Question about Cars & Trucks

Open Question

Why has the pump stopped heating and the jets come on on there own

Been plugged in for over 4hrs to heat i cant seem to alter the temperature up to what we want its been going for a while when we noticed it had stopped heating the red light went out and the filetr stopped all that we could hear was the pump we pressed the filter button and it started again then after a hr it went off again we did this again and then the jetts started on there own ive turned it off as i have a inflatable lid and cover on n wasnt sure if your suppost to let the jetts run with these on has any1 got any idea what could be wrong here as its starting to annoy me trying to heat this and then this problem starts waisting electric for something that may be a easy fix this is my 1st time using 1 of these and i have no instructions and can't seem to find anything out on line regarding this problem

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

keemo68
  • 1263 Answers

SOURCE: ABS light and pump

after you took the fuse out and it stopped did you put the fuse back in and see if it continued to run?

Posted on Sep 02, 2008

tripletauto
  • 1450 Answers

SOURCE: Van heating up and then cooling off?

sounds like your low in coolant. this will cause an air pocket in engine and cause erratic temp readings/loss of heat check coolant in radiator when cold. and add

Posted on Dec 09, 2008

  • 58 Answers

SOURCE: 1997 chevy 2500 4x4 stumbles

Fuel pump is most likely the cause. Probably just barely making the required pressure to start. Needs to maintain 60-66 psi while cranking to start.

Posted on Dec 21, 2008

  • 31 Answers

SOURCE: Overheating/No Heat 2001 Impala

change the thermostat and the temp gauge in the radiator

Posted on Mar 08, 2009

Molson02536
  • 3854 Answers

SOURCE: My son's 2004 Kia Optima started stalling on the

Start with the simple and replace the fuel filter. The fuel filter should be replaced every 15,000 miles or once a year to ensure the fuel system is running 100%. Auto Zone will have the fuel filter and can give you the step by step instructions to getting the job done with common tools. If it's the fuel pump failure, you have not gotten the car restarted. Good luck and keep me posted, be glad to know you got your car running 100% again soon and please rate.

Posted on Jan 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi I'm having this message, 'low oil pressure' when temp go to suitable temperature my car Peugeot 407


The engine bearing clearances expand with heat which, if excessive, will lower the oil pressure. The spring in the pressure regulator in the oil pump will cause the pressure to drop for the same reason. A partially plugged oil intake screen will work in conjunction with the oil pump to cause it too.

Nov 15, 2015 | 2009 Peugeot 407 2.7

1 Answer

Died on rd, replaced fuel pump, crank pos sensor, temp sensor. Still starts gets to operating temp then skips dies. Won't restart till cold then same thing


A bad thermostat leads to poor engine performance as it alters the engine's operating temperature greatly. Moreover, it could also lead to reduced gas mileage. God-Bless! It may be stuck closed, if this happens it will over heat. If the thermostat is stuck here, the radiator coolant would stop working, resulting in the car overheating.

Jun 08, 2015 | Cars & Trucks

1 Answer

I have a Chevrolet 2005 Suburban and the heating/cooling fan will not cut off unless I disconnect the battery or take out the fuse, any ideas?


most likely your temperature sensor for the fan is stuck on your heating fan will run when the key is off if it is getting a high temperature signal from the switch ,, put it back together and get the fan to run then unplug and plug back in sensors around the thermostat and water pump areas until it stops, then replace that sensor

Oct 20, 2014 | Chevrolet Suburban 2500 Cars & Trucks

2 Answers

R reg toyota previa over heats. had new pressure cap n tested the head gasket so both of them are fine. is it likely to be the water pump? as its worse wen Im startin n stopping but seems fine wen Im...


It appears that you have a viscous fan hub driving the fan or should I say failing to drive the fan. The fix is to replace it . If you have electric fans then there is a problem in the temp sensor system and the fans are not cutting in on temperature The problem you state is indicated by the fact that when driving there is sufficient air through the radiator to remove the heat from the radiator ..but when driving slow there is no air flow because the fan is not drawing air through the radiator and the temperature climbs until over heat is reached . Typical indicators of fan speed problem is overheating at stop sign/lights, slow heavy traffic driving, slow up hill driving, and rapid cool down as road speed is increased , the faster the speed the cooler the motor

May 15, 2014 | Cars & Trucks

1 Answer

Cannot change temperature on heat & air


Temp is controlled by an electric motor(or could be vacuum hose) on the blender door of heater housing. If you find this is operating correctly, then the problem is a plugged heater core.Backflush it by removing both heater hoses and flushing from water pump side toward thermostat side.don-ohio

Oct 23, 2011 | 2000 Mercury Grand Marquis

2 Answers

Land Rover Discovery 1996 3.9 V8i Cooling Problems


you need to replace the heater core and pressure text the radiator cap, replace if it leaks down go to a parts store to do this also you need to replace freeze plugs if you don't they will blow and ruin the engine,a slo check that the water pump is not bad, loosen the pump belt and see if you can wiggle the water pump with fan connected, if you have any play replace the water pump. and add new anti freeze.

Jun 18, 2009 | 2003 Land Rover Discovery

2 Answers

No interior heat / engine overheated 97 dodge ram 1500


From your description i would say the thermostat stuck closed, no heat, running hot, boiling in resavor, thermostat bad, replace. must of got real hot to makes that kind of clunking noise, I just hope for your sake thats all it is, of course i don't know the history of the truck, but right now it sounds like thermostat. There is an outside chance it could be a head gasget, cracked head, pluged radiator, thies are all worst case sanareo.

Feb 17, 2009 | 1997 Dodge Ram 1500 Club Cab

2 Answers

Daughters 1996 ford contour 4 cyl. died on the road.After sitting a while it started again then drove it home.It starts and runs good but after warm up it bubbles out the expansion tank, I replaced the cap...


dear sir,

the solution to your problem is simple. yes you say that it has a new water pump, but the reason that a vehicle bubbles out of the expansion tank is because the water pump is not circulating coolant, the coolant boils in the engine and bubbles out of the expansion tank. secondly the reason the fan never kicks in is because the temp sensor is not seeing the heated coolant because the water pump is not circulating the coolant through the cooling system. 3rd. the heater never gets hot because the water pump is not circulating coolant through the heater core in order for it to get hot and provide heat. and the temperature gauge never seems to go up because yup you guessed it, the water pump isnt circulating coolant in order for the engine temperature sensor to see hot coolant and thus send a signal to the engine temperature gauge as to the coolant temperature. i know you said it has a new water pump, but i have heard that this type of vehicle may come with a plastic fin pump. i would remove the pump and check the passages for foreign matter{ trash} in the passages as well as the condition of the new pump. also one last thing, the reason the vehicle died on the road in the first place was probably because it overheated. happy hunting and please post to see what you found. i am a mechanic by proffession.

Dec 17, 2008 | 1996 Ford Contour

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...