Question about 2005 Subaru Outback

Open Question

2005 Subaru outback vibrates when pushing gas pedal

Vibrates while accelerating

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
mas66
  • 104 Answers

SOURCE: Subaru Engine Vibration

I'd suspect a vacuum leak in the inlet manifold, check to see if any vacuum lines might have fallen off. This can cause a lean misfire at idle, but often it's not enough of a leak to make it lean enough to misfire at higher rpm. If a leak is not obvious, check if it is a leak by buying a can of engine start (or even CRC will do) and spray it all around the inlet manifold. If the idle smooths out while you're spraying then then goes rough again, it is a leak. By spraying in specific areas you can narrow down the area of the manifold or gasket that is leaking.

Hope this helps.

Posted on Oct 26, 2008

Ad
  • 1 Answer

SOURCE: 2003 subaru outback engine vibration in gear

Did you recently replace the axles on the vehicle? This problem commonly occurs in Subarus when you replace the axles with non-OEM parts. The only fix seems to be to swap out the axles for OEM parts. Search the forums at subaruoutback.org for many stories of the same condition and some theories on why non-OEM axles cause the problem.

Posted on Jan 06, 2009

mcgyver468
  • 710 Answers

SOURCE: Cause of noise in front differential of 1997 Subaru Legacy Outback.

there is a plug on the shaft-side of the differential. Using a ratchet remove the plug and with the engine OFF, stick your finger inside the hole and you should get fluid just below the threads of where the plug goes in.

Posted on Apr 24, 2009

blueextc3221
  • 15935 Answers

SOURCE: needdrive belt diagram for Subaru outback 3.0

8c0dd6e.gif
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Posted on May 23, 2009

  • 25 Answers

SOURCE: 2005 subaru outback cabin air filter install

Yes the o5 outback has a cabin air filter and it is located behind the glove box. You have to remove the glove box, once you get it out of the way you will need to remove the 4 metal clips that hold it in place and make sure you put the filters in with the arrows pointing in the right direction for air flow. Other wise you will have restriction through the vents

Posted on Jun 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2015 subaru outback 3.6 r makes a clicking sound when I floor the acceleration and it clicks while accelerating.


2011 3.6R Back Seat or Door Rattle / Click Sound - Subaru Outback ...

www.subaruoutback.org > ... > Models > Gen 4: 2010-2014
Dec 3, 2011 - 2011 3.6R Back Seat or Door Rattle / Click Sound ... The latch can bang into the plastic cover making a rattle sound. See More is offline. Clicking sound on stopped car with brake pedal
Oct 25, 2015
Yet another clicking sound. But in console and sounds like a relay ...
Jan 1, 2011
Clicking Sound After Engine Turned Off - Subaru Outback ...
May 30, 2010
Engine ticking sound? - Subaru Outback
Apr 4, 2010
More results from www.subaruoutback.org

2013 Subaru Outback Shifter makes clicking sound at low ...

? 0:07
www.youtube.com/watch?v=AUAKNhxKWTM
Jan 8, 2015 - Uploaded by Eric Seeger
I noticed this sound occurs during low speed stop and go driving. This video was ... 2013 Subaru Outback Shifter makes clicking sound at low speed braking. ... 2015 Subaru Legacy Challenges the Roadkill Project Cars! ... 2013 Subaru outback 3.6R up hill in snow - Duration: 1:47. by davidlcb 13,610 views.

Nov 13, 2015 | Subaru Cars & Trucks

1 Answer

Car vibrates when accelerating, engine light flashing


engine light flashing means a problem needs immediate attention ----have the vehicle scanned most auto stores offer this service for free more than likely the viberation is what is setting off code

Oct 05, 2015 | Cars & Trucks

1 Answer

Vibration in steering wheel that will disappear after slowing down and then accelerating in 2002 Subaru outback


Drive Line Universial Joint
Belt Broke in a Tire

Make sure your Tire Pressure is correct

Apr 10, 2013 | 2002 Subaru Outback

1 Answer

I am burning oil alot (2006 outback 2.5) needs a quart within less than 3 wks (never see any oil leaks under car). With accelaration car also vibrates in gas pedal, seat and wheel -idoling is rougher than...


Trouble with modern day synthetic oil is that it evapourates very quickly, check to see what subaru say in the driver handbook about it, they should give you guidelines on how much oil the car should be using. Wouldn't think this was causing your vibration fault. Check gearbox and engine mounts,they may look ok but the rubber on them may be weak. Also check your anti-roll bar bushes.Good Luck.

Mar 10, 2011 | 2006 Subaru Outback

1 Answer

97 subaru legacy outback 2.5 vibration only at idle in gear


I would suspect a mount. Either motor or trans. Also check lateral mount on top of motor to firewall. Good luck and have a great day.

Feb 10, 2010 | 1997 Subaru Legacy

2 Answers

Gas pedal on 2005 subaru forester got stuck in a


No there has not been complaint's like with the Toyota's. Toyota is involved with Subaru on a few thing's , But toyota uses Subaru technology not the other way around. And the accelerator style levers are different from Subaru's. Sorry to hear about your accident. Have a great day.

Jan 31, 2010 | 2005 Subaru Forester

1 Answer

On my 2005 subaru legacy outback 2.5l replaced passenger side cv axle. now while driving the vehicle i come to a stop light or stop sign foot on brake pedal engine makes cavitating noise and feel the...


If I understand you correctly, you feel a vibration it the brake pedal when you apply the brakes. Is that correct?
Have your brake rotors re surfaced; they are warped.

"engine makes cavitating noise" ....what does this mean?

Apr 21, 2009 | 2005 Subaru Outback

1 Answer

2003 subaru outback engine vibration in gear


Did you recently replace the axles on the vehicle? This problem commonly occurs in Subarus when you replace the axles with non-OEM parts. The only fix seems to be to swap out the axles for OEM parts. Search the forums at subaruoutback.org for many stories of the same condition and some theories on why non-OEM axles cause the problem.

Dec 19, 2008 | 2002 Subaru Outback

1 Answer

Vibration when accelerating


You may need to have tyres balanced and wheel alignment done.

Dec 14, 2008 | 2005 Toyota Tacoma

Not finding what you are looking for?
2005 Subaru Outback Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...