Question about 2006 Peugeot Partner Grand

Open Question

Engine will not start

1.6 hdi engine will not start unless i use holts easy start

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I used holts wonderweld in my cast iron cylinder head in 2013. Last week the car overheated can I use holt wonderweld after skimming the top or it still sealed.


I would say that you used Holts because of a leaking head gasket. You should be fitting a new head gasket so there should be no need for the use of holts.

May 03, 2015 | Cars & Trucks

2 Answers

Why does my Peugeot 307 fail to start it turns over but doesn't want to start had a new Key done for it and now it doesn't start was running yesterday but doesn't want to start today


wow , no year, stated, that makes it hard, no?, im blind
nor the engine, i open the hood and see and empty pit. (blind i am)
gas or diesel?
1.4 L ET3 I4 (petrol)
1.6 L TU5 I4 (petrol)
1.6 L DV6 HDi I4 (diesel)
2.0 L EW10 I4 (diesel)
2.0 L DW10 HDi I4 (diesel)


new key
(a metal key or a transponder key, an you only have 1 key for this car.
really?)

my wild guess
gas engine, lost spark. never tuned up. at 60k miles, or 100km.
diesel, same no service and fuel filters packed up.
key issues, if the immobilizer lamp glows, it will not start. (any car)





Jun 05, 2014 | Cars & Trucks

1 Answer

Boxer 2.0 hdi wont start when hot or cold without easy start once started runs well.


have the codes read as you have more than 1 sensor fault.

Mar 16, 2013 | Cars & Trucks

2 Answers

Instructions on how to use holts wondarwald


Holts Wondarweld
Flush engine.
EXTERNAL CRACKS
1 Run engine until hot,drain off enough coolant to remove thermostat.
2 Remove thermostat.
3 Mix contents of can thoughoughly! and pour contents into thermostat opening.
4 Replace thermostat cover.& fill radiator with hot water,replace radiator cap.
5 Run engine at a fast idle for 15 mins,dont allow to boil.Top up if necessary.
6 Leave Wondarweld in system for 2-3 days then drain off,flush system replace thermostat and refill.
HAIRLINE CRACKS
1 MIX thoroughly and pour into cold engine (radiator if it has a cap)
2 Run engine until hot.
3 Allow engine to cool then run again until hot.
4 Follow procedure 6 above.
INTERNAL CRACKS
1 Follow external crack instructions except after pouring Wondarweld into engine remove spark plug from
affected cylinder and run engine for 20 mins. If more than one cylinder affected run for 5 minute intervals.
2 Allow engine to cool then drain cooling system and refill with clean water.
3 Drain sump & flush,refill with fresh oil.
Note:- 1/2 pint of Wondarweld for every 6 pints of water,DO NOT add antifreeze for at least 3 days after process.

Aug 05, 2012 | Cars & Trucks

1 Answer

Hi, I'm getting code p1445 (additive level too high) after I refill additive (fit almost 4 lit.). I try to reset counter to zero but ecu reply there is no communication with ecu and on display message...


recently had similar problem 307 55 hdi engine code RHR getting p1445 + p1435. Hooked car up to launch 431 code reader got p1445 purge flow sensor circuit high input. pa435 a/c ref temp circuit range/performance no contact. Then hooked to snap on ethos p1445 diesel additive system quantity too high. p1435 diesel additive system incorrect message from can bus. checked tank level 1/3-1/2 tank about right for 55k fired pump by shorting briefly appeared to work as youd expect. few hours later after dismantleing most of car looking for depolution ecu stumped ! next day dropped in to local peugeot dealer who i know well after a conflab they agreed these are common codes easy solution! The depolution ecu is found either beside the passenger seat (left) against the sill or depending on where its built behind the fuse board/glove box (where this one was) just remove felt under glove box look up with torch behind fuse board youll see big relay type unit with slide out release (red) unplug clean (toothbrush w40) apply vv slight pressure to pins to adjust contact, refit, clear codes job done !! Common problem apparently worked for me easy & simple place to start !

Jan 18, 2011 | Peugeot Liberte Cars & Trucks

1 Answer

Citroen 2.5 hdi i have been starting the engine with easy start when you turn the engine of for a min. it wont start again could you please help me what to look for? thanks


First easy start is bad for the motor, it sounds like fuel starvation, could be a bad delivery pump in the tank, check in the fuel filter, any aliminium powder in the bottom (it should be brim full of fuel) it a tel tale of a bad pump. They are available cheaper on ebay.

Jan 02, 2011 | 2001 Volkswagen Jetta TDI

1 Answer

I have a peugeot 307 hdi, the engine was changed r...


Hi - have the same problem - battery gone dead flat and now have no start except on spray??

May 20, 2010 | Cars & Trucks

2 Answers

Peugeot 206 1.4 hdi has developed a fault where the engine will not start.After leaving the car rest for a couple of hours it will not start .I have to manually bleed the system and the car will start and...


expensive to repair properly,quick fix??? fit two non return valves ,one in the feed and one in the return to the injector pump ,weither conventional pump or common rail pump .this will cure your problem and its cheap to do ,two valves (observe direction) in the lines .works every time on any diesel engine weither its plant or road use

Oct 18, 2009 | 2005 Peugeot 405

1 Answer

How do I change spark plugs on a 2008 Dodge caliber


easy there may be a cover over he engine which just lifts off, then you need a selection of torx bits to remove the screws that holt the coils 1 for each coil disconnect the electrical connector on the coil and remove the coil pulling straight up then ysing a 5/8 spark plug socket remove th eplugs and install the new plugs put back the coils and go

Sep 20, 2009 | 2008 Dodge Caliber

2 Answers

SUSUKI VITARA 2008 ENGINE


Hello, I think Suzuki offered Peugeot/Citroen Diesel engines in the earlier models but started offering Renault Diesel in 2006. I believe that the gas motors were all Suzuki.
If you find that this info to be correct would you please enter a "fixya" rating.
Thanks, Gator241

Feb 16, 2009 | 1999 Suzuki Vitara

Not finding what you are looking for?
2006 Peugeot Partner Grand Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...