Question about 2003 Volkswagen Golf

1 Answer

OIL FILTER SEAL BLOW - 2003 Volkswagen Golf

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Contributor
  • 13 Answers

Is this all info? Oilfilter seal can and will blown if the engine doesn't breeth right, if the camchamberpressure is blocked, this happens. You must check that all the hoses are clear. Sorry about my english, I'm from finland, and I dont' have any translator nearby:)

Posted on Apr 18, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The seal on the oil filter housing is leaking


YOU NEED TO REPLACE OIL FILTER SEAL IF YOU OIL FILTER ON TOP OF ENGINE.IF OIL FILTER ON BOTTOM ENGINE LEAKING YOU HAVE TO REPLACE OIL FILTER WITH NEW OIL SEAL.

Feb 12, 2011 | 1996 Volkswagen Jetta

3 Answers

What causes the oil filter housing to leak - it is above the filter - we replaced the filter but this is on seam about 1/2 inch above the top of the filter


If there is a spacer between the oil filter and the engine block then you would could have a bad seal on it. If its similar to a Honda there will be to hoses going to the spacer. This spacer is called the oil cooler adapter. If this is it. Take oil filter off and the remove the oil cooler nut if there is enough room you won't need to disconnect cooling lines. Pry the Adapter away from the block with screw driver. remove old seal clean surface with clean rag install new seal. Wipe a little oil around the seal just like you would the oil filter. 'Tighten snug, but don't over tighten. Not sure the correct torque for this. Hope this helps you. This similar problem occurred on my 1995 Honda Odyssey.

Jan 29, 2011 | 1996 Volkswagen Cabrio

2 Answers

Chevy Silverado threw all the oil out around the oil filter. Changed the filter, but that wasn't the problem. What could be causing it to lose all the oil?


Take th oil filter off and make sure there is only one gasket sometimes the old one will stick there and the new ones cannot make a good seal

Dec 15, 2010 | Chevrolet 1500 Cars & Trucks

1 Answer

Cylinder 3 misses and has carbon biuld up on plug also looks to have oil on the plug, smell like oil is burning , smokes alot out of tail pipe,oil consumtion is a qt, per 300 miles and it looks like oil is...


Geez!

U got a bad piston rings! U have to pull down the PiSTON to replace the PiSTON RiNGS, oil is getting in ur combustion!

Or

Check also the valve guide oil seal, hope that is the faulty one! 'Cause replacing PiSTON RiNGS will cost a LOT!


Check on that first, Oil in ur air filter means a BLOW BACK gas from ur combustion is pushing the oil into the air filter!

BLOW BACK is a residual combustion air that should have been burned or gone thru the exhaust, but w/ poor seal of ur piston ring, it goes into ur CRANK CASE and into ur EGR system w/ excess oil!

Hope that explains everything!

Dec 02, 2010 | 1987 Toyota MR2

1 Answer

OIL LEAKING SON OVER FILLED


DRAIN OUT EXTRA OIL.PUT THE RIGHT AMOUNT OIL IN.CADILLAC 4.6L ENGINE WITH NEW FILTER HOLDS 7.5 QUARTS. THE CADILLAC 4.9L ENGINE WITH NEW FILTER HOLDS 5.5 QUARTS.TELL SON CHECK THE OIL LEVEL ON THE DIP STICK.DONT GO PAST FULL MARK. TOO MUCH OIL IN ENGINE CAN BLOW FRONT OIL SEAL.CAUSE PAN GASKET LEAKS AND FOUL OUT SPARK PLUGS.

Aug 08, 2010 | 1996 Cadillac DeVille

1 Answer

Oil draining out from engine


It sounds like they did not tighten the oil filter properly. There is a by pass valve in the oil filter housing to allow oil to flow though just in case if the oil filter is plugged up with dirty from lack of oil change. Good luck and hope this help and what was the oil pressure reading on your dash gauge. Over tightening the oil filter can cause the o-ring to leak, as to not having the filter on tight enough.

Jan 11, 2010 | 1999 Chevrolet Tahoe

1 Answer

No oil pressure


Make sure that you are using the correct grade of oil for your car and climate.
Oil pressure warning light ON usually indicates a problem with 'low' engine lubricating oil pressure and is a CRITICAL issue that needs to be fixed before you blow your engine.
Some of the causes:
- Wrong oil type for your car and weather
- Low oil level
- loose oil cap or dip stick seal
- Leaking oil gaskets or engine seals (common in old cars)
- Blocked oil filter
- Faulty oil pump or block internal oil pump filter

Dec 24, 2009 | 1999 Dodge Durango

3 Answers

What is the problem when oil is pouring out above the starter area


Could be the engines rear main seal. Clean the area and trace the source.

Sep 03, 2009 | 2001 Chevrolet Lumina

Not finding what you are looking for?
2003 Volkswagen Golf Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

79186 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...