Question about 2002 Dodge Intrepid

1 Answer

Running rough check engine light flashes until engine gets to running temp. Also engine runs rough till then. After it gets to running temp engine runs smooth

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Dodge Master
  • 354 Answers

A blinking or flashing check engine light indicate misfiring. I suggest you check the components of your secondary ignition system especially if it worsens when it's damp.

Posted on Apr 17, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 14036 Answers

SOURCE: runs rough at low speed

take it to auto zone and they will check it for free.

Posted on May 01, 2009

  • 153 Answers

SOURCE: 1994 dodge ram van b250. when warm, starts

Sounds like the fuel pump is going out. Its inside the tank. But first see if the fuel pump is clooged. take it off and see if its plugged. Check fuel pressure if you can. should be 45-55 psi

Posted on Oct 13, 2009

hondakilla
  • 129 Answers

SOURCE: Check engine light , trouble code 34

Your truck is OBD2 compliant take it to a local auto parts store and have them read the code for you they usually do this as a free service, if it doesn't have a obd2 port then your truck is not a 1996 vehicle.

Posted on Apr 04, 2010

  • 31 Answers

SOURCE: code says there is a problem with the camshaft

I also have a 04 intrepid with the 3.5L engine. mine did the same thing. I replaced my cam position sensor. Bought it at autozone for $30 and replaced it myself. It's located in your timing cover in front of the engine under your upper intake. Never had another problem after replacing it.

I hope this helps

Posted on Aug 07, 2010

jturcotte
  • 8273 Answers

SOURCE: my dodge is a 1996 dodge ram 1500 with a 3.9 v6.

intermittent lean condition may be caused by leaking intake manifold gaskets. Get some carb cleaner and start the truck. Open the hood and spray carb cleaner on the intake manifold gaskets. If the engine reacts at all, you have a gasket leak. If you have questions, please let me know.

Posted on Nov 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Check engine light flashing check engine soon smell of gas and not running smouth


Check engine light flashing means there is a bad misfire , it flashes to tell you your damaging your catalytic converter . You need to have it check , you don't won't to have to replace the catalytic converter . Can cost up to $1,000.00 . Flashing Check Engine Light CarMD

Feb 03, 2016 | 2004 Cadillac Deville

1 Answer

Check engine light flashing runs little rough


before you take it to the shop go to an auto parts store and they will scan it for free and tell you the problem

Apr 08, 2014 | GMC Savana Cars & Trucks

1 Answer

2002 dodge intrepid gets to operating temp oil light comes on tep gets high runs rough and dies no ticks runs smooth until it reaches operating temp


put an engine flush in first . run the engine on tick over .till oil is hot then drain it. do an oil and filter change may have a build up of carbon in the engine .the flush should deal with that .use 20/40 oil .

Dec 21, 2013 | 1997 Dodge Intrepid

1 Answer

Runs rough with check engine light flashing


Flashing MIL Lamp on a Ford, is a Class A exhaust
converter damaging Cylinder Misfire

Get your codes ,google them & diagnose the problem
& don't use it until resolved

Mar 28, 2013 | 2000 Mercury Mountaineer

1 Answer

99 3500dodge 5.9L cummings, running very rough when cold, warmed up runs fine.


Hi

The engine temperature sensor is bad. If so, the ECU assumes the engine is warm and it leans out the mixture, but you need a richer mix when cold, so it will run lousy till it actually gets warm.Check your coolant temp sensor. It may be defective and telling the computer that the engine is already warm. The computer is supposed to add extra fuel when cold to "choke" the engine until it reaches operating temp. If the sensor is reading incorrectly the computer may think its warm and not add the extra fuel to keep it running smoothly. Also check the two ground wires connected right next to the thermostat housing for loose or corroded connections. A bad ground here can also lead to running problems. If the sensors test ok have the timing checked.

Pull your diagnostic codes. The codes will tell if the sensor is not right.

Please get back to us if you have further query or else please accept this "particular" solution.

Thanks for contacting fixya.com


Sep 19, 2011 | 1999 Dodge Ram 2500 4WD

1 Answer

Car will start and run till it starts to warm up and then it will run rough and die. I can restart it but it will run for a minute and then die again like its not getting gas. I have changed sending...


unplug coolant tempurature sensor. if it runs better, then the sensor is your problem. a bad coolant sensor adjusts air to fuel mixture, depending on temp. of engine. it will run to rich and not enough of air if bad. it will also run rough at idle. if check engine light is on get it scanned for the problem code.

Aug 10, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

My check engine light is flashing, the car runs rough until I get up to about 30mph and it is running through gas like crazy


Sounds like you have cylinder misfire. Any of the large auto parts stores can run an OBDII check and tell you which cylinder is misfiring (not firing). The engine is running with one cylinder out causing the rough idle. The faster the car goes the less perceptible the misfire is. That is why at 30mph the car seems to run smooth.

Jan 07, 2011 | 1997 Buick LeSabre

1 Answer

Rough running engine at temp


0340 is camshaft position sensor and the other 0325 is the knock sensor. Chances are you need to replace the sensors and good to go.

May 05, 2009 | Nissan Xterra Cars & Trucks

1 Answer

90 f150 5.0 has issues


If your check engine light is on, you will need to have it tested to see what codes have been stored. The light will stay on until it has been tested and codes cleared. Disconneting the battery for five minutes will also reset the light, but if the truck is running rough, you don't want to run it like that. It could cause severe damage to the engine. Best bet is to get it tested and correct the underlying problem before it costs you big bucks. Good Luck 

Jan 05, 2009 | 1990 Ford F150

Not finding what you are looking for?
2002 Dodge Intrepid Logo

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...