Question about 1998 GMC Jimmy

Open Question

How do you change the oil pump on a 1998 GMC Jimmy?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bryant329
  • 125 Answers

SOURCE: TPS in a 1998 GMC Jimmy

the tps is ususally at the side of the throttle body opposite where the throttle cable / tv cable mount.
sometimes it won't start, run, or run erratically. there are ways of testing this unit (by output voltage) before you commit to buying a new one. to test it you will need a dvom (digital volt ohm meter).

just a note: straight from the book... "a broken or loose tps can cause intermitten burst of fuel from the injector and an unstable idle because the ecm thinks the throttle is moving."

Posted on Sep 22, 2008

Ad
psds4
  • 293 Answers

SOURCE: 1998 GMC Jimmy Vortec V6 4.3L 4WD

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800bfc68
hope this helps

Posted on Oct 17, 2008

  • 45 Answers

SOURCE: how do i bypass security on 98 gmc jimmy 4.3

Hi: Sounds to me like you tried to start the vehicle with something disconnected in the security system. If this is the case the solution is simple. Put key in ignition and turn to the on position, leave on for EXACTLY 30 minutes... then take key out, wait 5 minutes then start vehicle. Hope this helps... please rate suggestion... ty

Posted on May 21, 2009

  • 468 Answers

SOURCE: 1999 gmc jimmy w 4.3 v6. cannot find oil filter

look under the front of your blazer, just below the bumper, and you will see a little access door in the plastic guard. Open this door, and you will find your oil filter.

Posted on Dec 01, 2009

  • 75 Answers

SOURCE: replace water pump on 1997 gmc jimmy 4.3 litre

there are four nuts that you must remove at the front of the pulley between the fan. remove fan, fan shroud,loosen accessory belts. remove water pump pulley and the pump bolts will be exposed. check belts for replacement while you have them loose. reverse procedure to install.

Posted on Apr 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i remove oil pan for 1998 gmc jimmy 4.3?


You will need an engine lift remove engine mount bolts lift engine high enough to remove pan,or remove transmission

Aug 31, 2014 | 1998 GMC Jimmy

1 Answer

1998 gmc jimmy changed fuel filter fuel pump cranks but will not start


may be you should make a diagnostic and you can do it in a garage but if you want to do it by yourself you could buy a diagnostic tool here: spobd2.com

Jan 11, 2013 | 1998 GMC Jimmy

1 Answer

1998 gmc jimmy fuel pump


did you change connector at fuel pump?

Dec 12, 2012 | 1998 GMC Jimmy

2 Answers

I have a 4WD 1998 GMC Jimmy 4.3L Vortec V6 and it started running hot then it shut off and wouldn't start back up... do you think there would be any way to fix without replacing the whole engine


IS THEIR WATER IN THE OIL? CHECK THE PLUGS TO SEE IF THEIR WET.YOU MIGHT PUT SOME PLUGS IN IT IF WET TO SEE IF IT WILL RUN.THEN PUT SOME HEADGASKETS ON IT.BUT IN REALITY NEW MOTOR WOULD BE BEST.

Aug 26, 2011 | 1998 GMC Jimmy

1 Answer

How to release fuel system pressure 1998 gmc jimmy to change fuel pump


If you have a schrader valve on the engine,use that,
if not, pull the ignition fuse & crank the engine

Jun 27, 2011 | 1998 GMC Jimmy

2 Answers

No fuel delivery to eng., no voltage spurratic


Oil pressure switch activates the supply pump. Replace the oil pressure switch.. New & Need good rating please.

Jul 31, 2010 | 1998 GMC Jimmy

1 Answer

1998 Jimmy: How do I replace the water pump to my 1998 GMC Jim...


You will have to take the fan and fan clutch off to get to the water pump. It is best to go to oriellys and put a deposit on the fan removal tool it will be easier on you. Than there is only four bolt holding the water on.

May 16, 2010 | 1998 GMC Jimmy

3 Answers

My 1998 gmc jimmy transmission is not shifting right. i just had the fluid changed it was black looking. after changing the fluid it shifted ok at first but now the fluid is starting to get dark looking...


I would try changing the fluid and filter again. Sounds to me like there is a lot of crud built up in it and another change would probably do the trick. It probably wouldn't hurt to add a bottle of Lucas Trans Fluid at the same time. It will help extend the life of your transmission. Black fluid would likely be clutch material that wears off over time.
If this doesn't work you are likely in the market for another trans. Hope this helps.

Nov 28, 2009 | 1998 GMC Jimmy

Not finding what you are looking for?
1998 GMC Jimmy Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...