Question about 1993 Plymouth Colt Vista

Open Question

Start problem new battery good connection ok where is starter relay located?

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: where is the starter relay located?

starter relay on 94 regal

Posted on May 09, 2010

  • 2976 Answers

SOURCE: It wont start battery is good. i was told to hit

It's at the back of the engine.
If you don't know what it is, don't hit it with a hammer, take it to a shop and have it pulled off and cleaned. Sometimes, dirt and grit loads onto the shaft that the bendix gear slides on.

Posted on Jun 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont vehicle turn over


Is the anti-theft light lit ? Is the starter relay good ? Do you know what a relay is ? Are the battery cables good ? I would start will the starter relay circuit's if the anti-theft light is not lit.! The starter relay along with the starter relay diode is located in the battery junction box in the engine compartment. The relay is K-22 . If you pull out the relay an look on the bottom of the relay you should see four sets of numbers 30,87 an 85 ,86 . If you take a jumper wire (12-14 gage ) an jump pins 30 an 87 if the battery cables & connections are good the starter will crank . Pin's 85 &86 are the control side of the relay . One of these comes from the ignition switch when is start position an the other goes through the transmission range sensor (park neutral switch) To ground or the PCM if yours has a V-8 . Now if when you jump pins 30 & 87 an nothing happens you have bad connections or the battery cable is bad . You can go on youtube an check out videos on voltage drop testing the starter circuit .

May 25, 2016 | 2000 Ford Contour

1 Answer

Where is the relay location at ?


A Simple Preliminary Car Starting Procedure
If your car won't start, try this procedure:
  • Check the battery cable connections:
Make sure the positive cable, makes a good connection at the battery and at the starter. Make sure the negative cable makes a good ground connection at the battery and (preferably) at the engine.
  • Check the battery the simple way, like this:
Turn on the headlights, then try to start the car.If the headlights do not dim or go out, then the battery is likely ok.
  • Check the starter and solenoid:
If the wiring looks ok, then look at the starter solenoid for a good connection, and proper voltage at the starter(10 volts minimum while cranking).
If the starter spins and no crank, the problem is most likely the Solenoid's bendix gear is stuck.
Have someone hit (not too hard) the starter while you try to start the car. This usually works by dislodging a stuck bendix gear.

May 16, 2014 | 2008 Dodge Ram Pickup 2500

2 Answers

Car wont start after replaceing batterty


The most common cause of a non-starting car is the battery. It is either weak, (low voltage) dead, (zero voltage) or has bad connections. (corroded or loose) I will assume you have a fully charged battery with good connections. (both to battery and starter relay) Just becaue its new, don't mean its good or fully charged.

If you remove the starter switch lead (small wire) from the starter relay and apply +12v from the battery to its respective prong or lead on the relay, and your starter cranks, your starter switch is faulty. (not to be confused with your key switch). If you jump the two large wires together on the relay and it cranks, then the relay is faulty. If you jump the two large wires together and nothing happens, then starter is faulty, or wires to starter are loose or broken. Picture of starter switch prong on the relay is pictured. NOTE: sparks are to be expected, so don't be too scared.

Dec 17, 2013 | 1997 Toyota Camry

2 Answers

1991 toyota truck relay clicks no starts


check battery cable connections. Dirty/corroded wil cause that condition. Headlights bright?
try starter with headlights on.If clicks and they dim slightly,have a friend TAP the starter with the key in the START position.
USE a long length of re bar or metal rod. Tap on the starter motor,like a pool cue. If the starter cranks on the first "tap",the starter should be replaced.
There are brushes inside the electric starter motor and when they get burned/worn,a slight tap jars the starter motor brushes just enough to make good contact.

Mar 03, 2013 | 1991 Toyota Pickup

3 Answers

2001 GMC Sonoma. SLS 6 Cyl 4 WD 4.3 Vortec. I turn the key on and nothing happens. My dash lights up, all lights come on, fuel pump runs, starter relay clicks, Still nothing. I replaced the starter,...


Tilt the steering wheel down all the way and see if it starts, if it does then there is a main power wire loose in the steering columb. Thats all which comes to my mind at this time.

Sep 16, 2011 | 2001 GMC Sonoma Extended Cab

2 Answers

93 Honda Accord LX; no spark; will not start; has great fuel pressure; new distributor; new coil; voltage 11.8 into the coil but no spark???? any solutions?


Try removing the ignition module, usually located right under the coil pack, and having it tested at Auto Zone or Advance Auto Parts.

Jun 04, 2011 | 1993 Honda Accord

1 Answer

I have a 1998 4 X Tahoe. When I turn the switch on, clicking sounds under dash and then nothing. Battery seems strong, checked connections, all good. Could it be a starter relay? Thanks so much!!! Ed


an easy way too see if its the battery is to turn the headlights on, and try to start it, if the lights dim the battery is to low, if the battery checks ok, then it sounds like the starter solenoid located on the starter it self, a new starter and solenoid should be around $100 and take about 30 min. to install

Sep 27, 2009 | 1998 Chevrolet Tahoe

2 Answers

2002 toyota camry will not start , could it be the starter relay


if you don't even hear the starter click, it's the starter, relay, or battery (turn your headlights on and try to start. if the lights dim a lot, get a new battery). if it clicks but doesn't spin, battery or starter. if it turns over but doesn't start, fuel or spark problem.

Aug 02, 2009 | 2002 Toyota Camry

Not finding what you are looking for?
1993 Plymouth Colt Vista Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...