Question about Cars & Trucks

1 Answer

I have a 2004 jeep liberty with a hornet remote starter The remote starter turns the car on but the key won't What happened and how do I fix it? There is a hidden key in the car

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 486 Answers

More than likely the key has a computer chip in it, or the ignition switch could be bad. Try the hidden key to see if it works! If not, you may need to have the code matched to the ignition by a dealership, or locksmith!!

Posted on Apr 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2004 jeep liberty thermostat change?

ihave to change my thermostat in my 04 jeep liberty is it hard

Posted on May 22, 2009

ZJLimited
  • 17970 Answers

SOURCE: 2004 jeep liberty replacing the starter

2004 Jeep Liberty 4WD 3.7L MFI SOHC 6cyl
Starteer - Removal & Installation

2.4L & 3.7L Engines

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Disconnect the negative battery cable.
  3. Remove the starter mounting bolts.
  4. On the 3.7L engine, the left side exhaust pipe and front driveshaft must be disconnected.
  5. Disconnect the starter solenoid harness connections.
  6. Remove the starter.
To install:

8222c5e.jpg

Fig. Starter mounting: 2.4L engine

1ab95e7.jpg

Fig. The starter position for the 3.7L engine
  1. Connect the starter solenoid wiring connectors.
  2. Install the starter and torque the bolts to 40 ft. lbs. (54 Nm).
  3. On the 3.7L, the left side exhaust pipe and front driveshaft.
  4. Install the negative battery cable and check for proper operation.

2.8L Engine
  1. Disconnect and isolate negative battery cable.
  2. Raise and support vehicle.
  3. Disconnect solenoid wire connector from solenoid terminal
  4. Remove battery cable from stud on starter solenoid.
  5. Remove 3 starter mounting bolts.
  6. Remove starter from transmission bellhousing.
To install:
  1. Position starter motor to transmission housing.
  2. Connect battery cable solenoid terminal wire harness connector to connector receptacle on starter solenoid. Always support starter motor during this process. Do not let starter motor hang from wire harness.
  3. Install battery cable eyelet terminal onto solenoid B(+) terminal stud.
  4. Install nut securing battery cable eyelet terminal to starter solenoid B(+) terminal stud.
  5. Refer to torque specifications.
  6. Position starter motor and install 3 bolts. Tighten 3 bolts in this sequence: top bolt, bottom bolt, middle bolt. Refer to torque specifications.
  7. Lower vehicle.
  8. Connect negative battery cable.

Also can review the Service Repair Manual for Jeep KJ Liberty

I really hope help you with this (remember rated this help) Good luck.

Posted on Oct 05, 2009

  • 65 Answers

SOURCE: Jeep liberty 2002.....ignition key lock

Most commonly it is the key is worn out. If you have a spare key or your current one is not too badly worn, have a copy of it made and try it in the switch. You will have to have the copy key "coded" so it will disable the anti-theft system in order for the engine to start. If the new key doesn't fix your problem, you will have to replace the tumbler assembly.

Posted on Nov 20, 2009

  • 8 Answers

SOURCE: 2008 Jeep Liberty Won't Start and Sentry Key doesn't work.

check battery connections especially the ground

Posted on Feb 05, 2010

  • 125 Answers

SOURCE: The following happened all at once, not over time.

Here is a picture of a 2002 fuse panel...yours is probably the samekevin_r_fogo_1.jpg

Posted on Dec 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 jeep liberty won't turn over nor crank


The anti-theft system won't allow it to start . You replaced parts without knowing what would happen . The key has a transponder is the head of the key . The module that controls anti-theft doesn't see the transponder code an locked up the vehicle . Your best bet ,have it towed to a qualified repair shop . You don't have the tools or knowledge to fix it .

Jul 04, 2017 | 2004 Jeep Liberty

1 Answer

2004 Jeep Liberty, gear shift stuck in park. button won't go in


The first thing to do is check the brake lights, it they are not working the park lock system will not release the shifter.

May 17, 2013 | 2004 Jeep Liberty

1 Answer

2008 Jeep Liberty


Possible solution - This happened to me and my battery was dead in my key fob and also I needed an ignition switch because a piece on it was broken which therefore wouldn't turn to start the engine.

Apr 26, 2013 | 2008 Jeep Liberty

1 Answer

2004 JEEP LIBERTY. BATTERY GOOD. THE CAR WILL NOT TURN OVER. IT SOUNDS LIKE IT IS COMMING FROM FUSE BOX UNDER HOOD


I assume you are hearing a starter Relay/solenoid chattering. That's usually caused by:

A dead battery.

A loose connection on Battery or start relay/solenoid.

Bad connection at starter or bad starter.

Good Luck

Jun 29, 2011 | 2004 Jeep Liberty

1 Answer

2004 jeep liberty won't start no click


your key starter might be bad or unplugged

Dec 05, 2010 | 2004 Jeep Liberty

1 Answer

2004 jeep liberty will not start....new battery and all my lights work, everything in side works but the POS still wont crank...thought it was the starter but im not hearin the clickin and the starter is...


probably a security but if you have two keys and both of them dont work go to a parts store that will let you borrow a code reader O reillys etc other than that get the trusty test light out and check power at starter when key is turned make sure the new starter isnt foul in up tap it with a hammer lol

Nov 27, 2010 | 2004 Jeep Liberty

1 Answer

I have an 08 Jeep Liberty that has a remote starter on the key. I tried to unlock the car with the remote, however, that didn't work, so I unlocked the car with the key. The alarm went off, I tried pushing...


Sounds like you have a key without the chip in it. Replacement keys without the chip will only unlock the doors and will activate the theft alarm when you start the vehicle.

May 22, 2017 | 2008 Jeep Liberty

2 Answers

Jeep won't start. turn the ignition key and hear clicking sound in engine compartment. I had a remote car starter installed 2 years ago and can start the car that way. when i started the car with the...


clicking when you turn the ignition on most vehicles could be one of two things. First the selenoid for the starter. Second the batterry is worn out or drained. Since your jeep starts with the remote its not your battery. Lucky for you your remote starter is like having a second selenoid. If you are so inclined you might try to fix it yourself. Open the hood. Have someone else turn the key. Follow the sound. I don't have a jeep of that model to look at but It could possibly be comming from a two post terminal that is realatively easy to change. If you are worried about reassembly take pictures before you start. Clean all connections that look corroded.

Feb 21, 2010 | 2006 Jeep Liberty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...