Question about 2008 Hyundai Santa Fe

1 Answer

Codes P0305, P0441, P2187, P2189 on in a 2008 Hyndai Santa Fe

Just Started on way home. Car stutters and doesn't have power it should. Where to Start

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 176 Answers

Did you change air filter recently look like mass air flow, is the hose between air filter and engine is not tight or not crack,if so cannot measure amount of air to give the exact amount of gaz

Posted on Apr 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 hyundai santa fe car alarm

I had the same problem a while back. What I did was disconnect the battery for a minute and I havent had that problem since.

Posted on Feb 14, 2009

emissionwiz
  • 75051 Answers

SOURCE: Santa fe

P0102 - Mass Air Flow (MAF) Sensor Circuit Low Frequency

P1702 TPS - Abnormal
P1702 TPS - Malfunction Adjustment
P1703 TPS - Low Input
P1703 TPS - Open/Short (Ground)

Posted on Sep 27, 2008

  • 21 Answers

SOURCE: 2003 santa fe

It needs a new pruge valve. The purge valve is sticking open allowing fuel vapors into the intake manifold causing a rich hard start condition.

Posted on Jul 02, 2008

  • 51 Answers

SOURCE: start and diesss

p0456: evap system. sensor failure
p0172: evap system. intake blocked
p0778: exaust valve control. solenoid/ecu faukt
p0300: cylinders misfire. check ht/ignition leads
p0301,303,304,305,306: same ht leads

hope this helps..

Posted on Apr 27, 2009

  • 66 Answers

SOURCE: OBD2 reader,reads P2125 ... on a Hyndai santa fe

Sounds like a throttle position sensor. That is what it is called on american made cars but would serve the same function. The throttle position sensor would do exactly that, tell the engine where your foot is on the throttle ( or gas pedal) it is generally not an expensive fix, check with your parts store.

Posted on Dec 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My problem in the type of car Santa Fe at 2007 3.3L examination give code p0174


Stuck with these codes P0174 and P0171..need help - Hyundai Forums ...

www.hyundai-forums.com/.../237193-stuck-these-codes-p0174-p0171-n...

Feb 12, 2014 - 10 posts - ‎6 authors
I've been getting these codes for awhile now which are p0174 "ECM has detected ... 06 Sonata LX 3.3L V6 ... the fact that your FE has gone down could indicate something else as .... 2014 Santa Fe Sport 2.0T AWD w/ Tech Package ... Join Date: Jul 2007 ...More on PowerTorque Tools - Hex Bits Set - SAE ...Missing: examination

p0171 p0172 p0174 p0175 p2187 p2188 p2189 p2190 - Page 2 - Hyundai ...

www.hyundai-forums.com/.../336641-p0171-p0172-p0174-p0175-p21...

Dec 25, 2014 - 10 posts - ‎3 authors
today one of my colleague who have same car sonata 2007 but with 4 cylinder.for checking ... Drives hyundai accent 2005(sold) Drives Hyundai Sonata 2006 v6 3.3L ...Due to it throwing codes for both rich and lean and after finding a thread searching those.... More on UltraSteel - Magnetic Nut Driver Set.Missing: examination

santa fe won't start, what is most likely wrong? - CarGurus


Jan 04, 2016 | Cars & Trucks

1 Answer

2004 hyndai santa fe: when putting the key in ignition, the alarm goes off and vehicle doesn't start. please advise.


the imobilizer need reset if stil the original you need to take the car to hyunday dealler to reset

Oct 18, 2013 | 2004 Hyundai Santa Fe

1 Answer

Santa fe sputters from idle


There are a few thing that could cause this to happen, the first thing is that you need to make sure the check engine light is not on, if it is or not still have the computer scanned for any codes, the computer is always watching the operation of the engine and if there is a problem it will store a code and turn check engine light on to warn you of the problem, the code will come out as a set of letters and numbers and tell you were the problem is. it will not tell you whats wrong but just the component that is failing and then with some testing the problem can be found.

the sputtering you speak off could be due to a coil that is bad and causing engine to misfire, or even a vacuum leak or spark plug.
There are many auto part stores that will scan the computer for free and give you the codes, start by having the codes read and then write me back with the codes. Here is an example of a code, let say code po301 cyl 1 misfire , came up as one of the codes.

As you can read it tells you that cylinder # 1 is misfiring, then we would check the coil for that cylinder and the sprak plug first.

make sure to get the complete code, good day.

Nov 28, 2012 | 2001 Hyundai Santa Fe

1 Answer

Problem started suddenly two days ago. Engine is 4cylinder - Autozone diagnostic showed codes p0441, p0442, p0446. Replaced spark plug wires and disconnected battery to reset computer. Now - no check...


PO441 ,PO442 codes have to do wit the oxagen sensors, If there is a problem with both of them,Or your cat is pluged up ,The car will not run (Properly)

Nov 11, 2012 | 2004 Hyundai Santa Fe

1 Answer

Piston positions in 2004 hyndai santa fae


I were awakened by a loud explosion that sounded like a tire on an 18 wheeler blew out on the interstae nearby. then within seconds a smaller sxplosion and the 'panic' alarm on our 2008 Syundai Santa Fe started on go off. by the time I reached the window to look out on our driveway the rear drivers side of our 2008 Santa Fe was engulfed in flames, and only 3 feet from our house and parked next to our 2001 GMC 'Jimmy". One of our neighbors was frantically screaming for us to get out of our house and pounding on our front door. The vehicle had not been driven for over 2 days --- it just spontanousely erupted in flames.
WHY? Has anyone ever heard of anything like this happening to a new Santa Fe with less than 2,500 miles on it?

Jul 29, 2012 | 2004 Hyundai Santa Fe

1 Answer

Hyndai Santa Fe code P0172, P0175


fault codes stored in your car lead to check engine light on, you can get a code reader to clear it.elm327 can have a look, maybe can suit for your car.

Jun 29, 2012 | 2006 Hyundai Sonata

2 Answers

Car is trying to start but wont turn over. spark


Have the fuel pressure checked. Fuel pump may have given up.

Jun 17, 2010 | 2004 Hyundai Santa Fe

2 Answers

Where is the fuel filter?in santa fe 2004


FUEL FILTER IS WITH THE IN TANK FUEL PUMP.

Mar 25, 2010 | 2004 Hyundai Santa Fe

1 Answer

I bought a hyndai in feb tucson. i can smell the exhaust


you may have an exhaust or manifold leak somewhere test it at a local shop

Sep 03, 2009 | 2001 Hyundai Santa Fe

Not finding what you are looking for?
2008 Hyundai Santa Fe Logo

248 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...