Question about 2005 Suzuki Baleno

1 Answer

Where can i find the filter for my transmission

Car is starting but when gear is selected its not moving had to put it in nutural and tow it

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

It's under the transmission oil pan. You have to remove it and drain the oil from one corner without taking all the bolts loose. Filter is normally not the cause though. Could be something else wrong internally. Cheapest thing to do is replace it though just to see. Often you could be low on fluid too!

Posted on Apr 16, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 700R4 in a 1990 Chevy 4x4 the transmission was working in another truck I put it in mine and now it changes gear 1-2-3 but it won't change into overdrive don't have nutural it's drive and reverse...


Overdrive is a function of the torque converter. When you put the transmission in the vehicle you should have change the seals and rings on the shaft. The transmission fluid travels through that. Also check the linkages and the connections.

Dec 12, 2014 | Cars & Trucks

1 Answer

When putting into reverse it has to be in the


This sounds a lot like the bush's in the gear change linkages are either worn out or gone. I have seen this a few times. Ask someone to check to see if the linkage moves when you move it only one place. Do this with the motor off and the hand brake on. Select nutural. Ask a friend to see if the gear selector moves when you select "D" drive. If there is little to no movement, time to start looking at linkage bush's

Sep 16, 2014 | Cars & Trucks

1 Answer

My 2009 dodge charger wont go all the way into


The linkage between the shifter and the transmission needs to be adjusted

Aug 28, 2014 | Cars & Trucks

1 Answer

03 suzuki will shift in to all gears but won't move


oops didnt read how to tow that suzuki,oops.
how far you go , over 200 miles>?
is it an auto or stick?

flat towed??
dolly towed,?
towed from front or rear.?
we cant guess any of that and are all covered in the operators guide.
clear as a bell too.

towing cars , most will damage the rear transmission bearing.
because its dry when engine not running.
so the rules are very strict. due to that hard fact.
soon as you tow anything , thing, "rear bearings."
or if Fwd car, same on front.
most cars are not designed to be towed and some only short distances.

Jun 15, 2014 | 2000 Suzuki Aerio

1 Answer

1997 silverrado transmission will not go into gear


More info.. ??? Does it shift but not go.. Like the trans is in nutural? or will the shifter not move? \]

May 24, 2014 | Chevrolet 1500 Cars & Trucks

1 Answer

2000 lexus RX300 transmission problem


Are you check trans fluid levels? Sound like a problem with the torque converter or internal valve body solenoids clugged. I suggest check with your technician before to buy or think in replacement parts.

Hope this helps.

Feb 08, 2012 | 2000 Lexus RX 300

2 Answers

Pickup starts great, goes into all gears but won't move. It's like it is still in nutural.


Assuming the pickup is an automatic, check the transmission fluid. The #1 cause for transmission slippage is lack of Automatic Transmission Fluid.

If the pickup is a standard shift, the pin that connects the shift to the transmission has likely broken. You would still be able to shift from the inside but the gears won't engage. A bad clutch is also a possibility but you would have noticed a burning smell prior to the clutch giving out.

Dec 20, 2011 | Cars & Trucks

2 Answers

1995 silhouette will start but won't go in gear at all, I tried all gears it just won't move


If the fluid level is correct and it will not go into gear, you need a mechanic. Have the car towed to a transmission shop. It is possible that your flexplate has sheared loose from the engine and your transmission is OK (caused by shifting into gear at high revs). Worse case, you need your transmission rebuilt.
Sorry, but this could be expensive.

Aug 23, 2010 | 1995 Oldsmobile Silhouette

1 Answer

Transmission will not engage and slips when it does engage


auto trans operates on fluid pressure. if the trans has never been serviced, more than likely the filter is plugged, and or the fluid is bad. no doubht its burned and will smell and look like it. get it towed to a shop and have the fliud and filter changed first, then check the band adjustment.recommend a trans shop do it and not jiffylube.

Jul 20, 2009 | 1995 Dodge Avenger

Not finding what you are looking for?
2005 Suzuki Baleno Logo

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...