Question about BMW X3 Series

Open Question


Posted by Anonymous on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 6784 Answers

SOURCE: inside ac actuator plastic gear:where can I buy this?

Unfortunately, you will not be able to just purchase the affected gear in this case. you will only have access to the entire Actuator. There are no parts that can be purchased separately at this time.

Posted on May 31, 2009

  • 318 Answers

SOURCE: Have a BMW 1993 318i low on gearbox oil filled it as the trans light was on and abs and gearbox was slipping went really good then after 20 min driving light came back on gear box started to slip

need to find where the oil is going. I take it for granted you sre using the correct transmission fluid Dexron 11

Posted on Nov 28, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

E53 X5 will not go in gear

failed electronic stability control module.sits behind your gear stick.take it to a dealer to check the codes they can check that part first. as two other things can go wrong in your gear box .but the codes will check that.

Dec 18, 2013 | BMW X5 Cars & Trucks

1 Answer

Click sound when shifting gear and parking

The clicking noise could be related to the bigger problem with the abs/vsc actuator, this is a kind of common problem on the prius models, the actuator should be replaced, this is a very expensive part (around $2000) for the part only, while the warning light is on the traction control and abs are disabled, it will still brake normally.

Jul 22, 2013 | 2007 Toyota Prius 1.5

1 Answer

Bmw 523i 1999 model asc light on and stays on when driving ABS working normally

The fact that the ABS is OK means that the wheel speed sensors are OK. The sensors are the part of the system that get the most abuse, so it is good to eliminate them as suspects.
On a 1999, I think that you have a mechanical (cable-driven) throttle rather than drive-by-wire throttle. If so, the ASC has its own throttle just outboard of the regular throttle. If you don't see it, follow the air tube up from the air filter to the intake manifold. The throttle(s) are attached to the center of the intake manifold at the end of that air tube..
If your ASC has its own throttle, that means that you have an actuator and a little throttle cable running from the actuator to the ASC throttle. Since that is a moving part, it is subject to wear, dirt, and corrosion that interfere with motion. That makes this system the second suspect after wheel sensors. Check that cable for fraying and a full range of motion as it pulls the lever on its throttle. Unplug the control wire to the actuator and make sure that the connections are clean and tight.
I recently had an ASC light that turned out to be a hose clamp that was installed improperly and was interfering with the motion of the throttle arm on the ASC throttle.

Sep 22, 2011 | 2001 BMW 5 Series

1 Answer

Abs light is on trany strock on secound gear

If the second gear problem happened just as the ABS lamp came on.....Car is in Limp Mode.

ABS system has set likely a code about" Brake system failure..... although 3rd gear is usual default.

You must scan for codes and remedy the fault/s.

Aug 22, 2011 | 2008 BMW 528i Sedan

1 Answer

Why does my bmw 1997 318i abs light stay on all

a multitude of potential problems. Probably a bad abs unit or control box $850.00 Could be a sensor at the wheel---dirty or just quit working.

Either way.....lots of money.

Oct 30, 2009 | 1997 BMW 318

1 Answer

ABS and anti skid tracking control lights stay on in my BMW 523i

Unfortunately there are several possibilities that are common to causing the light to come on. I would suggest taking the car in to a dealer and having them read out the fault memory. Such possibilities are a failed speed sensor, a binding DSC/ACS actuator cable, or faulty DCS/ASC control unit. If you know how, you can disconnect the speed sensors, and check for voltage output across the the terminals inside the connector going to the speed sensor while rotating the wheel. A dealer should charge you about an 1hour fee to check out your system. Due to the cost of parts involved, I would recommend having it checked before just guessing.

Mar 15, 2009 | 1998 BMW 5 Series

1 Answer

Removing and fitting a new gear knob bmw e46 318i man trans

Hi joserosa if this is a manual gearbox you just have to grip the gear knob and pull upwards until the gear knob is removed, the same principle is applied for a auto box but hold in the release button while removing, regards Mark.

Jan 25, 2009 | 2001 BMW 325

1 Answer

Dear Sir , I have bought a used BMW module 728 , year of production is 1997,My two questions are :1- I have an ABS light problem and all fuses are ok so how could I solve this problem , 2- How can I...

I am not sure you can change the screen language, call BMW customer support. As far as the ABS light the 1st thing to do is run a ABS trouble code test on the ABS system module/computer, a dealer will have to do this, as long as the light is on the AHBS is dis-abled.

Dec 01, 2008 | 2001 BMW 5 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers


Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides