Question about Toyota Mark

1 Answer

Once I've stopped the enginge(off the Ign by key), it's very very hard to restart again and sometimes totally cannot start again. I've to wait for long long time to restart. Can say cannot restart if

Cannot restart the engine once stop at normally high temperature (working temp.)

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 114 Answers

Do the dash lights come on? You might want to check the security system because at times it could be setting the anti theft kill switch, and after waiting a bit it will reset itself.... It could also be a bad ignition switch. Good luck!

Posted on Jan 24, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 46 Answers

SOURCE: 2000 Honda Accord - engine overheats when stopped

There are only a couple things you can check. First, I would make sure the gauge is reading properly by checking the fluid temperature manually. Newer model cars have temperature sensors that can malfunction but they will usually set your check engine light off it that is the case. Check your radiator fluid. While the engine is cold!! See if it looks dirty. Rub it between your fingers and see how viscous it feels. Make sure the radiator is full. You may just need to get your radiator flushed. A lack of flow will cause an overheating condition. When your back in motion the engine has more pressure to circulate the fluid. When the car is moving there is airflow that also aids in the cooling process as well. Other than that you have a thermostat which could be sticking and causing it to overheat. Or the water pump is bad. A flush and fill and replacing the thermostat are fairly cheap and usually a lot easier to do than replacing the water pump. Especially on a Honda. Usually you will hear a squealing noise if your water pump is going out and there is, I think it is called a weep hole on the pump itself that will start to leak when the pump is going bad.

Posted on Oct 06, 2008

  • 104 Answers

SOURCE: 1991 3.3L Plymouth Voyager, Transmission temp sticks in first.

John, this sounds like a valve hanging up in the valve body. The car shifts when the govenor pressure overcomes throttle valve pressure in this valve body.

What is the condition of the fluid? Is it at all dark or grey, does it smell burnt? It should be a nice light pink. If not, have the fluild and filter for the trans changed. This may take care of the problem.

If the oil is really burnt, you are at the end of the life of the clutches and you are looking at a complete trans rebuild. If the oil is ok, a trans shop should be able to take just the valve body down, clean it and eliminate the problem without overhauling the entire transmission

good luck

Posted on Feb 09, 2009

  • 14 Answers

SOURCE: My engine in my '03 toyota matrix xr dies.

check the mass air flow sensor it is hooked with air cleaner

Posted on Mar 11, 2009

  • 3 Answers

SOURCE: Hard starting Chev 2500HD 8.1 L

i have had the same problem.the solution is the fuel pump! i know you got pressure and it runs so how can it be the fuel pump? the pump is losing its prime you are getting pressure just no volume thats why its crank off crank off the system is priming itself again kinda like a weedeater or similar motor fuel is there just not enough of it to the injector To check this hook a pressure gauge turn on key turn off key release fuel should be plenty but if tis just a few drops thats it hope this helps

Posted on Jun 09, 2009

ghost45
  • 1280 Answers

SOURCE: 1999 Hyundai Grandeur suddenly stop and couldn't start again

Coolant Temperature Sensor

Posted on Oct 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 200 1.6 glxi in thailand, have intermittant engine shut down, electrical as all goes off, sometimes instant re start, back fire, and away, otherwise start off the key whilst rolling, i have c


check the battery terminals and posts are shiny clean and tight. Check for loose wires and other terminals that may be dirty or loose.. Have the fault codes read

Mar 25, 2014 | 1998 Ford Laser

1 Answer

Intermittent starter won't engage on mercrusier7.4 1988 boat engine


might be a burned spot on the starter contacts where the brushes power the motor.
tap the starter to see if problem goes away.
sometimes you can clean the contacts but that is a temporary fix.

Mar 11, 2013 | Cars & Trucks

1 Answer

2000 Chevy Lumina wouldn't start at gas station out of nowhere...security light and volt light came on.


to reset security you'll ned to do the 10min key with ign. on for 3times after each 10 min turn key off briefly then back on without trying to restart after 30min or three 10min ign on cycles turn off key briefly then the car should start

Sep 02, 2012 | 2000 Chevrolet Lumina

1 Answer

Security system stops jeep from starting


With the door open engage the locks, then shut the locked door. After door is shut use the KEY note: (NOT THE REMOTE) after you've unlocked the door place key in ign and start the Jeep.

Dec 05, 2011 | 1995 Jeep Grand Cherokee

1 Answer

My jeep wrangler 95 can't be start, because check enginge line can't ON.when i'm remove general cable from batery, end wait until 2 hour, plug cable on batery. check enginge light is ON and enginge can...


i have the same prob with mine. if u trun the key to the on and leave it sit there the ck engine light will come on in a few minutes then it will start. I think it is the computer but i have not got it check yet but i have to do that every morning and then it works fine as long as it stays worm.

Jun 08, 2010 | 1995 Jeep Wrangler

1 Answer

Vehicle: 2000 Dodge Ram 1500, 5.9L, Automatic Transmission, 171,000 miles. Vehicle will stop running, just shut off, after about 10 minutes of driving. Then after 5 minutes of waiting it will start again...


the first suspect is the igniton switch. when this happens, take the ign key and just barlely turn it, either way, not enough to go off/on just a little tweak, it the lights come back on or flicker, that ign switch will need replacement.

Sep 18, 2009 | 2000 Dodge Ram 1500 Truck

1 Answer

1998 CHEVY BLAZER STARTS FIRST TIME WHEN DRIVEN FOR SHORT DISTANCE AND ENGINE IS TURNED OFF IT WONT RESTART AGAIN UNTIL YOU WAIT FOR 5 TO 10 MINUTES THEN STARTS RIGHT UP HAVE HAD THE IGNITION SWITCH...


You might want to look at your fuel pressure. Test the pressure cold, turning the key on before starting it and then when it is hot,

You could also have a coil that is not putting out spark when it gets too hot. The engine gets hotter when you shut it down because the water is not being circulated. Once the vehicle is shut down the temp increases for a while. It could also be an ignition modual, sometimes just before total failure they quit working when they get hot.

As you can see there are a lot of things that can cause this and it makes it hard for a repair shop to diagnose with out having it for enough time to duplicate the problem.

If you want to try yourself, you will need at least a fuel pressure Gage.

Hope this helps

Aug 20, 2009 | 1998 Chevrolet Blazer

1 Answer

05 cts v6 drove car,when i stopped an let it sit for a few min.when i tried to start again the key turned on but would not start and key would not come out. the only way it will come out is by unhooking...


I dont remember the name for it.VATS I think it's called,it a security item inside your steering wheel the little wire breaks and the system looses it's sense to know what's going on.The car thinks you are in drive mode.

Aug 15, 2009 | 2005 Cadillac CTS

1 Answer

1992 Volvo 240 nearly overall electrical failure


VOLVOS ARE NOTORIOUS OF BURNING/WEAR THE ELECTRICAL PART OF THE IGNITION SWITCH. SUGEST REPLACING THE ELECTRICAL PART OS IGN SWITCH LOCATED BEHINF THE IGNITION/KEY.

Dec 01, 2008 | 1991 Volvo 240

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...