Question about 2002 Infiniti QX4

Open Question

Smog fail code p1130 - 2002 Infiniti QX4

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why my 2002 ford focus Abs light stays on and wha is codes P1130 & 1131


P1130 - Lack of HO2S-11 Switch, Fuel Trim at Limit The HEGO Sensor is monitored for switching. The test fails when the HO2S fails to switch due to circuit or fuel at or exceeding a calibrated limit.
  • Electrical:
    • Short to VPWR in harness or HO2S
    • Water in harness connector
    • Open/Shorted HO2S circuit
    • Corrosion or poor mating terminals and wiring
    • Damaged HO2S
    • Damaged PCM
  • Fuel System:
    • Excessive fuel pressure
    • Leaking/contaminated fuel injectors
    • Leaking fuel pressure regulator
    • Low fuel pressure or running out of fuel
    • Vapor recovery system
  • Induction System:
    • Air leaks after the MAF
    • Vacuum Leaks
    • PCV system
    • Improperly seated engine oil dipstick
  • EGR System:
    • Leaking gasket
    • Stuck EGR valve
    • Leaking diaphragm or EVR
  • Base Engine:
    • Oil overfill
    • Cam timing
    • Cylinder compression
    • Exhaust leaks before or near the HO2S(s)
A fuel control HO2S PID switching across 0.45 volt from 0.2 to 0.9 volt indicates a normal switching HO2S.
P1131 - Lack of HO2S-11 Switch, Sensor Indicates Lean A HEGO sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time. See Possible Causes for DTC P1130

Jul 15, 2017 | Ford Cars & Trucks

1 Answer

P1130 CODE FOR 2000 TOYOTA SIENNA


The air/fuel ratio sensor has gone bad (basically the O2 sensor). The code P1130 is Bank 1 Sensor 1.
Sensor 1 is before the catalytic converter coming off the exhaust manifold. Bank 1 is which ever side cylinder 1 is on your engine. In this case its a sideways engine and its closest to the firewall.

May 01, 2014 | 2000 Toyota Sienna

1 Answer

Code for 1996 nissan pick up p1130


P1130 Swirl Control Valve Control Solenoid Valve.

Oct 31, 2012 | Nissan Cars & Trucks

1 Answer

Failed inspection! Check engine light on and received codes po440 and p1130 on a 2001 subaru impreza What could this possibly be?


your p1130 code is Oxygen sensor circuit malfunction (Open circuit) and your p0440 is Evaporative Emission System. so you could have a bad o2 sensor or a disconnected wire connector, sometimes with the heat they go bad after awhile check your wires and your sensor for continuity. For the EES it could just be your fuel cap is bad or not on tight enough, i keep getting this one too because i don't make it tight enough after fueling. good luck

Jul 29, 2011 | Subaru Impreza Cars & Trucks

1 Answer

How do i fix p1130 AND P 1440 code on my 2000 Nissan maxima? It takes about 5-6 minutes to crank up.


P1130 Swirl Control Valve Circuit Malfunction - With Automatic Transmission Possible Causes
  • Check for air leaks in the Air Induction system (e.g., in the intake manifold)
  • Check for leaks or looseness in hoses and tubes between the intake manifold, vacuum tank and swirl control valve actuator
  • Check for leaks or looseness in the hoses between the air cleaner assembly and the swirl control valve vacuum check valve
  • Crankshaft position sensor (REF) signal problem
  • MAF sensor has failed (it may be dirty or contaminated)
  • One-way check valve has failed
  • Swirl control valve actuator has failed (it may be damaged or sticking)
  • Swirl control valve control connector is damaged (check pins for damage)
  • Swirl control valve circuit is open, shorted to ground or shorted to voltage
  • Swirl control valve has failed
  • PCM has failed
  • Throttle position sensor has failed
  • Vacuum tank has failed

P1440...EVAP Control System (Small Leak)
Check your fuel cap & reset code,

Good luck, hope this helps,,,

Jul 15, 2011 | 2000 Nissan Maxima

1 Answer

1999 Camry 4 cyl. 104k miles, throwing codes p0125, p1130, p1135


P0125- Engine not reaching operation temp quick enough. Possible problems:
  • Insufficient warm up time
  • Low engine coolant level
  • Leaking or stuck open thermostat
  • Faulty coolant temp sensor
  • P1130- A/F Sensor Circuit Range/performance, Bank 1 Sensor 1

Oct 15, 2009 | 1999 Toyota Camry

1 Answer

1998 camry, 4cyl. P0171, P1130 toruble codes.


Hi.. On your question the definition of the codes are:
P0171, System to lean ( Fuel trim)
P1130, Air / Fuel sensor circuit range ? performance malfuntion This code is exclusive california Emissions). Oxigen sensor Performance malfuntion.
The first step you need to do is Check the Oxigen ( O2 sensor)
Connections The front and the rear one.
Check the condition of the Air filter Replace if need.
Check Spark plug Replace if need.
Check Fuel condition, Replace fuel filter if need.
And Clear the Codes if averything is good.
If the code P1130 return Replace the Air fuel ratio sensor..

Ok.. I hope this help on your question. If need more info letme know.

Thankyou for use fixya...

Jul 26, 2009 | 1998 Toyota Camry

2 Answers

Dose anyone no wat thease codes codes meen as my car wont start but turning the key on an of a few times it brings up thease codes p1130 and p1685


P1130 - HO2S Circuit Low Variance Bank 1 Sensor 1

P1685 - Skim Invalid Key - The engine controller has received an invalid key from the SKIM.

CLICK HERE for a full list of OBD Codes for the PT Cruiser.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Mar 05, 2009 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
2002 Infiniti QX4 Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14337 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...