Question about 2010 Mercedes-Benz Sprinter

Open Question

What p20bd faultcode mean

Check engine light on

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine light and abs light on


Take it to a garage and have them read the OBD faultcodes for starters ... could be as simple as bad electronics/wires, but something more serious too ...

Jul 13, 2014 | 2003 Pontiac Montana

1 Answer

I pulled the fuse on my v w golf 1.6 now the air bag light is on


You probably pulled the air bag fuse as well ? Try replacing that fuse (with the correct type ofcourse) ... Could also try disconnecting the battery afterwards for like a minute (that will reset any faultcode). When the warning light still comes on, you still have a problem and I would suggesting reading the faultcodes using OBD.

Jun 29, 2014 | Volkswagen Golf Cars & Trucks

2 Answers

A.B.S LIGHT STAYS ON,& COMPUTER SHOWS FAULT CODE P1685,BUT I CAN`T DECIPHER THE CODE. CAN YOU HELP.


P1685 is:
P1685

Skim Invalid Key

The engine controller has received an invalid key from the SKIM.



You can get a full list of error codes from:

http://www.wjjeeps.com/faultcodes.htm

Jun 21, 2011 | 1997 Jeep Grand Cherokee

1 Answer

What does it mean when the MIL stays on when idleing and flashes when driving?


If the light is flashing, severe catalytic converter damage and power loss will soon occur.

http://www.wjjeeps.com/faultcodes.htm#MIL

Dec 11, 2010 | 2002 Jeep Grand Cherokee

3 Answers

My epc light went on in my 2002 volkswagen jetta


Take it to the dealer, the EPC warning light - and even more the failsafe run which doesn't allow you drive faster than 20mph) is an indication of serious motor troubles. They can read the ECU faultcodes, which should be a good startingpoint for troubleshooting the cause ...

You could do some basic troubleshooting like checking the air filter, the oil level, the spark plugs, etc. You didn't fill it up with bad gas, did you ? And does the engine make strange noises/vibration when running idle ? In case you fixed some obvious cause, you can dis- and reconnect the battery to erase the engine's faultcode. If it's not fixed, the EPC (and failsafe run) will simply come on again.

My advice would be not to drive it untill it's fixed to prevent more potential damage.

Aug 17, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

Check engine light on, Autozone says "glowplug code"


Take off the glow plug power bar and check each glow plug with an ohm meter. Infinite resistance means it's burnt out. Check the three glow plugs on the right side of the head with your ohm meter as well.
Just removing and reinstalling the bar will fix any bad connections which might also have triggered the errorcode, so when none of the plugs seem broken, that might have been the case.

I had the same faultcode on my 2005 TDI some years ago; it ran perfectly, but after checking under the hood 1 of the plugs was indeed broken.

Mar 22, 2009 | 2001 Volkswagen Jetta TDI

1 Answer

Indication lamp shining


That's the motor-management warning light. Meaning: serious errors are being detected by the motor-management computer (= ECU). You should have a dealer readout those ECU faultcodes using VAGCOM to determine the cause a.s.a.p, before (more) harm is done to the engine.

Please be aware that your motor could also switch to "failsafe" mode when too many severe errors are detected, meaning it's terribly slow to drive and turbo-pressure is nearly non-existing.

Mar 21, 2009 | Audi A4 Cars & Trucks

2 Answers

Engine check light


It means that it didn't receive a signal from the transmision module.
Have your transmission control module checked.

To reset your engine codes:
Remove the negative terminal of your battery (10mm wrench).
Turn your ignition key to START and hold it there for about 15 seconds.
Turn your ignition key to OFF and remove it.
Connect the negative terminal of your battery.

TCM (Trans control Module)
(electronic transmission control module)

Jan 09, 2009 | 2000 Dodge Dakota Quad Cab

1 Answer

Error Code 147203


http://www.wjjeeps.com/faultcodes.htm#1400

Here's a link to error codes, but the one you listed has too many digits.

Jul 12, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
2010 Mercedes-Benz Sprinter Logo

Related Topics:

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...