Question about Jeep Grand Cherokee
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Code 54 - Mixture Control (MC) solenoid is shorted or the ECM is faulty.
Fuel Injected Engines:
Code 54 - Camshaft (or distributor sync.) reference circuit - No camshaft position sensor signal detected during engine rotation.
Hope this helps
Posted on Jul 14, 2008
12 is a battery disconnect within the last 50 start cycles and 55 means the end of the diagnostic cycle. Basically the computer found nothing wrong. The 12 code may seem incorrect if you haven't disconnected the battery recently, but from my experience the 12 code shows up almost all the time regardless.
Posted on Dec 16, 2008
P0700 means there is a transmission fault code in the transmission controller. Since the transmission controller doesn't have a light attached, it tells the engine controller to turn the light on using this code. You'll have to access the transmission controller to further diagnose the problem.
Posted on Jun 14, 2009
P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please
Posted on Oct 27, 2009
p0340 is the cam shaft sensor, this will cause it to cut off while driving, hardtime starting, p0351 is the ignition coil A primary/secondary curcuit mal function. p1391 is ignition system misfire, this could be plugs, wires, or coils. first of all have the cam sensor changed and it may correct the rest of the codes. when fixed turn light off with obd2 scanner. if you do not have one, then any auto parts store will erase the codes fo free of charge.
Posted on Jan 21, 2010
Tips for a great answer:
Apr 07, 2017 | Cars & Trucks
Oct 08, 2016 | 1996 Jeep Grand Cherokee
Oct 14, 2014 | 2003 Jeep Liberty
Mar 26, 2013 | 2003 Jeep Grand Cherokee
Mar 04, 2013 | 2002 Jeep Grand Cherokee
Feb 04, 2013 | 2000 Jeep Grand Cherokee
Aug 06, 2009 | 1993 Jeep Grand Cherokee
Jun 17, 2009 | 2000 Jeep Grand Cherokee
Jan 20, 2009 | 1998 Jeep Grand Cherokee
Oct 20, 2017 | Jeep Cars & Trucks
29 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: