Question about 2002 Chrysler Sebring

1 Answer

Will not start!!!

I have a 2002 Sebring that was bumped from behind and now car will not start. Any ideas?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 85 Answers

Change the fuel pump.

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 chrysler sebring car jerks at 30 mph drives fine before and after that thou.


Re-tighten your gas cap after turning the gasket upside down or purchase a new one. Sounds simple, but it worked for me on my Sebring and on my wife's PT Cruiser.

Apr 14, 2013 | 2002 Chrysler Sebring

1 Answer

The breaks on my 02 lx 2.7 sebring chatter loudly every little bump in the road i hit i still have stopping power but it is very anoying. is there anything i can do to fix this problem of mine


There is a hardware kit you can purchase at most auto parts stores. It contains anti-rattle clips that apply pressure to the pads to prevent excess movement as the originals wear from heat and fatigue.

Aug 30, 2011 | 2002 Chrysler Sebring

1 Answer

2002 sebring, 2.7 engine replaced 15000 miles ago. Exhaust just replaced, needs downstream O2 sensor. The problem: Car will not start. Lights, fan blower work. Wipers do not turn on. Battery tested at...


the battery needs more power,, it needs to be over 12 volt..to startpay attention to the sound..
you may also not have enough fuel pressure.. you need to tested and must have 45psi
if not you have to replace the fuel pump

Dec 15, 2010 | 2002 Chrysler Sebring

1 Answer

The speedometer is stuck behind the peg.


Push and hold in the speedometer odometer button turn the key to almost starting the car when needles start moving release button wait for the needles to return to original position then turn off the key.

Dec 10, 2009 | 2002 Chrysler Sebring

2 Answers

Diagram of where spark plugs are in 2002 sebring coupe


I own a 2002 sebring 2.7 liters engine and i can tell you where they are. on each 2 top side of the engine you will see square blocks(3 on each side) with a couple of wires coming out , they`re held in place by two nuts, these are the high voltage coils, remove the coils and you`ll find the spark plug underneath. have fun

Nov 08, 2009 | 2002 Chrysler Sebring

1 Answer

Where is the PCM located on a 2002 chrysler sebring?


The PCM (Powertrain Control Module) is the aluminum box with fins that is behind the left headlight and toward the engine a bit. It's about 12" long 6" high and 2" thick and runs lenghwise from front to back. The box right behind the headlight that is about 6x6x2 and runs side to side, is the TCM ( Transmission control Module).

Oct 25, 2009 | 2002 Chrysler Sebring

1 Answer

My ac only works part of the time


u have a temp door accuator motor shorting out

Jun 30, 2009 | 2002 Chrysler Sebring

1 Answer

Heater only blows heat when accelerating


I think you might want to start with thermostat replacement and pressure flush the system and as other suggestion check levels when car is COLD!!!!!!

Dec 22, 2008 | 2002 Chrysler Sebring

1 Answer

1998 Sebring - Noise in the front of the vehicle


front wheel bearing got a 05 i have had 3 sets of them on in less then 4,000 each, bearings are junk dealer recomended to go with the v line wheel bearing supposed to do better

Aug 16, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
2002 Chrysler Sebring Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...