Question about 2000 Dodge Stratus

1 Answer

Mystery car my 2000 dodge stratus jumps going down the road and it goes dead. my rpm gauge goes crazy when this happens i have to let it sit for about 10 minutes before it will crank back up. i have replaced the altenater the brain box the heads the crank shaft censor plugs and plug wires. my signal and flashers also go out. i have replaced everything on this car the altenator the brain box the crankshaft and crankshaft censor the plugs and plug wires the heads. what could possibly be left to replace?

Posted by on

  • Lance Birch May 11, 2010

    what do you mean by: "it jumps going down the road" ????

  • yadayada
    yadayada May 11, 2010

    suggest u use the premium question option an do a trouble code test before you post.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

It sounds to me like a bad censor...you would probably have to take it to a shop for them to run a diagnosic test, that should tell you what censor.

Posted on Jun 29, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

When the gas is applied the car will stall and the rpm gauge will go up and down


Check the air inlet tube for cracks. Duct tape will work in a pinch.

Sep 01, 2014 | 1992 Honda Accord

1 Answer

2000 dodge stratus. Heater only works at idle, when driving at high speeds, heater blows cold and thermostat gauge goes to cold. Back flushed heater core, new thermostat any ideas?


I'd say you have a faulty thermostat, be it new or not. If your temperature gauge goes to cold as your engine is taking you down the highway, the thermostat is not doing its job. The temperature should never come down to below normal until engine is shut off...

Dec 03, 2013 | 2000 Dodge Stratus

2 Answers

Dodge stratus code p1391 replaced knock sensor and cam sensor still nothing


in my code book gave me intermittent loss of cmp or cpk
for 2.0 L are you having any back firing problems ?? iif so timing belt may have jumped one tooth . just trying to help hope this gives you some other things to look at ,good luck
oh look up code p1390 just found it . explains more what i was saying.

Sep 29, 2012 | 1998 Dodge Stratus

1 Answer

4runner RPM gauge needle going crazy


Check your Alternator. If itis charging and arcing inside the case, the gauges like rpm can malfunction.

Mar 29, 2012 | Toyota 4Runner Cars & Trucks

2 Answers

Ford Escape Hesitant to start, gauges going crazy?


open curcuit in crank sensor replace it.

Jul 24, 2009 | 2003 Ford Escape

1 Answer

I'm getting the engine light coming every so often. It seems that after I fill the tank and get down around 3/4 tank, The message I'm getting is "EVAP Emission Control System Purge Flow Fault". PO441 and...


I have a 2004 dodge stratus 2.4 dual overhead cam. When driving down the road, bell goes off, check engine light comes on, and it's like I'm driving on limp mode, when going over 2000 rpm's, there's a severe stutter. After getting code for light it points to cam shaft sensor, which i changed. I also changed crank shaft sensor. After all of this was done, drove great for about 30 miles and the same thing happened all over again. If anyone can point me in the right direction it would be greatly appreciated.

Jul 05, 2009 | 2004 Dodge Stratus

1 Answer

Rpm goes to 0, or goes dead


Your going to have to get the car scanned for a DTC code. Auto Zone can scan free of charge and a transmission shop can do it too, since i am leaning towards a DTC code P0715 which is a input turbine speed sensor circuit malfunction. Good luck and keep me posted, if it is the input speed sensor,it.s not a hard job to do and Auto Zone can give you the step by step instruction to replace it.

Jun 09, 2009 | 2000 Pontiac Grand Prix

Not finding what you are looking for?
2000 Dodge Stratus Logo

Related Topics:

176 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...