Question about Mercedes-Benz C-Class

Open Question

Installation of ac compressor s430 2000 - C-Class Mercedes-Benz Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you bypass the ac compressor on a 2003 envoy with a shorter belt?


Yes, it wont hurt anything by installing a shorter belt and eliminating the AC compressor from the loop

Jan 09, 2014 | Cars & Trucks

1 Answer

Can we fix the heater and defrost in a 2001 Isuzu Rodeo LS without the AC compressor


You may be able to remove compressor and purchase a pulley with an arm that atttaches to the block in place of compressor. Or remove compressor altogether and install a shorter serpentine belt. Hope this has been of some help.

Nov 14, 2013 | 2001 Isuzu Rodeo

2 Answers

2005 Sedona fully charged,compressor does not turn on


Normally you would check for voltage at the relay then the low pressure switch, then the compressor clutch.
With the system charged or the low pressure switch bypassed you should have 12 volts at the clutch and ground. You can also check the clutch with an ohms meter to see if the magnet is open.

Aug 16, 2012 | 2005 Kia Sedona

2 Answers

Hi. I have a 2003 Ford Taurus that has a problem with the AC Clutch. There was a pretty nasty noise coming from my AC compressor, even when I wasn't using the AC. I took it in and the mechanic seemed


Yes in most of these instenses you can replace just the clutch assy. advance auto parts does offer it sepperatly. and they wont have to even open any lines. it just requires a special puller kit.

Dec 15, 2011 | 2003 Ford Taurus

1 Answer

How much compressor oil do I add when changing the ac compressor on a 04 expedition with front and rear ac?


When replacing the compressor the dryer should also be replaced, you put 2oz of oil in compressor and stand compressor on pulley for 5 min, then after install turn clutch 10 turns to pump most oil out of compressor, the dryer should have 2 oz of oil also, if you are flushing the ac system out with a solvent then more oil is needed for the system, if your just replacing the compressor then 2oz in compressor.

Oct 09, 2010 | 2004 Ford Expedition

1 Answer

I need a diagram on how to remove a ac compressor on a 1996 lincoln mark VII


There's not really a diagram for the actual removal and installation. A good repair manual might list steps like these: First, your system needs to be purged of the freon. Next, unplug the AC clutch/pulley assembly at the front of the compressor. Remove the belt, then the AC lines on the compressor (usually in the back), then unbolt the AC from any mounting bracket(s) and remove. To avoid having to press on and off the clutch/pulley assembly you might want to make sure you're buying a complete compressor assembly. Read and follow those directions concerning oil for the compressor. After installing the new AC, reconnect the lines with new "O" rings. Most if not all compressor manufacturers will not honor any warranty unless you change out your orifice tube (also called an expansion valve) and accumulator (aka the dryer) at the same time. Recharge the system with the appropriate amount and type of freon, most likely R-134a.

Oct 05, 2010 | 1996 Lincoln Mark VIII

1 Answer

Installed new air conditioning compressor in 2002 Pontiac Grand Prix - how much compressor oil do I need to put in?


If you have not cleaned out the ac system,the ac system will have oil in it,but,the compressor most likely does not have any in it,so pour about 4 to 5 oz in the low side opening on the compressor before installing it,and turn the center nut of the compressor clutch about 8 to 10 times,oil will try and come out the high side,when it does,this will be enough turning.If the system needs more oil,add as needed when freon is put in the system.If the oil is not added to the ac compressor before installing,the compressor could be damaged.Please rate if this was helpful,thank you.

Jun 11, 2010 | 2002 Pontiac Grand Prix

3 Answers

Installing compressor 91 civic do the lines have o rings or gaske


this honda uses o rings, these orings should come with the compresor,also you should replace the filter dryer when replacing the compressor,if the compresor locked up you may want to flush the system to get any metal chips out or it will destroy the new one, heres a picture of the filter dryer, its located next to radiator in engine area, good luck,881d179.jpg

Apr 28, 2010 | 1991 Honda Civic

1 Answer

AC Problems


If there is no gas in the system it as you pointed out the low pressure switch will shut the power to the clutch in the compressor off. your pressureswitch should be located near the dryer at the front of your Benz. You could try and bridge it to see if the compressor engages, how ever DO NOT try and keep it engaged without gas in the system or you may find yourself having to change the compressor again.

Jul 25, 2008 | 1988 Mercedes-Benz 190

1 Answer

Ac repair procedure 2003 ford taurus


recover r134. remove cooling fan and shroud assembly. Remove surp belt. Unplug compressor connector. From under car. Remove ac manifold retaining bolt. Remove O2 sensor from exhaust for clearance. Unbolt compressor and remove (some of the bolts will have to be inserted into the new compressor prior to installation. Reverse all steps and evacuate and recharge system.

Jul 08, 2008 | 2003 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...