You say that your key fob does not unlock the car. Try to open the door ordinary and try to start the car. If the car wont start means that your key fob has lost the program and needs re-programing. The other option is either you by any case confused the key fob with the standard key which is only to unlock the doors. The last senario is when you have opened the key fob to check the battery lost the microchip and that is the reason for not starting. Check following my advice. Good luck.

Aug 17, 2012 | 1999 Nissan Primera

1 Answer

1999 porsche 996 replaced key fob battery disconnected battery now trunk releses are locked and cant access battery.How do you open frt trunk manually


Assuming the car battery is ok (if not, buy a male to male cigarette lighter at the auto store and connect to another car until charged enough to unlock the doors...but don't try to crank the ignition!). The trunks won't open if the battery went dead with the alarm set because arming the alarm physically locks the releases.

Sounds like the key code is switched off because you replaced the key fob battery. Try unlocking the car manual with the key in the door lock. Then switch the ignition on to reactive the keyless entry. If this does not work, you might also try pressing the fob unlock button with the key in the door lock until the dash led flashes.

Jun 10, 2010 | 1999 Porsche 911 Carrera

1 Answer

How do you program a key fob / transmitter for a 2009 Altima?


all keys/car have to be programmed at the same time.using nissan diagnostic machine.you could try a quickfit centre (if they have correct machine)

Feb 17, 2010 | 2009 Nissan Altima

1 Answer

Car won't start and the starter is new


Try the 2nd key

Try new key fob battery / 2nd key fob

Check alarm relay

Jul 15, 2009 | 1995 Mercedes-Benz C-Class

2 Answers

Key fob not working after battery change ford focus 2006


Try reprogramming it.

1. Turn the ignition from OFF to RUN 4 times within 6 seconds.
2. Turn the ignition OFF. The system will chime to confirm programming mode.
3. Within 20 seconds, press any button on first keyless remote.
The system will chime once to confirm programming.

4. Within 20 seconds, press any button on second keyless remote.
System will chime once to confirm programming.

5. Turn ignition to RUN to exit programming mode.

May 28, 2009 | 2006 Ford Focus

1 Answer

Do key fobs loose memory (06 Pontiac Grand Prix)


do you have the owner manuals .... it tells you how to program them for that car

Dec 11, 2008 | 2006 Pontiac Grand Prix

1 Answer

HELP HELP !!!!!!! Electric fault i think !!!!!!!!!!


1....ensure the battery in the "Key Fob" is OK............Press either Lock or Unlock button for more than 1 second, the lamp on the fob will light if OK. Change battery if it does not illuminate! 2.....if battery on fob OK.......Re Syncronise the key fob to the car by:.... a brief press on either button twice and within 30 seconds turn Key to position 2 on the ignition lock
Hope that fixes it...let me know?

Nov 09, 2008 | 1998 Mercedes-Benz C-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...