Question about 1997 Plymouth Grand Voyager

Open Question

Antiifreeze leak under intake manifold replaced intake gasket and water pump outlet tube still big leak

Antifreeze leak under intake manifold replaced intake gasket and water pump outlet tube still big leak coming from under intake

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: water outlet tube leaks

It inserts into back of water pump.Need I say more? Sorry.

Posted on Apr 12, 2009

Dr-Custom
  • 216 Answers

SOURCE: leaking coolant from tube coming out of intake on drivers side

I assume this is a 3.0L v6 and that the metal tube that goes under the intake is leaking.This tube can be removed without taking the intake off. There are two bolts holding the tube under the intake on at the transmission side to the tube.The other end of the tube has an "o" ring on it that seals to the back of the water pump housing.Take the radiator hose off of the tube and then the two bolts need to be removed. Now try to pry against the bracket the the bolts were in and move the tube away from the engine. Pull the tube all the way out of the area from beneath the intake and either replace the tube if necessary or just replace the seal. Install by reversing removal procedure. Lubricate seal with silicone greas so seal will slide rather than get damaged upon installation.

Hope this helps

Posted on Apr 20, 2009

  • 1 Answer

SOURCE: antifreeze leak in a 1999 plymouth voyager.

i have the same problem on my 1996 voyager is it the water pump?

Posted on Feb 12, 2010

alicantecoli
  • 22133 Answers

SOURCE: leaking antifreeze, looks like its

yes water pump without a doubt ,it does run downwards

Posted on Oct 31, 2010

  • 159 Answers

SOURCE: 2000 plymouth breeze 2.4 jumped timing and now leaking antifreeze.

that would'nt make any difference to water pressure! may be possible that your vehicle was overheating! overheating caused excessive pressure in the system, which popped(The noise you heard) one of the hoses, or a connection!

Car stalled from over heating!

Posted on Apr 27, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Using antifreeze but no sign of leakage on 2006 sienna


After it warms up check exhaust for steam. Probably head gasket leaking into the exhaust.

Sep 14, 2014 | 2006 Toyota Sienna

Tip

Intake Manifold gasket replacement and/or leaking= Ford


Intake Manifold gasket~

Replacing intake manifold gasket:
Replacing the intake manifold gasket, I used the tube kind, it's a make it youself for about $6 (it's blue and the consistancy of toothpaste) follow directions carefully! You can get a tube at Autozone or any car parts store. Has been working great. Just ask the cashier for the make it yourself kind of intake manifold gasket. Sorry, I don't remember the name of it, it's been that long...lol...

As for the Intake Manifold leaking coolant....It could, but shouldn't. One of the largest problems I've seen for coolant to leak out the Intake Manifold has been due to pressure in the system somewhere... Check the classic area:
Water pump- look for either water seapage and/or coolant. You'll know if it is because you will see real water either coming out of the water pump leak hole or under the thermostat. Most of the time coolant will pool where your heater hose runs in the intake manifold.

Mentioning heater hose. Check for leaks, holes, and/or cracked heater hoses. In-addition to the water pump, heater hoses...Check the transmission system, exhaust system, fuel system, radiator system, A/C system, secondary fan (located above the water pump housing), and thermostat.Also, check all electrical connections....Hummm....This is almost the entire workings of the vehicle.

NOTE: "It seems to be an infinity kinda thing... Once one thing starts to fail and is ignored, you are bound to be fixing a chain of event failures. Therefore, Do not ignore even the smallest problem or you'll be bound for life in repairs...."

on Jun 25, 2010 | Ford Expedition Cars & Trucks

1 Answer

2001 pontiac sunfire will not hold any antifreeze, why and whats wrong with my car????


General advice:U must track the leak .How much it takes to loose the coolant?.If the coolant shows under the car must identify the tubes clamps that need tighten or replace.If a radiator related problem need clean/solder/replace.If leaky water pump,replace.If no trace of coolant ceck the oil.If is color altered(milky)u have a head gasket ahead (with head revision)or a broken engine block/piston cyclinder.If the oil is ok,ceck the smoke:whity smoke means coolant in the pistons head.Again best guess:head gasket (can leak also in the intake manifold).Very rare coolant shows in some cars in the power stearing oil (!?) track the tubes.Tip:colored coolant (green...)is better visible in leaks.Tip:water coolant may show rusty spots where dissapearing (radiator,expansion deposit,pitched tube).Hope u deal it.Cheers.

