Question about 1993 Cadillac DeVille

1 Answer

Absolutely NO BRAKES

Is this a brake line problem and if so is the repair typically over $300?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 957 Answers

Going over $300. is very easy to do. I could be more specific if you could tell be exactly what was told to you (what the car needs to be repaired).

Posted on Jun 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Got a problem with my brakes


Need more information about the brake fluid leak and what you needed to do to rectify it.

Brake pedal feel should be fairly consistent and when it isn't it does indicate something mechanical is sticking and freeing itself intermittently.
I suggest you inspect all aspects of the braking system systematically and thoroughly to ensure everything is serviceable. Pay attention also to the correct adjustment of the pedal linkage and if the master cylinder or brake booster servo has been changed at any time, the master cylinder clearance should be checked.
Check also wheel bearings for excessive free play.

May 05, 2016 | 1998 Opel Astra 1.8

1 Answer

Now for my brakes. The right rear brake locks up so badly that it even pulls the rear of the car down. I have completely rebuilt them and bled the entire system.


If the brakes are locking in that way I would suspect you have a partially blocked flexible brake line on that wheel. When you apply the brakes you can force the fluid through but when you release them the fluid will not flow back up the line and is locking your brakes as a result.
You will not see deterioration from the outside of the hose because brake hoses deteriorate from the inside especially near each end.

If you cannot fix it yourself take it to a brake specialist to diagnose.

Look forward to a civil law suit and a criminal prosecution if you disconnect your rear brakes and have an accident which I can absolutely guarantee you will.

Sep 29, 2015 | 1991 Buick Century

1 Answer

Brakes going to the floor will not stop master cylinder full no leaks around car what could this be


Sound like you have a Master Cylinder failure, you brake fluid is full, and no pedal resistance, if the brakes feel spongy then you may just need to have your brakes bleed, and got air in you brake lines, if you found that your brake resivoir tank low and added some recently, then maybe it pulled air into your lines. Good luck. Rick.

Aug 06, 2011 | 2000 Lexus Gs 300

1 Answer

Cant get brakes to work


Hydraulic brakes are quite simple in their basic operation, but can sometimes be difficult to troubleshoot.
Basically, a piston presses on a hydraulic fluid, which presses other pistons against the brake shoes.
Total failure is rare, but usually indicates where you should be looking to find the problem.
Typical points of failure are:
  • Brake shoes/pads. Shoes are used on drum brakes, pads on disk brakes. While they aren't typically the cause of total failure, they can be a problem.
  • Low brake fluid. Sometimes worn brake pads can result in significant piston movement inside the caliper. That can cause low brake fluid inside the reservoir. Check the fluid level.
  • Leaky master cylinder or slave cylinder. Usually you'll see fluid leaking around the inside of the wheels or down from the master cylinder.
  • Air in the brake line. If there is a poor seal on the master cylinder or if the brake fluid has been allowed to run out, it's possible that you may air in the line. The hydraulic line must be purged of all air for hydraulic brakes to function properly. If you haven't done it before, enlist the help of a mechanically inclined friend who has a little experience with bleeding the brakes.
Of course, it's always possible that a flexible brake line has ruptured or been cut or some other damage has occurred, but that's rare.

Mar 06, 2011 | 1997 Ford F250 SuperCab

2 Answers

I have a 2001 Ford Windstar and the brakes went out on me earlier in the week. I was able to nurse it in to a repair shop. They said the wheel cylinder ruptured. They replaced both rear wheel cylinders,...


The vibration could be caused by the engine missing, or otherwise may well be that the emergency brake adjustment wheel was not properly adjusted when the were reassembling the drum brakes in the rear.
You have been ripped off. The problem your van was having did not call for all of the work which was performed, and even if it had, those prices are absolutely out of line with what an honest repair shop would charge.

Jan 02, 2011 | 2001 Ford Windstar

1 Answer

Both front brakes are leaking brake fluid/Lexus es 300 1993


probably not. you won't know though till it is taken apart. the worst i think is the calipers are frozen. but most likely you can swap the hoses out and it will be fine. good luck and if you have any more question please ask

Sep 25, 2009 | 1993 Lexus Es 300

4 Answers

Drivers side rear brake line has a hole in it near a bend just after the axle. Is there a repair kit with a flexible hose and clamps or compression fittings availabe?


The best, SAFEST, and cheapest way to fix anything that has to with your brakes is just replace the brake line.

The brake fluid you're losing doesn't only affect that brake it will affect al four of your brakes and if the leak expands you could mash the peddle one time and have absolutely no brakes at all.

Brake lines aren't that much and it shoud take you under an hour to change it.

I hope this helps you out.

Thanks for letting FixYa.com....fix ya


Terry

Sep 14, 2009 | 1997 Chevrolet C1500

1 Answer

Replacement brake pads for 06 Lexus GS 300?


go with standard pads.they wear a little faster than ceramics.but they dont wear down brake rotors.ceramics pads are hard and they cause brakes to squeak.also your car is under warranty with lexus dealership.i would use what they said. because you have future brake problem. they will void out warranty for not using their brakes.

May 29, 2009 | 2006 Lexus Gs 300

1 Answer

1997 Saab 900 Turbo SE Brake Issue


Have you put the correct caliper on each side?
Are bleed screws facing upward?
If so you will probably need to have brakes pressure bled to push through air in ABS system.

Jun 18, 2008 | 1997 Saab 900

Not finding what you are looking for?
1993 Cadillac DeVille Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...