Question about 1995 Jeep Grand Cherokee

1 Answer

Output shaft bearing

Output shaft gasket for front differential is leaking badly on my 1995 jeep grand Cherokee. what do you suggest.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 176 Answers

Leaking by axles or input shaft (driveshaft),if it is the pinion change the seal, make a dot mark with a punch on the nut and the pinion before removing the yoke to tight it at the same place, unless you do that you will burn the bearing it hapen to me one time

Posted on Apr 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 334 Answers

SOURCE: 2001 Jeep Grand Cherokee Limited is squeaking

duse the howl go away when you trun a conner ?if it duse its a wheel bearn. as for the squeak its hard to pin point. try finding some one how duse mud run they would be ableto help you with the howl noise. have a nice day

Posted on Mar 31, 2009

  • 94 Answers

SOURCE: The rear differential leak on my 2002 Jeep Grand Cherokee

If your talking about the cover then yes it is very easy to accomplish.

Posted on Sep 21, 2009

  • 6982 Answers

SOURCE: I have 2001 Jeep Grand Cherokee Laredo and it is leaking coolant

Front drivers side could be a bad cap, lower hose or the radiator itself. You need to look carefully and find the leak source. Steam travels and isn't a good indication of where the actual leak is coolant will run down and take any path it can to reach the ground. Therefore, you need to follow it back to where it is coming from, then deal with it. Your water pump can also leak and run down the lower hose. there is a small hole in the pump behind the pulley. If you see coolant coming from there the pump needs to be replaced. Sealers will not work on hoses or pump leaks so don't bother using them for that.
Good luck...don't forget this is free, so rate answers!
I will answer follow-up questions too!

Posted on Jan 25, 2010

  • 2 Answers

SOURCE: fuse box diagram for 1995 jeep grand cherokee 6

EMAIL ME I CAN CAN EMAIL YOU THE LAYOUT

vernonscbiker@hotmail.com

Posted on Mar 30, 2010

  • 46 Answers

SOURCE: Front drive shaft on Jeep Grand Cherokee

yes but make sure you don't in gauge the front axle

Posted on May 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Was told drive shaft was worn out needs rebuilt or new any 1 here of this


Rebuilding them consists of new U joints and maybe balanced. If it was so loose the the u joints wallowed out the keepers, Then yes, they would also need replaced. Cut off and welded on. That isn't a common problem, but I have had to replace a few. Not just on jeeps.

Feb 05, 2016 | 1999 Jeep Grand Cherokee

2 Answers

1995 Jeep Grand Cherokee at parking lot speed I have a chatter coming from the diff. when I let off the accelerator, I have replaced the fluid with Royal Purple which says I DON'T have a modifier.


Sounds like you could possibly have a pinion bearing issue. Have you had the pinion seal replaced recently? if so, sometimes the nut that holds the yoke on the rear differential gets over-tightned causing the pinion bearing to be too tight in the race, therefor damaging the bearing assembly and causes a "chattering" sound. When a pinion bearing goes bad in these Jeeps that is the noise they will make, even at lower speeds. Hope this helps..

Oct 22, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Differential gasket


Rear cover gasket is easy. Unbolt, drain, clean and replace gasket; fill with proper gear oil. Pinion seal on the front of the differential, different matter. If its the pinion seal leaking, take it to a shop with experienced techs.

Aug 11, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Just wondering is the drive shaft is located in or around the differential- my jeep was smoking with a foul odor coming from underneath the vehicle and I was told by 2 mechanics that I need to replace the...


I own an 02' Jeep Liberty. It is either the differential, or the drive shaft.
Is it the front or rear driveshaft? Does the Jeep drive? If the driveshaft
was bad, it wouldn't move, so I'm assuming he's screwing you,since driveshafts don't smoke.LOL. If your front or rearend lube has come all
out or very low, you could get smoking from the diffs,especially if the fluid hit's your exhaust. look under the jeep, to see if any fluid is leaking
from the front or rear driveshafts?good luck.

Mar 29, 2010 | 1996 Jeep Grand Cherokee

2 Answers

How much in ny to replace front end differential, horrible whaling hum from front end. did local shop cause this when seals were done last year, i heard they have to torque it properly or this damage will...


only if seals leaked out the gear lube.
you need to check the fluid level first,
and make sure your not hearing a front wheel bearing going bad,does it make the noise only in four wheel drive?
before you start worrying about price of front differential you need to locate for sure what is causing it.

Dec 06, 2009 | 2000 Jeep Grand Cherokee

3 Answers

Whining/grinding noise at deceleration


We have the same problem at our shop. We haven't rebuilt the front differential yet. We tried 3 different shafts on 2 different Jeeps and the noise is on both just the same. By greasing the front driveshaft cv joint, we got he noise to quiet some, but it is still way to loud. With the driveshaft out, the noise is gone. We are about to buy a new shaft from the dealer for $600. There are some service bulletins about some noisy driveshafts.

Jun 15, 2009 | 2009 Jeep Grand Cherokee

1 Answer

Whouling niose when speed increses and decreses on my jeep grand cherokee 1998


You need differential carrier and pinion bearings. Jeeps had many problems with the differentials in these years.

Jun 02, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Front end and rear end differential


The 99 Jeep Grand Cherokee was prone to bad diff bearings because they changed the plant where they were made. The new plant used inferior materials. The only way to fix it is to replace and set the diff clearences.

Feb 17, 2009 | 1999 Jeep Grand Cherokee

1 Answer

1995 jgc limited rear end noise


If you removed the pinion and only replaced one of the bearings that was a mistake. You need to replace both at the same time. Also since it is a Dana differential you should have replace the crush sleeve also as this set the correct preload on the pinion bearings.

Feb 02, 2009 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...