Oct 24, 2013 | 2001 Pontiac Sunfire

2 Answers

I need to replace the thermostat it is sticking


DRAIN COOLANT LEVEL DOWN BELOW THERMOSTAT.PLACE DRAIN PAN UNDER VECHICLE TO CATCH ANTIFREEZE.WHEN DONE PUT ANTIFREEZE SAFE PLACE FROM KIDS AND ANIMALS.WHEN DONE DRAINING SOME ANTIFREEZE.FOLLOW RADIATOR HOSE TO TOP OF INTAKE TO THERMOSTAT HOUSING. LOOSEN HOSE CLAMP REMOVE RADIATOR HOSE FROM THERMOSTAT HOUSING.THEN LOOSEN HOUSING BOLTS.REMOVE THERMOSTAT HOUSING AND THERMOSTAT.CLEAN BOTH THE THERMOSTAT HOUSING SURFACE AND INTAKE SURFACE YOU CAN USE ACETATE OR BRAKE CLEANER AND SCOTCH BRITES ROLL OF CLEAN PAPER TOWEL. AFTER CLEANING HOUSING AND INTAKE SURFACE MAKE SURFACE CLEAN SMOOTH FROM THE DEBRIS WHEN DONE. TAKE THERMOSTAT PUT GASKET SEALER ON BOTH SIDES OF GASKET PUT GASKET TO THERMOSTAT HOUSING MAKE SURE GASKET AND THERMOSTAT HOUSING HOLES ALIGN CORRECTLY.NOW PLACE NEW THERMOSTAT IN PLACE IN THE INTAKE.MAKE SURE THERMOSTAT SPRING END GOES TOWARD ENGINE FACING DOWN.THEN INSTALL THERMOSTAT HOUSING WITH GASKET TO THE INTAKE.TORQUE THERMOSTAT HOUSING BOLTS TO 20 FT LBS.WAIT 1 HOUR BEFORE POURING ANTIFREEZE BACK IN THE COOLANT SYSTEM GIVE THERMOSTAT GASKET SEALER LITTLE TIME TO CURE.SO YOU WONT HAVE COOLANT LEAKS.NOW IF THERMOSTAT HAS THE LARGE O- RING ON IT YOU DONT HAVE A THERMOSTAT HOUSING GASKET THE THERMOSTAT O- RING IS THE SEAL THAT HOLDS COOLANT INSTEAD OF GASKET.WHEN THERMOSTAT AND HOUSING IN PLACE.INSTALL RADIATOR HOSE TO THERMOSTAT HOUSING TIGHTEN HOSE CLAMP.THEN FILL RADIATOR BACK UP WITH THE COOLANT YOU DRAIN OUT.START VECHICLE UP. THEN CHECK FOR LEAKS.

Nov 03, 2010 | 1992 Buick LeSabre

3 Answers

There is smoke coming from under the manifold area i can't see any visible leaks but i have noticed there is a nasty smell of antifreeze as well. The low coolant light is on but there is enough coolant in...


have your cooling system pressure tested, that should give a place to start as to where the leak is and how much it is going to cost to have the problem fixed

Oct 21, 2010 | 1993 Oldsmobile Cutlass Supreme

1 Answer

Top right front of the engine is leaking antifreeze but it is not the hose or water pump.


gasket from-[intake manifold -water pump]also check the heater hose connection on the intake manifold has a tendency to leak

Feb 20, 2010 | 1996 Chevrolet Blazer

2 Answers

Replaced water pump, now antifreeze leaking out from an area behind altenator and belt tensioner. Can you help?


take a flash light with the engine running and look at the corners of your intake manifold soo many times people have changed the water pump on the goofy engine WHEN!! it was the intake manifold gaskets leaking water to the outside and running down the front LOL

Jan 14, 2010 | 1995 Buick Park Avenue

2 Answers

My 1999 chevy tahoe is leaking antifreeze. I


it could but- check passenger side front where heater core line go into manifold right behind alternator the hose line is connected by a press clip into an alloy fitting this fitting gets eaten away by anti freeze and hose angle pulls back on fitting the part is $18 at dealer and is screwed into manifold use caution if ur r going to replace at very edge of aluminum manifold---and check ur water pump bolts the 2 longer ones should have a lock sealant on them they bolt in thru a water jacket

Oct 24, 2009 | Chevrolet Tahoe Cars & Trucks

2 Answers

2000 chevy impala ls - oil spray under hood inline with serpentine belt


You may have a lower intake manifold gasket leak (or a head gasket leak-slightly less probable) the lower intake can leak onto the serpentine belt and fling oil (and/or antifreeze). The lower intake manifold gasket is usually the culprit here. There is much information about changing it if you are inclined to do it yourself. If not, expect around 800 to 1200 to fix at dealer/mechanic. This is usually accompanied by (but not always) oil in the antifreeze, or antifreeze in the oil...

Jan 18, 2009 | 2000 Chevrolet Impala

1 Answer

Antifreeze leak


DO NOT DRIVE THE CAR until this problem is fixed! You could destroy the engine.

Many GM V6 engines of 1995-1999 had defective Upper Intake Manifold (UIM) gaskets (this is especially true for 3800 V6 engines). The antifreeze/coolant (especially orange DEX-Cool) will deteriorate the gasket material over time. If there are abnormal exhaust noises accompanying the leak, and/or the oil appears cloudy (check this immediately), you may have a blown head gasket or Lower Intake Manifold (LIM) gasket. Start with the UIM gasket.

The repair is detailed in the Haynes manual for that car ($17 at NAPA and Carquest), and (DIY) will take 5-8 hours plus a new gasket and RTV sealant (parts should be under $40 for all). A shop will charge $250-350 for this job.

Oct 08, 2008 | 1995 Pontiac Grand Am

Not finding what you are looking for?
1997 Plymouth Grand Voyager Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...