Question about 1996 Dodge Caravan

1 Answer

My 1996 cargo hard to push down on excelarator in drive.

The is no problem in reverse.when put in drive it goes but when i excelarate it slips to netutrel

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Dodge Master
  • 412 Answers

The kickdown linkage for transmission is seized at lever on transmission..spray with a penetrating fluid and try to work loose..if not,the valve body may have to come out of trans to freeup shaft..this is the short lever connected to throttle linkage at trans..should move freely

Posted on Jun 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wheels move when excelarating, when taking foot of excelatator the wheels go back to normal


i think this is normal due to the caster angle of front wheels,i presume you mean the steering wheel moves on acceleration

Mar 22, 2014 | 2000 Renault Laguna Estate

1 Answer

No excelaration at first changed egr valve and sensors checked relays truck wont start pump is new


Check your Inertia sensor for reset. It is usually behind a front kick panel or in some cases, at the rear cargo area next to the air ride switch. Sometimes knocking around on the other parts will activate the Inertia sensor.

The crankshaft sensor regulates fuel pressure by RPM. A failing Crankshaft sensor will under count the RPM resulting in low fuel pressure and poor performance.

Dec 27, 2013 | 2002 Mercury Mountaineer

1 Answer

Excelarate in secound gear but third


lets me all shook up !!! ,, give me more details ,,, dieing to know what happens in third,,, is it general loss of power or a shudder like a missfire ,,,, i will help best i can but need more

Dec 06, 2013 | 1996 Chevrolet C1500

1 Answer

My 2003 Chevy Tahoe idles very low. When driving at low speeds when not pushing on the excelarator the tahoe will die. It will even die sometimes when the vehicle is in reverse. it does when making...


You may need to clean inside the throttle body. YouTube has videos on how to do it. Also, your Idle Air Control motor might have carbon build-up in the passage for idle air. Take the motor off, and clean it gently and check the air passage for blockage.

Jan 24, 2018 | 2003 Chevrolet Tahoe

2 Answers

2009 Caliber: light on the dash that as two lines with a lighten...


I have a 2009 Caliber. Lately as I excelarate, this light on the dash that has two lines and looks like lightening bolt comes on and causes the car to not excelarate as it should. The car drives
less than 2 miles an hour when this happens. Even if I push the paddle to the floor, it still rides
very slow. What does this light mean? Please advise.

May 18, 2010 | 2009 Dodge Caliber

1 Answer

High pitch noise when excelarating past 75-80 mph, seems to be coming from where the dash meets the windshield. Becomes louder and more frequent when driving in really winding conditions. it goes away when...


Well how short a drive is it.........to get you to go nuts. Is it a high pitched whine? If so look to your right. Is the wife sitting there? If so. That's the problem. Going 75-80 in a 25mph school zone will cause that. And where is the speed limit 75-80 anyway.


It's the radio, btw, install an inline filter to filter out the alternator noise.

Jan 02, 2010 | 2006 Jeep Grand Cherokee

1 Answer

Problems during excelaration act's like it' going to cut out during excelaration seems like maybe a fuel problem it seems like it might be miss firing


It sounds like low fuel delivery, check the fuel filter, if it is after the pump and you can disconnect the line to the motor put the end in a container and get someone to start the motor, the fuel should spurt strongly. Beyond this you need to check the lines to the tank.

Dec 01, 2009 | 1992 Chevrolet S-10

1 Answer

Excelarator pedal very hard


4.6 v 8 its a gotta a double over head cam motor. which is chain driven,.{if thats the kind of car you have}

and yes u need to lubricate the accelerator cable with graphite.

May 29, 2009 | 1992 Mercedes-Benz 190

1 Answer

Car revs but sounds like it wants to die?


could be a pipe collapsing under vacuum

Feb 18, 2009 | 1999 Ford Escort

Not finding what you are looking for?
1996 Dodge Caravan Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81424 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22359 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...