Question about Land Rover Discovery

1 Answer

Brake lights dont work,fuses good lamps good - Discovery Land Rover Cars & Trucks

Posted by on

  • Steve
    Steve May 11, 2010

    check your brake light switch

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 176 Answers

Check brake switch near brake pedal

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights dont work


Are you sure the brake pedal switch is properly adjusted? You should be able to reach under the pedal with your finger and activate the brake lamp switch. There are two relays in the rear of the car by the brake lights which activate (you can hear them click) when the pedal/switch is depressed. Make sure you also have the correct lamps specified in the owners manual. Usually if the bulbs are no good you will get an indication on the instrument cluster.

Apr 04, 2014 | 2000 Honda Accord

1 Answer

Tail lights dont work but the brake lights do


does your car have DRL option (canada) daylight running lights?)
my answer will be, non export jeep. USA jeep, no one ever says !!!!
the tail lamps are not brake lamps.
they are independant.
there are many parking lamps , and the tails are that.
do all parking lamps fail>? see FSM page 8w50-2
the tails run directly to the park headlight switch pin, marked park.
which gets power from fuse 34
the same switch and pin runs all other park lamps and same fuse 34.
so if the fuse is good, then all lamps are burned out , nah.
or the switch is bad, and can due to so many lights for so long.
if lamps are not dim then here is no short, so must be an open
Fuse 34 tops list , use an ohmeter to test the fuse. or replace it
as , they can get hair line cracks. inside fues
0 ohms = good, infinity = bad fuse.

Feb 08, 2014 | 1997 Jeep Grand Cherokee

1 Answer

Dodge ram 1500 wiring diagram


Three places to look. 1) Brake lamp fuse, 2) Turn signal switch and 3) the brake pedal switch. Brake light power comes from the fuse up to the turn signal switch down to the brake lite switch on the brake pedal and then on to the light bulbs. Start by putting the 4 way flasher on. If the brake lites flash, then the bulbs are good. That eliminated the fuse too. so the problem is the other two.

Jan 24, 2014 | Cars & Trucks

1 Answer

Where is the brake light relay on a 1995 chevy van G20


brake light dont have relay only fuse brakes are hot at all times on gms. in goes from fuse to brake pedal switch to hazard turn signal switch then to brake lights. ck fuse if good go to pedal switch if good go to turn /hazard switch the turn signal hazard brake all use same wire to lamps.

Aug 04, 2012 | 1995 Chevrolet G20

1 Answer

92 sunbird brake lights not working


check for bad grounds,that is usually it. may look good but need to pull and clean

Mar 17, 2012 | 1992 Pontiac Sunbird

3 Answers

Brake light dont work, change bulbs, fuse, bake switch, and has power still dont work


You have a failed brake lamp relay,this is located at the back right hand in the trunk at the quater panel.

Mar 12, 2012 | 2003 Honda Civic

1 Answer

Brake light dont work. 2006 chevy truck, 4.8L 2wd


Some of these had two fuses for brake lights. One for the top/center stop lamp and another for the rear left and right brake lights. Usually one said "stop" and the other said "brake" and one was in the underhood panel while the other was in the dash fuse panel. It's not uncommon to blow a brake light fuse [LR and RR] if you tow a trailer but some of these had seperate fuses for the trailer lights also. If you have a test light check both sides of the two fuses for power [ignition key on] while stepping on the brakes. It should at lest narrow your search a bit.

Jun 08, 2010 | 2006 Chevrolet Silverado 1500 2WD

2 Answers

Brake light wont light up when brake pedal is pressed


Sounds like a brake lamp switch or fuse. Check all fuses electrically, with a test probe you can purchase from any auto parts store. Go through each fuse with the probe touching the end or tip of the fuse after clipping the lead on the probe to a good ground. If the probe lights up at both ends of the fuse, the fuse is sound, if it only lights up at one end then replace that fuse and if the probe does not light up at all, that fuse is not active so turn on the ignition but dont start the motor. The brake lamp switch is attached to the brake pedal. It may have a single wire or several. All the switch does is connect the brake lamp circuit to an active supply rail so, The switch should have one active wire and the other wire should become active when the pedal is pressed. If it does not, replace the switch. If it does, then you may have two blown bulbs in the rear lamps or a damaged wiring harness to the rear lamps and you should seek the advice of a qualified person. Start with the fuses, then the switch, then the bulbs..and remember, you may have more then one fuse panel in the vehicle so check under the hood too..

Apr 24, 2010 | 1993 Lincoln Town Car

1 Answer

Kia Sadona 2004 brake lights not working. I have replaced the Brake light switch and removed the brake lights every time peddle is pushed down the fuse blows. Brake lights and brake light switch has been...


there is a short circuit in the brake light wiring it could be in the lamp holders them selfs pull off the wires to the brake lights holders on all the lamps and see if it still blows a fuse if it dose then the short is in the loom not the lights them self's if it dont blow a fuse hook up one light at a time untill it starts to blow fuses again the last light to be hooked up that blows the fuse is the faulty light

Nov 16, 2009 | 2004 Kia Sedona

1 Answer

No more Brake lights in rear spoiler


dear friend-if your other brake lights is working then you dont need to check the fuses as they all work together,check for power to the lamp or the lamp itself.

Jul 27, 2009 | 2003 Hyundai Tiburon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

349 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...