Question about 2006 GMC Envoy

1 Answer

Ignition key turn

I only get a click sound, but the vehicle will not turn on. The battery, interior lights, radio are all fine,is this a fuse issue?

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 9,742 Answers

The solenoid on the starter motor is not engaging. Time for a new starter

Posted on Jul 24, 2016

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 261 Answers

SOURCE: Key will not unlock door

the lock on the driver side could be damaged or some on might have used a jimmy to open that door before how evr you have to open the pannel and remove the lock cylinder part and make sure that the key is working or yo must change the tumbler s in the lock to fit your key (lock smith)

Posted on Nov 19, 2008

  • 1201 Answers

SOURCE: 2001 jimmy not starting

You can try this==== take a screw driver and tap on the relay switch with the handle while somebody is turning the ignition. This is only a test, not a definate solution. If you haven't already, check the starter solonoid. My opinion, if the ignition was bad, it wouldn't even click at the relay, but without testing it's hard to say.

Posted on Jan 25, 2009

motor1258
  • 6674 Answers

SOURCE: key is on....battery is good....engine won't turn over

Black box (plastic) usually pretty handy to battery, you should see red (usually) cable from battery running to it. Another thing that came to mind, you don't have anti-theft system on that do you? Sometimes they will cause problems after a dead battery. Try using your key & valet key to unlock the doors, manually especially drivers.

Posted on May 18, 2009

  • 1374 Answers

SOURCE: 2002 GMC Envoy, i put the key in ignition and

Ignition switch and neutral safety switch. Next time it happens wiggle thekeys in the ignition switch and try to restart.If it starts its probably the ignition switch. Then locate neutral safety switch on brake pedal and put meter on B+ wire from switch to starter relay and see if you get B+ on the would -be- crank. Next locate B+ wire from starter relay to starter hook a meter to it and see if you get B+ on the would -be crank.
Where ever B+ is missing is your problem.

Posted on Apr 14, 2010

dmsr63
  • 2050 Answers

SOURCE: van won't start, when I turn ignition key there is

The only way to verify if a battery is good is by a load test, but...a volt meter will also give you a good idea. If you have a failing starter, the solenoid will click instead of engaging. You can tell by testing voltage with a meter. You have two wire going to the starter. The large one is from the battery, and the voltage should be the same as the battery, as it is there all of the time. The second and smaller wire gets positive volts only when you turn the key to "start" the engine. If you have these, the starter is the issue.

Posted on Jun 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Suzuki Vitara 2007


The battery terminal connections is loose or corroded.
Battery faulty or discharged, if the cable are clean and tight on the battery turn the key to the ON position and switch the headlights or windshield wipers. If they won't run then the battery is discharged.
Broken, loose or disconnected wires in the starting circuit.
Starter motor pinion jammed in flywheel ring gear.
Starter solenoid faulty, Starter motor faulty, Ignition switch faulty.

Nov 23, 2013 | Suzuki Cars & Trucks

3 Answers

Ok need some help. my 2006 taurus won't start. had the ignition done at about 90000 and now has 118000. car had been sitting for about 2 months. battery was changed and i changed the connectors on top...


had the same problem on a 99 buick regal no power going to starter silinoid and dash lights went out when key is put in start position.turns out it was the ignition switch.95.00 at auto zone

Nov 03, 2013 | 2006 Ford Taurus

2 Answers

2 din radio of when headlights on


Its the ignition live wire! they are nearly always yellow but please check your diagram. you will need to connect it to live.

Jan 15, 2010 | 2004 Mitsubishi Lancer

2 Answers

Nothing works and can't remove key from ignition


If the battery is dead, the ignition keys will not come out of the ignition cylinder. Don't force the ignition key to ensure you do not damage the pass lock system in your ignition. Jump the battery or replace it to get enough voltage to remove the key's from the ignition and check the fuse box for any blown fuses. Good luck and keep me posted.

Dec 08, 2009 | 2008 Chevrolet Impala

1 Answer

2000 Cavalier won't start, making fast clicking sound w/ ignition


Low voltage will cause the problem you are having,get the battery charged,and then have the alternator checked for the correct out put,13.65 to 14.25 if it is not in this range give or take a couple of volts,replace it,I would have the battery replaced also,so you won`t have the problem again.Have a shop replace the battery,if you do it yourself,the memory could be erased if certain measures are not performed.

Nov 14, 2009 | 2000 Chevrolet Cavalier

2 Answers

I posted this a little bit ago but forgot to mention The car would not crank. I started the car and it just dies. Wlould not start or even crank. When I put the key in the egnition (and NOT turning the...


check to make sure yu have 12v at the battery, once you do turn the ignition to start, if nothing, check the fuse and relays that control ignition, if all is good then the click sound is coming from the starter, have the solenoid replace.

Jul 31, 2009 | Saturn SL Cars & Trucks

1 Answer

I started the car and it just died. Would not


you may be out of gas or have a bad fuel pump

Jul 31, 2009 | Saturn SL Cars & Trucks

2 Answers

04 chevy 2500HD start relay /Circuit braker turns off @ key crank


Make sure battery has a full charge and battery connections all good. Any fuses in the diagram, test for voltage, some are hot all the time, some go hot with the key on.
Use a digital multimeter across battery posts, everything off, the generic spec for a full charge is around 12.6 volts. Leave the leads hooked up to battery, have a helper turn key to crank, how far does it drop? In my opinion it shouldn't drop much under 10 volts, I wouldn't argue with 9.6 volts.
2500 starter 1-h5vtzulw5yduyapxqxcg0ngy-5-0.jpg

impala starter 2-h5vtzulw5yduyapxqxcg0ngy-5-2.jpg

Mar 28, 2017 | Chevrolet 2500 Cars & Trucks

1 Answer

Electrical Problem


This sounds like a bad Earthing point off the ignition, fuse boards or battery, check ALL connections to the battery and earthing connections througout the vehicle, a long process, OR, you can take it to a vehicle electrician and pay them, the easiest solution is the latter.

Oct 08, 2008 | 1995 Mitsubishi 3000GT

Not finding what you are looking for?
2006 GMC Envoy Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...