Question about 1988 Buick Electra

Open Question

Replace motor mounts on 1988 park ave

Regular 3.8L

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

blueextc3221
  • 15935 Answers

SOURCE: What is the llocation of a fuel pump for a1988 buick park avenue

Commonly submerged in the fuel tank. Some require the removal of the bottom rear seat, others need entire tank dropped to access.
If memory serves, you will need to drop the tank to access on the P.Ave.
Save yourself some time and pop off the rear seat just to be sure.

Posted on Jan 14, 2009

honeymokey
  • 3113 Answers

SOURCE: blower motor on Park AVe '94

Relace blower control module.

Posted on Apr 08, 2009

  • 1 Answer

SOURCE: 93 buick park ave Ultra. replacing water pump

Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.

Posted on Aug 08, 2009

Testimonial: "answered the question completely and thoroughly!"

  • 491 Answers

SOURCE: got 1988 buick park ave.car wouldnt start,hooked

You may have damaged the starter when the engine kicked back.

The ignition module may have been defective.....but change the crank pickup too.........more likely it is the cause of the problems.

Change the crank pickup at every tune up..........it has a high failure rate.

If your engine has 250km or 150K miles you may need a chain soon.

Posted on Oct 05, 2009

Testimonial: "thanks alot,really helpfull"

  • 60 Answers

SOURCE: replacing motor mount

Put the car on ramps. Using a floor or scissor jack and a block of wood, find aa appropiate safe place to jack up the motor to relieve the tension on the motor mount you wish to replace. Remove the old mount and replace with a new one.

Posted on Apr 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Timing chain replacement 1997 buick park ave.


They are not prone to fail. I always recommend to replace only major when engine repair is needed.

Mar 27, 2013 | 1997 Buick Park Avenue

1 Answer

Blower motor resisror where is it in a 93 park ave


I think its mounted under the hood on the fire wall beside the blower motor by the passenger, in front of the glove box.

Jan 29, 2012 | 1993 Buick Park Avenue

1 Answer

Will a 1988 Buick Lesabre column replace a 1988 Regal Park Ave.


Lesabre and park ave should be the same and NOT regal.

Apr 17, 2011 | 1988 Buick LeSabre

2 Answers

98 buick park ave. shakes n shifts hard and noises, is this a transmission sensor?


sounds like a trans mount when they go bad it causes all kinds of shakes , have someone put in gear ,open hood,, watch motor. tell them to hold brake and give it a little gas .Don;t stand in front of car .....see if motor raises up if so replace all mounts motor included. this is a common fix on theses cars.

Mar 18, 2011 | 1998 Buick Park Avenue

1 Answer

Removing motor mount on a 1998 Buick Park Ave Ultra


Which motor mount? sides or front and rear, You have to hold the motor up in the air using a jack of some type then the motor mounts will unbolt from the motor and the frame, they should look like a dogbone, and you can get them at Auto Zone. usually about an horu job if you have the right tools and parts alraedy bought.

Oct 06, 2010 | 1998 Buick Park Avenue

1 Answer

93 buick park ave Ultra. replacing water pump...must I remove the front passenger side motor mount??


Yes. Put a jack under the motor and remove 3 bolts from side of engine and the long center pivot bolt in mount and the 2 bolts that go top down into the frame and loosen the 2 bolts below mount. Jack up the motor until you can separate the mount, leaving the engine side in and removing the frame side. The engine side can be moved out of the way without completely removing.

May 06, 2009 | 1993 Buick Park Avenue

1 Answer

Belt replacement on park ave 98


some models you do not remove anything some have a spacer on the motor mount

Mar 08, 2009 | 1998 Buick Park Avenue

2 Answers

What is the llocation of a fuel pump for a1988 buick park avenue


the fuel pump like all pumps on fuel injected cars is in the fuel tank.

Jan 14, 2009 | 1994 Buick Park Avenue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...