Murano display screen was bumped and now the display will not turn on. What to do?

Here is the link.

HOOKING UP A BATTERY BACKWARDS CAN CAUSE SEVERE DAMAGE. THE SMELL IS MOST LIKELY ONE OF THE CONTROL BOARDS THAT SHORTED. BURNED CIRCUIT BOARDS REQUIRE REPLACEMENT

indicates that lower suspension rubbers are broken and should be inspected by an accredited front suspension professional service center

According to the owners manual - -
To turn on the screen, push the "SETTING", trip
control, air conditioner (except rear window defroster
button) or audio button.

There's nothing in the book about special instructions should the battery be disconnected, so if the screen will not come on I would guess a fuse or something happened to the power source.

NO, the back-up camera is a 6 volt camera on the Murano.

It is in the manual that came with the SUV. If not, there should be a hyperlink or website shown in the manual. Follow the instructions to the "T".

the av may be bad, if the other lights brighten then the av is bad, there are led bulbs but they are part of the circut board.hope this helps.

i found this on a Murano forum, so i cannot validate whether or not it works.
-To reset the maintenance notice on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule" key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.-

Hope this helps,
matt

There are 2 locations it could be:
- The first is under the glove box cover.There are several mini fuses in there.The next place to look is under the hood.There is a large fuse box on the passenger side by the alternator. The fuses are labeled in the cover.
- The last place is right by the battery, there is also a fuse box which is labeled.

Maybe, you need review this documents:
- 2006 Nissan Murano Owners Manual / PDF
* Display Screen: Section 4-44 / Page 156
* Fuses: Section 8-21 / Page 280

Good luck, and remember rated the help.

press the maintance button, this is where you can set the tyre rotation and oil change intervalls.
when in the correct screen if you press and hold reset or clear (Depending on region of car) should clear back to 0miles.