Question about 1994 GMC Yukon

Open Question

Battery went dead now astrostart won't start vehicle lights blink

Lights were left on in morning. It has an Astro Start but now it will not start. If you push button, the lights come on as it did just before it would start, but does not start. Then lights go off. Battery has a full charge and you can start it with key in the ignition with no problem.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 261 Answers

SOURCE: Key will not unlock door

the lock on the driver side could be damaged or some on might have used a jimmy to open that door before how evr you have to open the pannel and remove the lock cylinder part and make sure that the key is working or yo must change the tumbler s in the lock to fit your key (lock smith)

Posted on Nov 19, 2008

SOURCE: Idles rough upon start , goes dead when letting up on gas.

If the bat went dead and was disconnected it can take 25 to 50 miles of driving for computer to reset sensors and controls. Sounds like MAF Sensor maybe reading different than when it was first driven. Did you drastically change climates or altitudes, New readings from when it originally was put into service. Slight changes in temp, alt and other variables gradually reset, if driving does not improve within 50 miles it will need diagnostics.

Posted on Jan 06, 2009

  • 108 Answers

SOURCE: Battery dead due to interior lights left on. won't start w boost

u might have an aftermarket alarm 2 if u see a flashing red led light on dash look for black box under dash if u see fuses that are in that wiring of the black box pull them out and then try to start or look for a valet mode switch under dash turn on key and flick switch then try 2 start

Posted on Mar 26, 2009

  • 334 Answers

SOURCE: 2001 Jimmy - Dead, no lights, power, nothing

try putting it on a battry charger over night . when boosting the newer jimmy and car you need to make sure you have a very good constion . they will full you sometime and look at your fueses insde and out ok have a good day

Posted on Mar 29, 2009

ftw1952
  • 10319 Answers

SOURCE: ignition key would not move, can't start the car..

Turn the streeging wheel hard while turning the ignition key. This may help

Posted on May 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I charge my battery and shut off the alarm in my 1995 astro van?


Try turning key in door, the factory alarm will disarm when unlocked in door...that shouldn't affect the vehicle with starting if say try letting it sit on jumpers for a bit before trying to start ...make sure lights blower fan and stereos off will help a bit...(on both vehicles)...

Apr 29, 2014 | 1995 Chevrolet Astro

2 Answers

Astrostart won't start the car


You may need to reset the system.

SEQUENCE ACTIVATED BY THE PARKING BRAKE .
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply the parking brake Once Twice
Note: The system can be set - at time of installation - to require that the parking brake be applied once or twice.
If set for two actuations, pause one second between the two.
4. Remove key from ignition (the system keeps the engine running).
5. Exit the vehicle.
6. Within 60 seconds, close all doors.
7. The system will stop the engine and blink the parking brakes once to confirm the sequence is valid (vehicle is
ready for a remote start command).
SEQUENCE ACTIVATED BY THE REMOTE CONTROL
1. While engine is running (key in ignition switch), apply the brakes and hold the pedal down.
2. Move gearshift lever to neutral.
3. Apply parking brake.
4. Send the start command (Model 801 & 2101 - Model 903 ).
5. Remove key from ignition (the system keeps the engine running).
6. Exit the vehicle.
7. Using the remote, send the STOP command. The system will stop the engine and parking lights will blink once
to confirm that the sequence is valid (vehicle is ready for a remote start command).
http://www.astrostart.com/Support/Guides.aspx

Nov 27, 2012 | Cars & Trucks

1 Answer

08 sentra won't start, fast clicking noise and dash lights flashing


We have no way of guessing to answer the question

If the battery came with the car new in 07 or 08,I would
say the battery is worn out

All you need to do with any vehicle issue ,is test things

If you don't have the knowledge, you should have a repair shop
you have used for decades,not some franchise or chain store

Aug 02, 2012 | 2008 Nissan Sentra

1 Answer

Was fine started great then voltage hand went left abs light came on brake light came on dome lights came on head lights went off all panel lights went crazy blinking then jeep would not start without


Seems to be having problems with the alternator. Alternator itself can be bad, but also the voltage regulator, which sits inside the PCM (powertrain control module).
DonĀ“t continue using with battery voltage around the 10V, because it will ruin your battery as well. Completely charge the battery with an external battery charger and let the alternator be checked out first.

May 16, 2017 | 2002 Jeep Grand Cherokee

1 Answer

2000 bravada worked ok yesterday went out this morning and won't start. Lights. radio and heater fan run and tries to turn over then just clicks. Could it be starter or alternator


The indication for your symptom is a dead battery, loose battery cable of a faulty ground wire. n If the battery is dead it could be an indication of a charging issue or there is some parasitic load or light that was left on

Apr 15, 2011 | 2000 Oldsmobile Bravada

2 Answers

Battery goes dead, overnight


possibly a parasitic drain issue. Have you installed an after-market stereo in the vehicle recently? If so that could be the cause, if not. check things like the trunk light or hood light (if you have one) or anything not so obvious that might not be turning off.

Feb 26, 2010 | 2001 Toyota Tundra

2 Answers

Turned off my 2006 Escape & now it won't start.


battery failure ,it does happen,cleanbattery terminals pour boiling water over terminals if they are corroded loosen clamps by undoing nut wiggle clamps back and forthand and retighten if no lights then ,iwould suspect computor failure -------- youdoit.com

Jul 25, 2009 | 2005 Ford Escape

1 Answer

Dead battery or starter?


Take the battery out and have it charged up. reinstall it and you should be allright. Your car has discharged it completely, and it will need a recharge to start. The gauge is only measuring voltage, and not the status of charge.

Aug 06, 2008 | 1994 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1994 GMC Yukon Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...