Question about Cars & Trucks
I am unfamiliar with the exact car but there should be 4 screws under gas door and 2 clamps holding it to the gas tank
Posted on Apr 17, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1995 maxima fuel filler tube
Are you going to get a new one, or a junkyard replacement?
You have to take off the rear left tire. Secure the car with jack stands and chucks. There is a plastic cowl on the wheel-well that covers the filler tube to prevent road damage. Take it off. The filler tube is attached to the gas tank through a rubber connector hose (tube) adapter, secured to the gas tank and to the filler tube by hose clamps. Loosen both clamps.. You should replace the rubber connector, as it has been there for many years, and rubber degrades. Loosen about three or four bolts along the filler tube that attach it to the car body. The top part, by the gas lid, comes off easily, it's just a plastic dam. You have to carefully work it off the (other end) at the rubber hose connector. Once it's out, get the hose connector off the gas tank neck.
With the new filler tube, reverse the process. Getting the hose clamp tight over the gas tank neck is hard. Make sure the clamp is seated properly before tightening.
Posted on Nov 08, 2008
SOURCE: 1995 Chevy Monte Carlo
you need to take the upper and lower steering column covers off, should be 3 screws in bottom, take tilt steering lever out if neccessary, it is a 2 peice cover, take apart, change switch and put back together
Posted on Dec 03, 2008
my 95 Chevy Lumina Seems to have tjis Similar Problem Especially after Driving in 6+ Inches Of Snow. I have Found that I use a Lot Of Trannie Fluid Check it. That Usually will get my speedo working right again, and Make my car Shift Accordingly
Posted on Jan 04, 2009
Look for a bleeder screw at the highest point of the coolant system, it is usually located on the thermostat housing. Once located open screw with engine off and cool, and pour coolant into the coolant resevoir/ radiator until steady stream of coolant starts to come out of bleeder screw.
Posted on Nov 24, 2009
Testimonial: "Good info. There are 2 bleeders. They are located on the coolant hoses. The best way to bleed them is fill up then blled after running 15 minutes."
Tips for a great answer:
Apr 17, 2014 | Cars & Trucks
Jun 14, 2013 | 1997 Chevrolet Monte Carlo
Jan 08, 2011 | 2004 Chevrolet Monte Carlo
Nov 13, 2010 | 1995 Chevrolet Monte Carlo
Aug 07, 2010 | 1999 Chevrolet Monte Carlo
Sep 26, 2009 | 1995 Chevrolet Monte Carlo
May 17, 2009 | 1995 Chevrolet Monte Carlo
Sep 22, 2017 | Ford Cars & Trucks
43 people viewed this question
Usually answered in minutes!