Question about 2014 Mercedes-Benz E-Class

Open Question

Mercedes e220 CID

Soft top will not open and message is received which says "close boot separator"

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1619 Answers

SOURCE: mercedes e220, horn, heater fan and electric

Horn and heater may be fuse related. The headrests have nothing to do with fuses. The switch is bad or going that way for the seat or the motors for the headrests are out.

The horn fuse spin it, or replace as corrosion from aluminum fuses cause problems. I suggest replacing them all with new copper barrel fuses. The blower motor fan is a strip fuse on the driver side strut mount in a tootsie roll sized case.

Posted on Apr 15, 2010

  • 165 Answers

SOURCE: i have mercedes benz E220 1995 AM LIVING IN

up what level it reaches ?

Posted on Apr 17, 2010

  • 6826 Answers

SOURCE: year of manifactured for the Mercedes Benz E220 CDI, Chassis

Must be a rather new car because the e220 cdi is listed as a first drive on the 2010 copyrighted site that I saw:

Posted on Jul 08, 2010

  • 67 Answers

SOURCE: Mercedes e220 2008 (57 reg) reset service warning

do you have a standard key or a smart key?

Posted on Jul 08, 2010

  • 34 Answers

SOURCE: Hi there, I have a Mercedes

Maybe you can find your soltion here

When you turn the key manually you will have to lift up on the boot it may be heavy. Hope this helps.

Posted on Jan 06, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1996 SL320. When trying to raise soft top, why does the light blink?

The light flashes to indicate there is a fault in the operating sequence. The soft top control module has set sequence order for the latches and microswitches to open and close in. When one of the microswitches doesn't send the signal the soft top control module will seize top operation and flash the soft top switch light to indicate a malfunction.

Dec 27, 2015 | Mercedes-Benz Cars & Trucks

1 Answer


I had the understanding that using the key in the lock would reset eveything either door or boot

Nov 24, 2013 | 1996 Mercedes-Benz E-Class

1 Answer

I have a Mercedes E220 CDI, I can not open the boot by the remote control or the internal button and I locked the key inside the boot ... Please help

You need the key to operate the boot from inside the car. Do you have a spare key somewhere? Do you seats fold down? There must be a way to find the wires that activate the boot from the boot switch in the car. Maybe you can apply power directly to those wires to operate the boot?

Sep 13, 2013 | Cars & Trucks

1 Answer

I have mercedes benz E220 cdi avantgrade,i havent been driving my car about one week.this morning when i start engine cardidnt start, on dash board tis apeared ,ESP not avallabel see owners

The ESP message came on because the battery went low causing your steering angle sensor to lose syncronization. There are 2 different ways to resync the steering angle sensor. One way is turning the steering wheel from lock to lock and the 2nd way generally involves just driving the car around like normal and it will resync on its own. You will most likely just have to drive the car around until it resyncs on its own because of warning message your getting. When it says see owners its because in the owners manual there is a description on what the message means and what to do to fix it. Basically it just tells you to drive the car. Hope this helped you out.

Feb 20, 2012 | Mercedes-Benz E320 Cars & Trucks

1 Answer

I left top half way up while cleaning rear galass. now top will not go down. got trunk working & roll bars go up and down. when i unlatch the top i hear nothing. normally you can tell the top is...

first try with disconnect battery ground cable, disconnect cable an leave 2 minute then fix it back and have a look, if not work now it's position uneven, you must close the roof slowly by hand up to locking position after that first operate the switch for closing and let it lock properly then till lock the boot lid to the right position with two flaps then switch off ignition let it stay 5 minute without doing any thing and, after that open the roof, if not work in this way you must fix Mercedes diagnose tool in to the car for manual activation through diagnose tool, and also would like to ask you to check the boot separation flap again is it in the right position if it not close properly it won't work,

Nov 15, 2010 | Mercedes-Benz CLK-Class Cars & Trucks

1 Answer

Hi I have a 2000 mercedes benz 320clk. Today for the first time the top wont go down and the red light is blinking on the button. Any ideas why???

if the light keep blinking it meat all the status for operating not complete could be one thing wrong, first need to be check separating lid in boot if it's properly close and also try 3-4 time that because some time the boot separation lid recognizing switch is not functioning, second step have a look any oil leaking on your roof if it's leaking you can see wet mark on your hood trim, and also have a look too small flaps at both coner between roof and front end of boot lid if the flaps are not close properly do it by hand and try, this is the only thing you can check, most common problems are oil leaking from hydraulic cylinders and boot separation contact switch or corner flaps, if not work any thing you have to get your car in to the Mercedes workshop for diagnose, is this information helped you?

Oct 26, 2010 | 2000 Mercedes-Benz CLK

1 Answer

Hello, where its located the soft top relay in my clk 320 2001. Not opening THANKS!!!!!!!!!! Leo

is your soft top not working it's not the faulty relay, it's control by electronic control unit, it's call soft top control unit, so first do one thing, open boot and have a look, there are one separation lid which is winding like cover, you must have close your boot separation lid buy pulling it out and hang it on hook which is locate both side back in boot, there are two hooks for hookup the separation roller lid,you pull it out and hookup it on two hooks, and close boot then operate roof if still roof not working it's need to be diagnose because there are many sensors and switches are fitted in this system if one switch or sensor not work your roof will not longer be opening and also there are any hydraulic oil leaking or lack of oil in the pump, it will not work, so in this case you must drive your car to the authorized Mercedes workshop who have the right diagnose tool knowledge for this particular car,

Oct 22, 2010 | 2000 Mercedes-Benz CLK

2 Answers

Year of manifactured for the Mercedes Benz E220 CDI, Chassis

Must be a rather new car because the e220 cdi is listed as a first drive on the 2010 copyrighted site that I saw:

Jul 08, 2010 | Mercedes-Benz E-Class Cars & Trucks

Not finding what you are looking for?
2014 Mercedes-Benz E-Class Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

75822 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides