My 2004 chevy malibu beeps like if i turned on the alarm but beeps even when im in the car

SOURCE: 2004 chevy malibu classic

Happens all the time to me. I trigger the Theft System by accident then the car won't start.  try this: Put the key in the ignition. Turn it to the "on" setting,but don't try to start the engine. Let it sit for 10 minutes until the Security light stops blinking and turns off. Take the key out and restart. Warning - don't have your lights, radio,etc on while you do this or the battery may die. 

Joe Lamb

• 463 Answers
• Posted on Mar 31, 2009

SOURCE: i can't disable my anti theft device on my chevy

This usually works.Lock the doors with the remote.Press lock twice sounding the alarm.Then press the unlock button twice.Your car should start now.If that doesnt work try this,Lock the car again with the remote once.Go over to the passenger side door and use the key to unlock the door then press in the door unlock all doors.Hopefully by now it worked.Now if none of these work your security probably malfunctioned and theres only two things that will work,One is disconnecting the battery for 5 mins then reconnecting.unlock doors.the start.If that doesnt work you'll have to take it to the dealer to get the security reset or replaced.The steps I have wrot you are the diagnostics to reset it.I hope these work for you and good luck.See ya had have a great day..

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

SOURCE: program a keyless enrty remote start 2004 chevy malibu

Dealer only If you find a different means let me know

SOURCE: 2004 Chevy Malibu Classic and problem is turn signal goes out

the hazzard switch is together with the turn signals, so if they are not working properly, check hazzard switch. the switch has a built in timer for hazzards and turn signals.

SOURCE: replacing spark plugs on a 2004 chevy malibu

2.2L Engine

1. Observe the following service precautions:
   
   Allow the engine to cool before removing the spark plugs. Attempting to remove spark plugs from a hot engine can cause the spark plugs to seize. This can damage the cylinder head threads. Clean the spark plug recess area before removing the spark plug. Failure to do so can result in engine damage due to dirt or foreign material entering the cylinder head, or in contamination of the cylinder head threads. Contaminated threads may prevent proper seating of the new spark plug. Use only the spark plugs specified for use in the vehicle. Do not install spark plugs that are either hotter or colder than those specified for the vehicle. Installing spark plugs of another type can severely damage the engine.
   
2. Turn the ignition OFF .
3. Disconnect the Electronic Ignition (EI) module harness connector.
4. Remove the spark plugs using a 5 / 8 inch spark plug socket.

1. Inspect the gap on the new spark plugs, re-gap the plugs as required. The spark plug gap specification is 42 inch. (1.0 mm).
2. Install the spark plugs and tighten to 15 ft. lbs. (20 Nm).
3. Apply dielectric compound to the spark plug boots and make sure no corrosion is present.
4. Install the ignition coil housing to cam cover and attachment bolts.
5. Tighten the ignition coil housing bolts to 89 inch. lbs. (10 Nm).
6. Connect the EI module harness connector. Push in until a click is heard and pull back to confirm a positive engagement.

Testimonial: "Thanks for the help, it was easy to change out the plugs with your info."