Question about 2002 Dodge Stratus
Not sure if related, but the A/C blenders doors are not working either. I have replaced the main switches (twice) and the Mode door actuator and the blender door actuator. I have also checked the door levers and they are working fine. Still ..not working.
There is more than one fuse for the radio. I know that one controls the power and there is also one for the memory and sometimes they have a third fuse as well. Take a look in your owners manual for the location of the fuses. \hope this helps
Posted on Apr 17, 2014
Testimonial: "Thanks for your response, but all fuses were checked and are good."
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2001 dodge stratus radio
i have a similar problem with my stratus except mine is a 95'. I haven't fully figured the problem out but i have been told to check all of the grounded wires you have hooked to your car.
Posted on Aug 15, 2008
bad radio i have seen it before have radio or change radio might chrck before you change and be sure the wires are pluged in good
Posted on Feb 17, 2009
You can buy adaptor plugs that allow a simple hook up at most car stereo places. However, when you increase the power going to the speakers you also have to replace the speakers to handle the higher power or you'll toast them.
Posted on Apr 01, 2009
sorry not sure the 12v prob will help this swtich works on 5v off 3v unlock 1v lock single wire lock/unlock logic signals
I found wiring diagrams at
it is 2004 but use the wiring diagrams to test the wires
(most likely to fail where they flex)
because it is using logic gates disconnect the plug at each end of the wire you are testing or the damn thing will find a few diffrent ways to trick you.
Posted on Apr 21, 2009
Did you try adjusting the dimmer for your dash lights? Did it feel different - like the knob was no longer connected?? If so, try pressing the knob to re-align it up to the threading to properly seat it. Then try turning it all the way to the right, to the brightest setting. Or try turning the other way if there is still no illumination. Make sure you have the key in the ignition and turned on to the same location where your radio, wipers, and all other accessories work (test to make sure they are working before trying the dash lights). And of course, you need to be out of bright sunlight and in an area where you can clearly see when the dash lights come on, even in the event that they come on very, very dim.
So if this all failed, I hate to say it but it means you gotta take apart your dash which usually means numerous other parts that may overlap. Find a good diagram or step-by-step instructions for your particular model. Then it will be a matter of checking the bulb(s) and making sure any of the wires did not become disconnected or damaged...
Good luck. Taking apart your dash to get behind it cant be any more difficult with your Dodge than it was when I had to do it to a Toyota a couple months ago... I had to remove the console between the front seats to remove the auto shifter assembly that overlapped with the bottom section of the dash...
alot of time and effort all for one little bulb replacement.
Posted on Apr 29, 2009
Tips for a great answer:
May 12, 2015 | 1999 Pontiac Sunfire
Nov 25, 2011 | Cars & Trucks
Jun 04, 2011 | Dodge Stratus Cars & Trucks
Apr 01, 2010 | 2002 Dodge Durango
Feb 25, 2010 | 2002 Pontiac Grand Prix
Mar 22, 2009 | 2003 Dodge Stratus
Mar 04, 2009 | 2002 Dodge Caravan
155 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: