Question about 2004 Ford Expedition

1 Answer

Power Pedals My pedals will hardly move in either direction. Does anyone have any helpful info.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

HI, i had the same issue with my ford last year. i had to replace the motor. it was weak, due to bad windings.

I first replaced the switch but, it continued.

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power adjustable pedals all the way out and will not retract. can hear and feel power to them, but will not move more than a 1/4"


Adjustable pedal problem looking for part number or fix. - Ford ...

www.ford-trucks.com > ... > Expedition & Navigator
Feb 3, 2010 - The fuse is good....the pedals move about 1/2' but will not move to the full forward or full back position. ... by the DSM and are operational all the time, ignition switch ON, or OFF. ... The DSM will power the adjustable pedals until the switch is ... I will keep my eye's out for anymore info on how to fix them.

Jan 01, 2016 | Cars & Trucks

1 Answer

2001. Which fuse is for the gas pedal brake pedal controls to move them up and down?


Adjustable pedal problem looking for part number or fix. - Ford ...

www.ford-trucks.com > ... > Expedition & Navigator
Feb 3, 2010 - The fuse is good....the pedals move about 1/2' but will not move to the... Does anyone know if a pedal assembly off of a 2001 fit a 2003? ... 2 9G604 Adjustable brake pedal switch ... The DSM constantly monitors the systems under itscontrol and ... I will keep my eye's out for anymore info on how to fix them. Parking brake light comes and goes
Apr 23, 2012
No Turn Signals, Hazards, or Brake Lights
Jul 4, 2011
Shifter stuck in park, Anti lock lite flashing
Apr 18, 2008
cruise control not working - Page 2
Nov 22, 2003
More results from www.ford-trucks.com

Dec 25, 2015 | Ford F-150 Cars & Trucks

1 Answer

Clutch pedal replacement


I really would need to know the year of the truck and also what exactly is the pedals or pedal doing.The question you asked is very vague and as you can expect you will only get a vague answer.

Feb 12, 2015 | 2000 Ford Ranger SuperCab

1 Answer

How do I remove pedals from a magnecycle?


Hello there.
Don't know about Magnacycle but the Owners guide for Magnetrainer

http://www.magnetrainer.com/MagneTrainerUsersManual.pdf


shows the Pedals screw in to the Pedal Arms,So it appears you need a thin slim Spanner / Wrench to undo the Pedals from the Pedal Arms by inserting it between the arm and the Pedal itself. You will have to turn the Pedal in the Opposite directions to that shown in the Manual.
to get the pedals off and leave the Arms where they are already.

Sep 11, 2014 | Cars & Trucks

1 Answer

Can I manually move the power adjustable pedals on my 2005 F150 King Ranch Crew Cab?


you can if motors are any good, the motors are reversable 12v only for a tempary fix.2 jumper wires and a 12v battery

Apr 15, 2012 | Ford F-150 Cars & Trucks

2 Answers

2004 ford expedition with adjustable brake and gas pedal. when i depress the button to move the pedals it will barely move them


Hi there nsgpam! It sounds like the electric motors that do the work are worn out. You should be able to get those at an auto parts store but there is a chance that that would be a dealer item. Unfortunately there are some parts that the dealers wont let anyone else sell but them. Check out NAPA, Car Quest or Autozone, or any other large store.

Apr 23, 2011 | 2004 Ford Expedition

1 Answer

Where is heater core located on a 2001 grand caravan and how hard is it too change?


The heater core does not look too hard to change. Here are the directions. It should take a skilled technician with all the correct tools about 1.4 hours to change....you might expect to spend 2 hours or a little more doing the job yourself.
The heater core is located on the driver's side of the HVAC housing, near the driver's right foot.

Removal - FRONT HEATER CORE

WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions could result in possible personal injury or death.

  1. Remove the silencer boot fasteners located around the base of the lower steering shaft from the dash panel so that it may be pushed aside.
  2. Remove the brake lamp switch from its mounting bracket.
  3. Disconnect the power brake booster input rod (push rod) from the pin on the brake pedal arm.
  4. If equipped with power adjustable pedals, remove the adjustable pedal assembly.
NOTE: Take the proper precautions to protect the carpeting below the heater core from spilled engine coolant and have absorbent toweling readily available to clean up any spills.

  1. Remove the heater core tubes.
  2. Remove the two screws that secure the heater core mounting plate to the HVAC air distribution housing.
  3. If NOT equipped with power adjustable pedals, pull the accelerator pedal upward (Accelerator Pedal) and push the brake pedal downward (Brake Pedal) for clearance to remove the heater core from the air distribution housing.
  4. Remove the heater core by carefully pulling it straight out of the side of the air distribution housing.
Installation - FRONT HEATER CORE

  1. If NOT equipped with power adjustable pedals, pull the accelerator pedal upward and push the brake pedal downward for clearance to install the heater core into the HVAC air distribution housing.
  2. Install the heater core by carefully pushing it straight into the side of the air distribution housing.
  3. Install the two screws that secure the heater core to the air distribution housing. Tighten the screws to 2 Nm (17 in. lbs.).
  4. Install the heater core tubes.
  5. If equipped with power adjustable pedals, install the adjustable pedal assembly
  6. Connect the power brake booster input rod (push rod) to the pin on the brake pedal arm.
  7. Install the brake lamp switch into its mounting bracket.
  8. Install the silencer boot around the base of the lower steering shaft on the dash panel.
  9. Reconnect the negative battery cable.
  10. If the heater core is being replaced, flush the cooling system.
  11. Refill the engine cooling system.

Oct 19, 2010 | 2001 Dodge Grand Caravan

1 Answer

Pedals don't fully move when pressing the Adjustable Pedal button


sounds like the brake/accelertor adjuster motor isnt working... 1st start by checkin the fuses under the dash if all looks well go down to where the accerator pedal/motor is and check for 12v at the connector if your gettin 12v with the switch depressed replace the accerator pedal adjuster motor

Jun 02, 2010 | 2003 Lincoln Town Car

1 Answer

Trying to convert from manual brakes to power brakes, the pedals and rod length and diameter are different. Can anyone help me solve this probem, suggestions please. thanks johnv


Go to any scrapyard and take the entire assembly from one already equipped like that. Then you will have everything you need.

Aug 05, 2009 | 1984 Jeep CJ7

1 Answer

Power seat


Fuse #109 30A** Driver power seat, Adjustable pedals
** Cartridge style fuse

here is a link to your owners manual, all your fuse info is in it.
http://www.motorcraftservice.com/pubs/content/~WO5F12/~MUS~LEN/36/05f12og5e.pdf

Dec 19, 2008 | 2005 Ford F-150

Not finding what you are looking for?
2004 Ford Expedition Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...