Question about 2008 Peugeot 207 GTi

Open Question

Courtesy light bulb change - 2008 Peugeot 207 GTi

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My interior light won't come on in my 1999 Buick Lesabre. I have checked the bulb & the fuse. Can anyone help me with this problem? Any ideas are sincerely appreciated.


Courtesy Lights
The courtesy lights come on under the following conditions:
?€¢
Any door is opened.


?€¢
The interior lamp switch is in the ON position.


?€¢
The keyless entry transmitter unlocks the doors (illuminated entry).

When the key is removed from the ignition switch with all of the doors closed, the courtesy lights light for approximately 25 seconds before fading out.
Battery positive voltage (B+) is applied at all times through the IP fuse block CTSY LP/PWR MIR fuse 6A via CKT 640 (ORN) through the body control module (MALL) to the courtesy lights via CKT 1732 (ORN). The MALL provides a ground through CKT 156 (WHT) for the courtesy lights under the following conditions:
?€¢
The MALL receives an input from a door being opened.


?€¢
The MALL receives an input from the interior lamp being turned ON.


?€¢
The MALL receives an input from the doors being unlocked using the keyless entry transmitter.

The courtesy lamps then light.
When the courtesy lights are activated by opening and closing a door, the courtesy lights will remain on for approximately 25 seconds before fading out after all of the doors are closed. If the ignition switch is turned to START or RUN within the 25 seconds, the lights immediately begin to fade out. If a door is left open, the MALL removes battery positive voltage (B+) to the courtesy lights after 10 minutes. When the courtesy lights are activated by the interior lamp switch, the lights remain on as long as the interior lamp switch is in the ON position. When the courtesy lights are activated by unlocking the doors using the keyless entry transmitter, the lights remain on for approximately 40 seconds. If the doors are locked using the keyless entry transmitter within the 40 seconds, the lights immediately begin to fade out.
Body Control Module (MALL) Diagnostic Mode
For a detailed explanation of the MALL module diagnostic mode, refer to Body Control Module Cell 51.
What interior light ? Dome , courtesy lights etc....They don't work with switch, keyless entry , door opening ?
What

Dec 03, 2015 | Buick Cars & Trucks

1 Answer

Interior bulb replacement Smart Car


You should remove the covers , front panel so that you would have access to the light , then you can replace

Apr 14, 2013 | Smart Cars & Trucks

1 Answer

How to change the courtesy light in my 2003 lincoln navigator


You can carefully remove the cover with a small flat screwdriver to get to burned out bulb.

Jan 18, 2013 | 2003 Lincoln Navigator

1 Answer

Courtesy lights not working


Check to see if the fuse for the lights are burned out or the bulb in the light it self has burned out.

Dec 13, 2012 | 2006 Hyundai Santa Fe

1 Answer

What bulb is the turn signal bulb on a 2002 oldsmobile alero


On 2002 Oldsmobile Alero Car Light Bulb Size, check this list:

Low Beam Headlight Bulb Size: 9006 or 9006 HID Upgrade KitHigh Beam Headlight Bulb Size: 9005 or 9005 HID Upgrade KitParking Light Bulb Size: 3157NALLFront Turn Signal Light Bulb Size: 3157NALLRear Turn Signal Light Bulb Size: 3157LLTail Light Bulb Size: 3157LLStop Light Bulb Size: 3157LLHigh Mount Stop Light Bulb Size: 921Fog/Driving Light Bulb Size: 894License Plate Light Bulb Size: 194Back Up Light Bulb Size: 921Front Side Marker Light Bulb Size: 194Rear Side Marker Light Bulb Size: 2825Glove Box Light Bulb Size: 194Map Light Bulb Size: 212-2Dome Light Bulb Size: 212-2 or 561Step/Courtesy Light Bulb Size: 168 or 73Trunk/Cargo Area Light Bulb Size: 211-2

Hope helps.

Apr 25, 2012 | 2002 Oldsmobile Alero

1 Answer

When changing a bulb in the front passenger side door (courtesy light bulb), It somehow arced (touched positive to ground) and it shorted, now my dome lighs, my cargo lights (exterior) and all of my...


I would double check all of the fuses,under the dash and hood. Sounds like you might have missed 1. If ALL of the fuses are good and you do not find any broken/burnt wires,,,, I am afraid you took out the GEM module. That will be costly.

Jul 30, 2009 | Ford F-150 Cars & Trucks

1 Answer

Change the bulb in the courtesy reading lamp?


if this is the light you push up on to turn on and off you use a small screwdriver and pry it down. it is held by 2 plastic pins that snap into holes.

Jun 25, 2009 | Dodge Caravan Cars & Trucks

1 Answer

Rear interior light and door courtesy lights not working- Jaguar


take off the cover and replace them. if you have a volt/ohm meter you can put if on the car side and make sure you have voltage and the ohm meter on the buldb should give a 1 rating if its good. it would be the cheapest and easiest to just get a new bulb and see if it works then start checking fuses if its not the bulb.

Mar 15, 2009 | 2004 Jaguar X-Type

1 Answer

Mazda 1999 2500 pick up- courtesy light problem


A:

Shoot a bunch of WD40 into the keyway (both doors), let soak, come back in five minues. Put your doom light bulbs back in and test. In case that doesn't work, take your doom light bulbs out forever. The light activator is deep inside the door (some magent thing is as close as I ever came to an answer?), good luck w/ finding it. I took the entire door panel off to replace a driver's side mirror and couldn't find it with two hands, a flashlight and a Chilton's manuel.

Q:
How do I get my check engine light off? I changed both parts on both codes from three different AutoZones. The EGR valve and EGR value sensor and a new hose from the manifold to the catalytic converter. Only thing I can think is to look for a vacuum leak, change the oil, rotate the tires, get new struts and shocks, a front end alignment, get my heat shield welded back into place, get a full tune up, change the transmission fluid, and two new oxygen sensors and these should hold her for quite a while. Rear brakes don't seem to be grabbing correctly, it feels uneven. Anti-lock brakes don't come on. I also replaced the speedsensor this time last year. And need a new windshield. How much will all this cost?

Mar 11, 2009 | 1999 Mazda Pickup

Not finding what you are looking for?
2008 Peugeot 207 GTi Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...