Question about 2000 Subaru Outback

1 Answer

2006 outback xt won't acccelerate

Electronic accelerarater pedal. One morning I start the car, it's missing a little and it smooths out when I push on the accelerate but RPMS do not increase. Come back 29 minutes later, starts anand responds to acceleratte but check engine light on and cruise control lite flashing.Its fine for a few days and then does the same thing fault code •P2109 Throttle/Pedal Pos SensorA Minimum Stop Perf

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Expert
  • 99 Answers

Did you check your oil levels?

Posted on Jan 14, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

xalint1
  • 150 Answers

SOURCE: Check Engine Light

Hello engelhard58
I have attached a link that can give you some of the reasons why your getting that code.I hope you able to get your answer out of that.
Mean of the code=P0420 Catalyst System Efficiency Below Threshold.
Link to site

Posted on Dec 12, 2008

alicantecoli
  • 22095 Answers

SOURCE: After oil change, check engine

dealer only software neede to reset this problem.sorry i couldnt be any more help but try reading the software whens it encrypted ??

Posted on Dec 22, 2008

  • 140 Answers

SOURCE: 2003 Subaru Outback check engine light stays on

You may have to take it to a shop and have them connect their OBD tool to the computer and clear the deep memory. If you have a code left in the deep memory it can reapear like that. Good luck. Please rate me so I know how I'm doing. Thanks.

Posted on Dec 30, 2008

  • 1 Answer

SOURCE: ABS Light and Check Engine Light on, Cruise light flashing

I had this occur on my 2007 Subaru Tribeca. ABS, Traction Control, Check Engine lights were solid, Cruise Control light was blinking and "Er SS" (commonly misread as Er 55) displayed on Trip Odometer. All lights were cleared after 10 or so miles. It appears this is a Speed Sensor (SS) reading error whereby the computer notices an irregularity with the readings taken from the four wheels. Most often it is a temporary and harmless glitch and sometimes a result of debris that is impeding the sensor's reading at one of the wheels.

Posted on Nov 03, 2009

  • 4088 Answers

SOURCE: check engine light, cruise control light flashing,

Take the car to Autozone or similar business for a free code read with a scanner. Depending on what turns up, they will be happy to sell you any needed parts.

Posted on Dec 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When u start to go if u give it gas it will bogg out and won't go but if u barely push the gas pedal it will go but has no power


i would say mabey the injectors but you said it runs good in the morning.....and you said filter, did you mean air filter or fuel filter

Feb 09, 2013 | Cars & Trucks

2 Answers

2006 subaru outback check engine light and cruise control light blinking


after this mileage the probable cause is the smoke sensor in exhaust it has to be replced and the error should be cleared by car scaner if you don't want to replace the sensor you can clean it it is located on the exhauste pipe but however you still need to visit a car technician to clear the fault from the computer log of the car

Jan 28, 2013 | 2006 Subaru Outback

2 Answers

Headlights won' turn on on a 2006 subaru outback marker lights work


2006 Subaru Liberty 3.0 Blitzen, 52,000kms. It's unbelievable, both my low beams went out at once and when I checked it was both the globes had gone at once. Never has this happened on any other vehicle before, I've ordered a HID conversion kit over the net, hope that works well.

Oct 03, 2012 | 2006 Subaru Outback

1 Answer

My 2003 dodge caravan turns on but it doesn't go. To move just a little bit I have to push gas pedal very hard.


make sure the emergency brake is completely releasing , is the motor lugging or working really hard to make it move? does it feel like the brake is on, or that the motor just won't get up to speed to make it move smoothly

Jul 04, 2011 | 2003 Dodge Caravan

1 Answer

Sometime it will not start untill i use a little very little starting fleuid. this morning the gas pedel didn't respond for 5 minets then started working fine


If this is a gas unit, try changing the TPS, the throttle position sensor. This should be located on the metal Airhorn behind all the plastic Air Filter ductwork. Also disconnect the throttle pedal and work the end by the Airhorn with your hand.

Check for binding in the cable. You should feel smooth response. If not, you need to replace the cable too.

Sep 08, 2010 | 2005 Ford F 350 Super Duty

2 Answers

Rough(missing) when cold. Smooths out a little after warming up.


It is not unlikely a plug wire got put back on on the wrong plug. These cars will still run with a few plugs wrong.

May 29, 2010 | 1998 Subaru Impreza

2 Answers

I have a 2002 subaru legacy outback. It's a


You may need to give the MAF a small shot of carb cleaner across the inside air flow vane. The small wire like elements sometimes get dirty and cleaning them will do wonders.

Apr 07, 2010 | 2002 Subaru Outback

1 Answer

2004, 6 cylinder outback, engine idle speed


We bought our H6 used under warranty and had the problem the day it was delivered. Brought it in to the dealer and the diagnosed it as the throttle position sensor. It is an electronic component that works in conjuction with the fuel delivery system and it is faulty, it cannot tell what position the gas pedal is in, and therefore is randomly picking power settings.
We had it replaced, and never a problem since.
There are other possibilites to your problem, and this was our solution.
Hope that helps.

Oct 31, 2008 | 2004 Subaru Outback

Not finding what you are looking for?
2000 Subaru Outback Logo

161 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...