Question about 2009 Chevrolet Traverse LS

1 Answer

Replace water pump 2009 Chevy Traverse ls

Do I access the water pump by removing parts from the top or do i go in throught the fender well

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 78,267 Answers

Which engine.

Posted on Apr 17, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
AUTODOC01
  • 216 Answers

SOURCE: 1993 chevy van g20 water pump replacement

you will need some fairly long wrenchs 15mm-16mm to get leverage on the spring loaded serp tesiner put a wrench on the pulley near the belt ? also loosen the 4 fan bolts on the water pump before you remove the belt ? ther are 7 fan shroud bolts you can split the fan shroud ? 2 bolts on the lower right and 2 on the left ? after you do this then you should be down to pulling off the fan and pulley just slides off ? then remove the 4 waterpump mounting boltss, scrape the old gaskets ? when this is done all you have left is to installthe fan studs from the old pump? you do this by screwing down 2 nuts on the stud then with 2 wrenchs lock the nuts together ? then unscrew the bottom nut ? keep doing that till all 4 are replaced? install the gaskets and add some silicone and reverse the process ? hope this helps repost thumbs up !!

Posted on Aug 29, 2009

dealt_soul
  • 296 Answers

SOURCE: 2009 Chevy Traverse Intake Pluem Full of creamy

It it water or anti-freeze?

If its water then somehow water was sucked up through the air intake. Check the filter box for leaks. If no leaks in the filter box then check all connections from the air box to the intake plenum.


Posted on Jan 24, 2010

  • 1 Answer

SOURCE: WATER PUMP REPLACED BUT THERE IS STILL A LEAK

im having this problem now getting ready to replace my water pump i hope it is what it is if not what did u come up with thanks for youe input

Posted on Mar 05, 2010

  • 41 Answers

SOURCE: 2009 Chevy Traverse with 3800 on it, w/ low coolant

good question with it being a 2009 i'd ask chevy

Posted on Apr 05, 2010

Rickygittins
  • 715 Answers

SOURCE: how do you remove the

I believe the center pieces are glued/double sided taped to the roof and the out side rails are bolted to the roof, need to remove the inside headliner.and then plug the holes.

Posted on Aug 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My rear air conditioner on my 2011 Traverse only blows warm air. Front air works good


clogged air condition filter leading to rear unit Possible LOW on FREON

Aug 20, 2014 | 2011 Chevrolet Traverse LS

1 Answer

Will changing the battery in a 2009 chevy traverse cause a overheating problem?


the thermostat is staying closed possible or a leak in the system have you checked the lines and water pump or radiator but nothing related to the battery

Apr 16, 2013 | 2009 Chevrolet Traverse

1 Answer

Water pump replacement procedure


there are pictures on the chevy traverse forum of water pump leaking.you will have to buy pump,gasket,new bolts.the bolts are flex bolts and can be used once.just downloaded the chevy traverse gm manual from ebooks.com for 11.99 for a havac achuator problem .same book the dealer has but in pdf

Jan 31, 2013 | 2009 Chevrolet Traverse

1 Answer

Parking brake adjustment on 2009 traverse


There is an adjuster on the driver's side. It is on the cable near the rear fender well.

Dec 10, 2012 | 2009 Chevrolet Traverse LS

1 Answer

Replace cabin air filter on chevy traverse 2010


2009 chevy traverse- where is the cabin air filter located. It definatly has one but ??? where.

Jun 18, 2012 | 2009 Chevrolet Traverse

1 Answer

Crankshaft sensor location chevy traverse 09


I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.

May 05, 2012 | 2009 Chevrolet Traverse

1 Answer

Where is the camshaft position sensor in the 2009 chevy traverse?


I spent hours in engine and on the internet. I viewed 15 different sites with 15 different answers. Finally found it...The crankshaft position sensor on a 2009 Chevy Traverse (3.6 liter) is as follows: You need to jack up vehicle (or useramps) and climb under. You CANNOT access it from top (as many sites state). On the firewall (vehicle) side of motor, in the center, directly below the exhaust outlet, you will see a silver (aluminum) heat cover/plate. It is held on by 2 bolts. (one 15mm and one 10mm). The sensor is located benind this cover. Once you get this cover off, you will see two seperate sets of wires, wrapped in silver heat deflection tape. The set of wires that extends further to the left go to th CPS (sensor). I used a small extendable automotive mirror to see it. It is in a tight spot, but once you find it, it is easier to access than it looks!!! Took me about 30 minutes total to switch it out. Hope this helps !!! Good luck.

Feb 03, 2012 | 2009 Chevrolet Traverse

1 Answer

How do you remove the luggage racks on top of a 2009 chevy traverse?


I believe the center pieces are glued/double sided taped to the roof and the out side rails are bolted to the roof, need to remove the inside headliner.and then plug the holes.

Aug 26, 2011 | 2009 Chevrolet Traverse

1 Answer

2009 Chevy Traverse Intake Pluem Full of creamy foamy water apon removal


It it water or anti-freeze?

If its water then somehow water was sucked up through the air intake. Check the filter box for leaks. If no leaks in the filter box then check all connections from the air box to the intake plenum.


Jan 24, 2010 | 2009 Chevrolet Traverse

Not finding what you are looking for?
2009 Chevrolet Traverse LS Logo

459 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...