Question about Cars & Trucks

1 Answer

My 1991 f150 will not starter have replaced the starter ther starter sylenoid new battery ignition still not start

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 173 Answers

Check your neutral start switch

Posted on Apr 17, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
ManiacZack
  • 14 Answers

SOURCE: location of alternator 1986 ford f150 xlt lariat

Well first have you charged your battery back up, if so then try to by pass the ingintion switch by just connecting the two main post of the colenoid with a piece or wire, this creates a direct wire basically from your battery to your starter, if still no luck you will need a new starter located more to the drivers side close to right under the pedels on the bottom side of the truck.

Posted on Oct 06, 2008

  • 1 Answer

SOURCE: 95 F150 wont crank

the starter should be replaced. The solenoid is kikcing the pinion out but there is no contact being made to turn the starter motor. I have the exact same truck and before i changed the starter used the old starter tap trick. Tap the starter casing with a hammer and it should start turning again. hope this was helpful for you. Good luck.

Posted on Nov 07, 2008

  • 3 Answers

SOURCE: 1991 dodge ram 250 van 318 engine won't start

ALWAYS CHECK THE GROUND ON A DODGE

Posted on Nov 16, 2008

redds55
  • 2620 Answers

SOURCE: My 1990 Ford F250 won't start but has new starter, battery and ignition switch

Have you checked for 12 volts coming in going out of the the starter solenoid switch that is mounted passenger side fenderwell.

Posted on Jan 14, 2012

Testimonial: "No but that is logical; thanks! You can start the truck by 'jumping out' that same solenoid."

tayjoejoe
  • 2186 Answers

SOURCE: 1994 oldsmobile 88 won't start

Yes, the key,ignition, or Theft Deterrent Module is not funtioning properly. You can start changing these out 1 by 1, or bypass the whole system for about the cost of a new key. This link explains and will help you.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Posted on Jun 18, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991 Ford taurus starts when its cold then once it gets warm and you shut it off it wont start until it cools off again


Did you replace the ignition distributor stator? they are the real problem not the TFI ignition module. See part below. You must remove the distributor to replace this part, it would also be a good idea to run a fault code test on the EEC 4 engine control system.
4p1258-mvo5utiinxaozxzewv5notdb-4-0.jpg

Apr 20, 2017 | Ford Cars & Trucks

1 Answer

1991 f150 starts but must hold key on to stay running i turned key on and off atleast 100 times to rid my tank of bad gas also i'am running off my battery


It sounds like you need to replace the ignition starter switch, the symptom you have is an exact fit, most models of Ford where recalled years ago for this problem.. The starter switch is at the base of the steering column under the dash and operated by a rod from the ignition key tumbler. Very cheap and easy to replace.

Nov 08, 2016 | 1991 Ford F150

1 Answer

Santa fe 2007 wont start makes a single click noise


May be ab bad starter solenoid, or corroded/loose connection at starter, or (ground). Could also be a bad ignition switch. Start from the load; the starter. Test for 12V at starter, OK. Connect short wire from starter and touch sylenoid connection..

Nov 09, 2013 | 2003 Hyundai Santa Fe

1 Answer

A buzzing sound under the plintum and wont start sometimes. Or we will be driving down the road and it just quits


The buzzing sound might be the sound of a dead battery or faulty starter. Try charging the battery and putting it back. ----------------------------------------------------------------------------------------
ECU Chip Tuning Tool

Nov 19, 2012 | 1991 Ford F150

1 Answer

1991 ford pickup truck


I recently had a problem with my '91 F150. It had started fine. Then, after I cleaned it some, it died and wouldn't start again. I think the ignition control module got wet on mine. If you are not getting enough fire, you might want to take the ignition control module off the side of the distributor and take it to Autozone/Advance or the like and get it tested. (You can get enough fire to turn the starter and it still not be enough. You'll need to take a plug wire off and see how hot it is when you turn it over.) The ignition control module is held in place by two screws that you can remove with a 7/32 socket if you have one small enough to fit. (Make sure they test it a few times (until it gets hot.) A bad one may test fine at first.) If it tests fine, you might want to buy a coil. For more detail about the ignition control module, see: http://answers.yahoo.com/question/index?qid=20080506033632AAUGhGf I don't know if your starter is turning over or not. If it is not, you might need a starter or solenoid. If you jump the solenoid and the starter turns, you probably need a solenoid. If not, you probably need a new/rebuilt starter (and maybe a solenoid, too.) I hope this helps! Peace and blessings!!!

Aug 03, 2010 | 1991 Ford F150

1 Answer

Got new batterys in it and new sylenoid but still just a dead sound when turn keys on in the 1991 ford f250 diesal what could be wrong with it


It sounds like you need a new starter motor. Really, you should do a starter draw test, but you need an automotive current tester and I'm assuming that would mean towing it to a shop. Probably a good bet and cheaper to just put a starter in it if you don't have a record of it being done for quite awhile.

Jan 17, 2010 | 1991 Ford F250

1 Answer

My 1991 plymouth voyager will not start the battery is good but when i turn the ignition it doesnt do anything what could be ther problem


It may lie with the ignition system but a good chance the starter has failed. If you have the ability you can jump the solenoid to check this. If the starter then engages you know to look else where. Try the starter and move on from there.
I hope this may have helped,
Tom

Oct 14, 2009 | 1991 Plymouth Voyager

1 Answer

Wiring from sylenoid switch out to engine


solenoid wires start at the ignition switch to the solenoid

May 24, 2009 | 1991 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...