Question about Mazda MPV

1 Answer

My mazda premacy 2003 lights flashing on and off on the dashboard when driving. The revs are up to 3000 at a speed of 50km/hr. Fuel consumption is very high.

Transmission fluid has been changed once and there has been a slight change in performance

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 37 Answers

If you changed the fluid, the level might be too low. Check level when engine is warm and running

Posted on Apr 28, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Mr Repair
  • 10 Answers

SOURCE: 2003 mazda protege 5 transmission problem

It sounds as if you may have a short in the wire harness, or a bad plug on one of the sensors. This is common. Make sure the sensor connections are clean then use die-electric grease on them where they make contact.

Posted on Jul 09, 2008

Landyman
  • 89 Answers

SOURCE: vw caddy 1.9 sdi r reg does not rev up

Check the turbo pipes for internal splitting , this will block air flowing through to the engine. Also check if a catalitic convertor is fitted , this could be blocked.

Posted on Nov 16, 2008

  • 13 Answers

SOURCE: 1993 mazda mx6 transmission is not slipping, but will not shift into higher gears. Will run at high RPM's and not shift up. Any suggestions on what it might be.. Mechanical, electrical, fluid change,

sounds like a shift solenoid in the trans.

Posted on May 10, 2009

  • 1 Answer

SOURCE: Mazda 626 'HOLD' light after gear box oil seal was replaced

I have the same problem with my car I think its the torque converter clutch but you should visit a diagonestic machine just to find out

Posted on Nov 12, 2009

  • 9 Answers

SOURCE: Airbag warning lights flashing on dashboard of

there are a quite a few problems associated with the airbag light flashing. The light will flash in long and short frequencies, this is a diagnostic code, e.g. two long flashes followed by six short flashes equals code 26, which is clockspring. Other codes are: 46 and 47 connector under seat, 3 power supply etc.

Posted on Dec 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does the driving on overdrive mode cause high fuel consumption, because the transmission use the first three ratios mostly?


driving in over drive mode actually is what gives the economy as the engine rpms will be around 300 less than direct drive . Lower rpms = fuel savings
OD should come in around 60 klm/hr and drop out at around 50 klm/hr. When you are accelerating hold the pedal in a set position and watch the rev counter (rpms ) and each gear change you will see the rpms drop and then build back up as the vehicle speed increases At 100klm/hr the revs should be around 3200 rpms or less but if over ( say 3500 rpms) then may be the OD is not coming in. One way to test a box operation is to find a speed shop with a dynomometer and test the gear selections against loads and engine rpms

Dec 23, 2014 | 2000 Audi A6

1 Answer

Revs seem higher than normal in my 2005 Suzuki Swift Sport (3.3rpm in 5th @ 100km/hr) - is this normal? I also have a really high fuel consumption rate


2 issues,
1: MPG, you failed to say MPG, 15mpg? or 39? is 39 low?
what MPG? you never said it?

2: rpm cruise. (what drive line, A/T M/T ?) what tranny?
first google hit , is this it? this yours?
engine: 1.5-litre 4-cylinder petrol, 75 kW/133 Nm
Transmissions: 5-speed manual, 4-speed automatic, FWD

3300 RPM in 5th and 100km
if you wish to now what is normal, find the final drive ratio, listed in the FSM. Id say this is normal. typical of tiny engines, with low torque.at lower RPMs.

if you have the A/T and IF the trannywere to slip, the TCM will infact throw DTC codes, telling you it did.
IS IT? (scan tools show you this fact as might that glowing CEL lamp on the dash, on driving.

RPM
my 1.6L spins 3000 RPM , at below tranny options valve counts.
54/59mph (104km/hr = 59) 5sp MT.
64.6 4sp A/T (goes fastest due to more aggressive OD + axle ratio is lower.)
56/.53 2sp A/T
see how drive line effects RPM? so will your cars options.

Oct 17, 2013 | 2005 Suzuki Swift

1 Answer

Mazda 2 (2004) central locking and alarm fault. My


how can i find central locking in mazda premacy tell me plsss

Oct 01, 2013 | Mazda Cars & Trucks

1 Answer

Location of mazda premacy 02 petrol fuel filter


What causes the pump not to run when turning on the ignition & click sound of relay then no spark on a Mazda premacy?

Nov 16, 2012 | Mazda MPV Cars & Trucks

1 Answer

Diesel mazda premacy not revving enough to drive


Check the condition of the following:

1) Air filter
2) Fuel filter

Nov 07, 2012 | Cars & Trucks

1 Answer

Changed thermostat,relay,tophose everything,radiator switch,.still the engine gets heated if we run the car above 50km/hr speed.It is normal when we drive inside 50km/hr.Radiator fan also not rotating.wht...


Sounds like your fan belt is glazed or loose. At higher speeds the belt slips over waterpump and doesn't drive pump fast enough to circulate coolant. That would be first thing I would check...
Other possibilities: waterpump, blocked heater core, fan clutch.

Mar 12, 2011 | Ford Escort Cars & Trucks

3 Answers

Airbag warning lights flashing on dashboard of mazda premacy 52 reg can I reset to clear these lights myself?


there are a quite a few problems associated with the airbag light flashing. The light will flash in long and short frequencies, this is a diagnostic code, e.g. two long flashes followed by six short flashes equals code 26, which is clockspring. Other codes are: 46 and 47 connector under seat, 3 power supply etc.

Nov 17, 2009 | 2002 Mazda MPV

2 Answers

Mazda 626 'HOLD' light after gear box oil seal was replaced


I have the same problem with my car I think its the torque converter clutch but you should visit a diagonestic machine just to find out

Dec 06, 2008 | 1998 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...