Question about 1995 Honda Passport

Open Question

Adjust positive camber

Tires are wearing on the outerside. New tires, only have 1000 miles and have worn then to about half the tread wear already.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 62 Answers

SOURCE: 92 prelude rear tire wear

I dont think the sway bar will affect the tires at all, but i would suggest fixig it as it helps the car handle the road better.

Posted on May 11, 2009

Ad
turo1000
  • 18 Answers

SOURCE: 2006 Honda Pilot - Road Noise - not tires.

the tires make steady noise , check the wheel bearing as noises get high and low at the same speed , and i also would check for diff if it's 4wd.

Posted on Jul 25, 2009

  • 346 Answers

SOURCE: inside tire is so wear

You'll need to have an alignment/suspension check done to verify, but normally, accelerated inside tire wear is attributed to misaligned or bad ball joints, and can also be attributed to tie rod ends/steering components.e

Posted on Aug 11, 2010

  • 3911 Answers

SOURCE: I recently brought my 1998 Honda Civic in for a

Replace the control arms, the tie rod ends and then get an alignment done. Your parts are all too worn out to properly align.

Posted on Nov 29, 2010

  • 133 Answers

SOURCE: i did a engine swap to a 1.8l but now my front

Just get your wheel alignment checked.

Posted on Dec 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What causes front tire wear on inside & outside edges


Under inflation. When the tire doesn't have enough air pressure, the center tends to be pushed up from the road. Thus causing outer wear on both sides. alignment problems cause wear on one side or the other. Over inflation causes the center of the tire to wear .

Aug 31, 2014 | Cars & Trucks

Tip

Preventing tire wear is about regular maintainence to your vehicle. You should...


Preventing tire wear is about regular maintainence to your vehicle.
You should rotate your tires every 5,000 miles , and keep
your tire pressure at factory pressures as indicated by the tag
inside the drivers door column.
Alignment is another factor in tire wear , look at your tires carefully .
Look for any unusual wear , especally on the inside of the tires,
as this is usually the most troublesome spot.
As vehicles age , the springs lose their tension to a degree.
This causes a problem in the tire angle called "camber".
The vehicles wheels are tilted inward at the top.
Excessive negative camber will wear the inside of the tire.
Most vehicles can have this corrected by properly aligning
the vehicle .
Another wear problem can be caused by the toe adjustment
being out of specifications .
This is the most destructive angle to tires , it the same angle you use to steer the vehicle left and right .
It normally causes inner and outer tire edges to wear rough in
one direction smooth in another while rubbing your hand around the
tire.
Both these angles can be corrected by a professional alignment .
Be sure the technician inspects your front end for any worn parts,
as aligning it with them is a waste of money and time .
Always ask for a before and after printout of your alignment.

on Aug 13, 2010 | Toyota Camry Cars & Trucks

1 Answer

Both front tyres have excessive wear after only a few thousand miles on the insides. Appears to be similar rate of wear on each tyre. Tracking adjusted last service, so unlikely to be that. Any ideas?...


I think a real good place to start would be to have a front end alignment, and struts and springs checked. Most alignment places will check front end all over before performing the alignment, to insure that it isn't worn parts causing the problem, as well as insuring that you aren't driving under dangerous conditions. Your problem could be as simple as a camber adjustment to correct negative camber.( tire is leaning inward at top, which causes tire at road surface to run on inside of tread.) Weak struts and springs are also a consideration, especially if still original on a 95' vehicle.
Here's a link that explains alignment pretty well to help you understand.
http://www.familycar.com/alignment.htm

Dec 29, 2010 | 1995 Volkswagen Golf

4 Answers

REAR TIRES WEARING OUT THEY ARE RIDING ON THE INSIDE OF THE TIRE ONLY


Hello there:
The only possibility is that you need a camber adjustment. If that were the case, the tires would be wearing more on the inside edges. If they're not, either ease up on the gas a little bit, or just put $2 a week in a piggy bank for your next set of rear tires, and don't worry about it. the tires that come with this car are made of a relatively soft compound. The softer the rubber, the goo-ier the tires, and the more the car "sticks" to the road. That's one of the reasons you can drive down circular parking garage ramps at 65 mph in this car. The downside of softer tires is that they wear out faster. So it may be a combination of your driving and the type of tires you have.


Nov 09, 2009 | 2001 Ford Focus

3 Answers

Tires wearing inside on 2008 Impala LT


this is a wheel camber (in and out tilt of wheel and tire) problem, u may have to have a Camber adjustment kit put in, most new cars have no adjustment provided for this. the bottom line here is you need to see a really good front end shop to get this taken care of, also the tires will continue to wear this way even if problem is corrected, so may want to replace them or rotate them.

Jun 05, 2009 | 2008 Chevrolet Impala

3 Answers

Front tires lean in at the top and is wearing inside treads down .i was told that torsion bars were adjusted all the way in.several mechanics have looked at this and find nothing misaligned


If you have run out of adjustment, perhaps you should consider replacing the bars. Essentially they are just a different kind of spring and over time they do loose tension. Obviously something is affecting your alignment or the tires would not wear!
What I fail to understand is that a shop can tell you it's not mis-aligned if the wheels have an obvious camber problem??!! Has anyone put it on an alignment machine?

Apr 19, 2009 | 1998 Ford Ranger SuperCab

2 Answers

Car shakes at highspeed, wears inside of tires


Sounds like its either your "camber angle" or your tires aren't balanced correctly

Nov 24, 2008 | 1991 Oldsmobile Cutlass Ciera

1 Answer

How can the rear suspension be adjusted?


REAR WHEEL ALIGNMENT
TOE-IN : 0±2 mm (0±0.08 in.)
note_icon.gif 1. The rear suspension lower arm mounting cam bolt should be turned an equal amount on both sides during adjustment. Right wheel : Clockwise direction : toe-in Left wheel : Clockwise direction : ton-out Maximum difference between LH and RH : 3mm 2. The cam bolt should be adjusted within a 90° range left or right from the center position. CAMBER Standard value : 0°±30´ Maximum difference between LH and RH : 3mm : 0±2 mm (0±0.08 in.) note_icon.gif 1. The rear suspension upper arm mounting cam bolt should be turned an equal amount on both sides during adjustment. 2. Install the left and right springs which have the same identification color. 3. The cam bolt should be adjusted within a 90° range left and right from the center position.e55b100.gif TIRE WEAR 1. Measure the tread depth of the tires. Tread depth of tire [Limit] : 1.6 mm (0.06 in.) 2. If the remaining tread depth is less than the limit, replace the tire. note_icon.gif When the tread depth of the tire is reduced to 1.6 mm (0.06 in.) or less, the wear indicators will appear.

Jun 16, 2008 | 2004 Hyundai Santa Fe

2 Answers

Aggravated front tire wear (outer edges)


Your situation is not not abnormal. Since you can't rotate due to different sizes front & rear & they are high performance "Y" speed rated tires 30K is really pretty good

Jun 11, 2008 | 2006 Chrysler SRT

Not finding what you are looking for?
1995 Honda Passport Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...